Question about Bowflex Treadclimber

Open Question

Lost key. all answers say any magnet will work but this has 3 gold pins in hole. is sensor missin? can i trick it by shorting pins? which ones?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I purchased a Gold's Gym Trainer 480 without a key. I used a bigger magnet and the screen blacked out and motor is squeeking. I purchased a key but still not working? Any suggestions?


I don't think its the magnet. Seem like something else may be going on. You may also have picked up some metal inside the console which then shorted something out inside.
purchased-golds-gym-trainer-480-without-uuxxv1o5nwvpx1g0ljlbpp00-2-0.jpg

Jan 21, 2016 | Exercise & Fitness

1 Answer

2003 s10 blazer cranks no start . when I was trying to test the crank sensor signal wire I found 10 volts present with ignition on not cranking. the ground wire has 12.5 with the key off and 12.21 volts...


Will a scan tool communicate with it or on the screen does it say NO COMM ! That's how you test a PCM/ECM . If no comm ,check power an ground's ,that's it .
Why were you messing with the crank sensor ? If the fuel pump primes for two seconds there is nothing wrong with it . When cranking the engine the PCM/ECM will only energize the fuel pump if it see's an input from the crank sensor ! You will not see 12 volts on the crank sensor signal return wire ! Crankshaft Position (CKP) Sensor
The CKP sensor is a three wire sensor based on the magneto resistive principle. A magneto resistive sensor uses two magnetic pickups between a permanent magnet. As an element such as a reluctor wheel passes the magnets the resulting change in the magnetic field is used by the sensor electronics to produce a digital output pulse. The PCM supplies a 12-volt, low reference, and signal circuit to the CKP sensor. The sensor returns a digital ON/OFF pulse 3 times per crankshaft revolution for the V6 engine, 4 times for the V8 engine. The CKP sensor reads the crankshaft mounted reluctor wheel to identify pairs of cylinders at top dead center (TDC).

May 20, 2017 | 2003 Chevrolet Blazer

2 Answers

How to bypass magnetic key on gold gym 450 treadmill


If you need to purchase a new safety key that was designed to work with your Gold's Gym machine, here is a link to one that is listed for seven models of the 450. But please make sure that your exact model is listed to ensure compatibility.
Safety key 6043675 Fitness and Exercise Equipment Repair Parts

Nov 04, 2012 | Golds Gym 450 Treadmill Drive Motor

1 Answer

Cadence cs200 treadmill model WLT 1901.5


Dear Sir:
Go inmediately and buy a small piece of magnet in any Hardware.

Since the key in any treadmill, is small magnet, and ready.

sincerely. God bless you

Apr 06, 2012 | Icon Image 17.5 S Treadmill

1 Answer

I have C280 Mercedes Benz. The car starts, but the engine dies after about 20 minutes.


Symptoms look like thermal instability of either the cam shaft position sensor or the crankshaft position sensor. Sometimes these sensors can fail by outputting reduced voltage with temperature increase so they appear to works fine at start up but fail when the engine reaches running temperature. I think the the cam sensor is Hall effect and the cam sensor magnetic:

2 pin socket (magnetic - sine wave output). One pin is 'ground' the other is 'signal'. A voltmeter set to 2 volts AC (note) should measure a signal in the 0.2 to 2 volts range on the 'signal' pin.

3 pin socket (Hall effect, magneto - square wave form output). One pin is 'reference' (5volts), one pin is 'ground' and the third pin is 'signal'. A DC (note) voltage should be detectable in the 0.5 to 1.5 volt range from the 'signal' pin.
It is important that the voltage measurement take place at start up when the engine is cold and again, 20 minutes later, when the engine has fully warmed up to operating temperature. These devices do not often fail and are expensive if purchased from the the Mercedes dealership, shop around on-line or try a breakers yard.

Dec 07, 2010 | Mercedes-Benz C-Class Cars & Trucks

2 Answers

What is sensor magnet in LG 6.5 kg washing machine? Recently I got a dE error and when technicians attended, they said, there was problem to closing door lid. To resolve this, technician replaced sensor...


The machine has a small magnet on the front of the lid. There is a sensor (Hall Effect probably) in the electronics block that senses if the magnet is there (lid closed) or not there (lid open). They aren't that well attached and seem to fall off and wind up in the wash, which means they get lost when the washing is being hung out.
The machine will not start without the lid closed you get a dE error code which means the lid is not shut. You can trick it temporarily by putting a small round magnet inside the front housing if you don't have a proper replacement, as the real one needs to be quite strong. Not sure what they cost, my husband just did the 'trick' to our daughters machine, but a small button magnet wasn't strong enough to trip the sensor from the lid position, he had to stick it right next to the sensor.
Shouldn't be that dear, you can buy blocks of very powerful neodymium magnets in varying sizes for under ten dollars.

Sep 09, 2010 | LG WFT1071TP Top Load Washer

10 Answers

I'm using LG Fuzzy logic 6.5kg WF-S6607TC. After the water reach the level, machine start to spin for a few seconds and then stop.I can hear the peeping alarm and both wash & spin indicators are...


Check the lid cover. At the edge, there is a plastic housing some sort of a magnet. This is the magnetic sensor for lid cover open protection.
If the magnet is not there, place a magnet at the position on the washer where the housing will come in contact with the washer when lid is close.

Feb 18, 2009 | LG WFT1071TP Top Load Washer

1 Answer

Swivel answer


There are two magnets behind the Screen which act as sensors.When you open or close your phone the magnets act as sensors.Check whether the magnets are there and in working condition or whether the magnets touch the keypad when closing or opening the phine

Oct 25, 2007 | Nokia 7373 Cellular Phone

Not finding what you are looking for?
Bowflex Treadclimber Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bowflex Exercise & Fitness Experts

Ekse

Level 3 Expert

13434 Answers

Bob Hawk

Level 1 Expert

2 Answers

ray gallant

Level 3 Expert

66490 Answers

Are you a Bowflex Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...