Question about Triumph 400T Treadmill
Speed Sensor fault.
There is no signal returning to the Console from the lower board.
Check Speed Sensor connection on the lower board.
Check lower board to console connection, and wire for breaks.
Adjust Speed Sensor position.
Replace Speed Sensor.
Posted on Oct 19, 2014
Ok. So the first thing to try is to calibrate the speed.
You do this by doing the following:
If after a good calibration sequence, if it still does the stopping and E-1 after 10 seconds. ., then you need to (Power off and disconnect treadmill). . .then unplug the speed sensor from the lower power board, blow into the connector on the wire, and add a little contact cleaner spray to the connector on the board.
Recap: If it actually runs. . .but stops after a few seconds. . but the calibration runs and passes fine. .. .more than likely it is a speed sensor misread or a faulty speed sensor.
Posted on Oct 17, 2014
Tips for a great answer:
Nov 24, 2014 | Triumph Academy Sports 400T Treadmill
Sep 14, 2014 | Sole Fitness F63 Treadmill
Mar 15, 2011 | Matrix T3Xi Treadmill
Sep 18, 2010 | Exercise & Fitness
Aug 23, 2010 | Cardiozone Supersport Hr Club Commercial...
May 16, 2010 | Exercise & Fitness
Apr 20, 2009 | Exercise & Fitness
Nov 10, 2015 | Triumph 400T Treadmill
1,114 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: