Question about Ultra Linear Car Audio & Video

Open Question

What is a ultra linear 10 inch ul10d 600 watt speaker worth

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 631 Answers

SOURCE: ultra linear ul-600hc

If the amp is in protect mode, it probably has shorted output transistors. To eliminate other possible problems, do the following. I'll assume that you've checked the amplifier's on-board fuses.

With your multimeter set to DC volts, the black meter lead on the ground terminal of the amp (not on the point where the ground wire connected to the vehicle) and the head unit on (so the amp will have remote voltage applied), touch the red lead alternately to the B+ and remote terminals of the amp. If the voltage is below ~11 volts, you need to check the wiring feeding whichever line is too low.

If the voltage remains near or above 12v, disconnect all speaker wires from the speaker terminals of the amp and disconnect signal cables from the amp. If it powers up, the wiring needs to be checked. If it still shuts down, the amp almost certainly has shorted output transistors and will need to be repaired.

Let me know if you have any other questions.

Posted on Aug 26, 2008

Ad

Anonymous

  • 3 Answers

SOURCE: power light on the amp goes on after 5 sec off ultra linear 1200

If you run the remote from the battery you will need a on/off switch. Sounds like the amp is overheating. Also, I don't understand bridge the remote and power. They should be seperate going into the amp.

Posted on Mar 01, 2009

Anonymous

  • 40 Answers

SOURCE: Modulation with my linear

the radio you are trying to fry your amp with is driving the amp to hard. that radio has a toshiba 80 watt final inside the radio you are killing your radio with the dead key at 2 watts it causes the final to overheat and shut down because it is not built to be turned down that much. its best to turn the radio back up and use the radio.

Posted on Mar 08, 2009

Boole5555

Chris Briggs

  • 160 Answers

SOURCE: i just got a 600 watt sony xplod amp with a 10

Could be overheating or a bad ground. Could also be a cracked tube or other internal part, that is expanding under heat and failing out.

Posted on Apr 07, 2010

juan valdez

  • 3 Answers

SOURCE: BP1200.1 Car Audio Amplifier: is that amp good for 2 12 inches subs kickers 600...

that will most definitely be the best amp you will own and the only amp you will ever need to purchase.

Posted on Jun 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just purchased the dual xinbp210 and don't know what size amp i need?


  • Enclosed subwoofer with dual 12-inch speakers; measures 27.5 x 14 x 15 inches
  • illumiNITE technology constantly illuminates the speakers with blue LED lights when in use
  • Handles 600 watts RMS power, 1100 watts peak power
  • Carpeted enclosure, plexi subwoofer viewing window
  • Dual 12-inch Low-Q optimized dri

Mar 26, 2015 | Cars & Trucks

1 Answer

What watt amp would i need to power 2 Kenwood KFC-WS253 10 inch subwoofer


get a nice 600 to 1000 watts Rockford and turn it down or upgrade speakers and turn it up it is usually better to have more than you need but control it

Aug 25, 2014 | Car Audio & Video

1 Answer

What amp for a Pioneer TS-W304C 10 inch


Wow, i just answered a similar question so, pretty much the same answer.......

You seem to be looking for an amp made for car audio. There are many brands, but I going to give you the specs for your particular speaker which will help in choosing, not a specific name brand amp, but at least one with the proper power outputs/requirements.

Your speaker, based on the model number you provided, is rated at 4 ohms .Nominal power handling range is 300 watts. And a peak of 600watts. That does not mean start cranking 600 watts thru the speaker, it will blow. I suggest you acquire a single (mono) channel amp that provides 350-400 watts at 4 ohms. Leaves you a little headroom on the amp, but use caution.

Hope these specs help you in choosing an amp.

Jan 05, 2013 | Pioneer TS-W304C Car Subwoofer

1 Answer

What watt amp would be best for my 1100 watt 10 inch xplod?


I have a 1100 watt sony xplode the silver one 4 ohm rms 3 00 with a 3000 watt 400 rms pyle amp? 8 ohm

Sep 16, 2011 | Sony Xplod 1100 Watt Max 10" Subwoofer,...

1 Answer

What type of amp do I need for apair of rfdj1 12" dj 600w band speakers?


The 600 watt rating is FAKE like most of our advertising and will be either 600 watts PEAK or 600 watts PROGRAM. If it is Peak, use an amplifier with no more than 100 watts a side RMS... If it is program rating use an amp with no more than 150 watts a side RMS but that is pushing it for speaker safety. Also pay attention to the spec of the amp as to what it will output at the impedance of the speakers. I read the spec on the speakers... they are rated 150 watts RMS, NOT 600 watts... Use an amp rated at 150 watts RMS MAXIMUM at 4 ohms per side. Also don't turn up the bass excessively or you be buying new speakers. Twelve inch speakers would be adequate for a 20 by 20 room at SAFE listening levels. If you want driving bass, you need to get an 18 inch subwoofer.

Jul 14, 2011 | Rockford Fosgate Rfdj1 12" 2-way Passive...

1 Answer

I have a Makita BMR100 radio. Stock speakers are 3.25" 8 ohm with an 8 watt 8 ohm amplifier. I replaced speakers with better 4" 4 ohm but they're not really compatible with an 8 ohm amp. I...


Buy an 8 ohm speaker and wire it in series-parallel look up images of of combination series-parallel wiring this allows wiring all speakers and keeping the 8 ohm loaf on the amplifier. Should get more linear volume between speakers. Not sure if replacement is worth it, those speakers are pretty good and work well with rain and jobsite conditions. I am planning to install some 8 ohm half inch tweeters on my Makita radio and using the series parallel wiring. Plead note series-parallel wiring is not series wiring or parallel wiring. It is s totally different way of wiring it that uses both names.

Jun 02, 2011 | Makita BMR100 Radio

1 Answer

Specs for orion 12" hcca


* Sensitivity: 84 dB
* RMS Power Range : 2000 Watts
* Peak Power Handling: 4000 Watts
* Impedance: 2 Ohm
* Diameter: 12 Inch

Features

* 4" Copper Wound Voice Coil on an Aluminum Former, High temperature PAARC (Polyester Amide, Amide Resin Coated)
* Continuous power handling will be 1500W (under rated)
* Burp power in excess of 5000W
* X-Max estimated at 30mm (total travel 4" peak to peak)
* Field Replaceable Cone / Voice coil / Spider Assembly
* Dual Flat Conex Spiders with Loop/Stitched Tinsel Leads
* Tall, wide, balanced, Foam (high density expanded polyester foam) surround for linear controlled long excursion using a Tri-Radius symmetrical edge design optimized on non-linear FEA
* Enhanced voice coil cooling system (forced convection ? aluminum heat sinking ? shorting rings to reduce inductive heating)
* Dimensions (in) 11.9 x 10.7

Jan 04, 2011 | Orion HCCA 12D Car Speaker

1 Answer

What kind of amp


It depends on the box you are installing them in. If you're going for sealed box they you can put 600-800 watts on them as long as you're careful with the gains and bass boost off. In a ported enclosure I wouldn't put more than 600 rms on them and still be careful with the gains. set your filter on your amp to about 80 hertz and match it on your source unit.

May 31, 2010 | Kicker CompVR 05CVR84 Car Subwoofer

1 Answer

Power light on the amp goes on after 5 sec off ultra linear 1200


If you run the remote from the battery you will need a on/off switch. Sounds like the amp is overheating. Also, I don't understand bridge the remote and power. They should be seperate going into the amp.

Dec 23, 2008 | Ultra Linear UL-2200D Car Audio Amplifier

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ultra Linear Car Audio & Video Experts

Professor_V
Professor_V

Level 2 Expert

93 Answers

FastHarley
FastHarley

Level 3 Expert

746 Answers

brian williams

Level 3 Expert

1720 Answers

Are you an Ultra Linear Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...