Question about Helman Group HDR-565

Open Question

My Canopy top broke off. - Helman Group HDR-565

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Need new canopy top for model LP-70008


Fixya does not sell canopy tops.

Jun 06, 2016 | Garden

1 Answer

2003 harley fl fuel tank gasket top plate torque specifications


While pushing down on the canopy, align holes in canopy
with those in fuel tank. Hand start ten new T20
TORX screws in perimeter of canopy. Tighten screws to
18-24 in-lbs (2.0-2.7 Nm) using the pattern shown in the figure below.


04c39913-750b-47bf-a34c-945f68e8b908.jpg

Jul 13, 2014 | 2003 Harley Davidson FLHTCUI Electra Glide...

1 Answer

I have a Bugaboo frog. I accidentally broke the piece that attaches the canopy to the frame, on one side. What do I do now?


if it's within 2 years old it's covered.
Call toll free: image_gallery?uuid=6a479f2d-8718-40f4-b775-292deedb9bd4&groupid=10136&t=1318502576820 800.460.2922
Email : serviceus@bugaboo.com
Fax: 310.496.0988

Hours: Mon-Fri: 10am-7pm EST

http://www.bugaboo.com/all-products

Sep 06, 2012 | Bugaboo Frog - Blue Stroller

6 Answers

What is the difference between a canopy bed and a four poster bed?


A canopy bed is decorative and has 4 posts connecting with fabric hanging from them.7_18_2012_2_55_42_pm.jpg

May 30, 2012 | Furniture

1 Answer

How do you remove a canopy cover from a Hampton Bay fan?


Turn off the circuit breaker supplying power to the ceiling fan. The circuit breaker is in your home electrical box and may control more than just the ceiling fan. Place a stepladder under the Hampton Bay fan.


Remove the light bulbs and light covers from the fixture, if you have a light assembly on your ceiling fan. Remove the screws securing the light assembly housing to the fan with a Phillips screwdriver. Lower the light assembly, and hold it in one hand.


Twist counterclockwise the wire nuts securing the wires for the ceiling fan and light assembly, using your free hand to separate the wires. Lower the light assembly from the fan and set it in a safe place.


Turn the screws securing the fan blades to the unit with a Phillips screwdriver. Remove the blades from the fan and set them aside. Find the screws securing the canopy to the ceiling mounting plate. Loosen the screws two complete revolutions. Turn the canopy counterclockwise and unhook it from the screws. Slide the canopy over the fan motor housing and away from the fan.



Ask a helper to hold the fan motor housing if you have a Hampton Bay fan with a down rod. Slide the canopy over the down rod until it rests on top of the motor housing. Disconnect the fan wires from the ceiling wires, twisting the plastic wire caps counterclockwise. Slide the hangar ball, at the top of the down rod, out of the mounting bracket. Slide the canopy over the top of the down rod to remove it from the fan.


Regards

Sep 28, 2011 | Dryers

1 Answer

A round part where the front wire insert broke


No but you can buy a new fabric set for around $US150 in a whole range of colours.

Jun 01, 2010 | Bugaboo Frog Stroller

2 Answers

How do I remove the canopy from evenflo infant carrier?


use a tiny flat-head screw driver to pull outwards on the tab (this is a blue plastic tab on mine) that holds the white plastic u-shaped (canopy part) in. I didnt think it would be this difficult but it is... the graco ones are much easier to take off to wash.

Apr 18, 2009 | Evenflo Embrace

1 Answer

The sun shade on top


1. Infant restraint comes with four identical canopy support parts. Thread one canopy support completely through one sewn tunnel.
2. Slide straight end of a second support into the straight end of the first support.
3. On models with four canopy supports, repeat steps one and two for the other canopy tunnel.
4. Attach canopy in the areas between the infant restraint and the handle base.
To remove canopy, reverse the steps.

http://www.gracobaby.com/assets/pdfs/instructions/ISPC089BA_ISPC106AA.pdf

Hope this helps!! Thanks

Nov 16, 2007 | Graco SnugRide 8646 - Fiesta

1 Answer

Need a replacement canopy for baby stroller


Try new baby land put in on google make and model and put spares or replacement parts it will bring up newbady land click on this and it shows a stroller with the part numbers on it you can order on line .

Jul 07, 2017 | Inglesina Zippy AG4 Umbrella Stroller

Not finding what you are looking for?
Helman Group HDR-565 Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Helman Group Kitchen Appliances - Others Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

NOEL
NOEL

Level 3 Expert

8546 Answers

Tom Chichester

Level 3 Expert

55370 Answers

Are you a Helman Group Kitchen Appliances - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...