Question about Hobart Food Mixers

1 Answer

Kitchen Aid Hobart K45 T-77720-A tilt up,Can you help me? where can I can down load or purchase the manual owner for this model?

Posted by Anonymous on

  • 3 more comments 
  • Anonymous Sep 15, 2015

    Thank you Bill Boyd. Another question, last night I turn on the mixer and have vaint motor smell, is that normal? Can anybody help me? thank you

  • Bill Boyd Sep 15, 2015

    it may be some organic matter that is in the motor, cooking from the heat of the motor or it could be a failing motor
    electrical problems in a motor can still be smelt long after a motor has been switched off and has a very distinct smell
    best have it tested by an electrician with a meter that can check the integrity of the insulation of the wingdings. I think it is called a mega meter

  • Anonymous Sep 16, 2015

    Under the yellow cable it flash when the motor running, I am not sure it suppose to flash? start small blue flash and continue, I don't know how to explain the problems ;(

  • Bill Boyd Sep 16, 2015

    from your description , it appears to have a commutator on the armature ( just like an electric drill in which case it will have blue sparks when it is running as the power arcs as the segments of the commutator bars pass under the brushes
    This arcing is normal but it should be very short and just visible
    If is large and appears as an aggressive spark then that indicates several problems that need attention from an electrician
    It could be that the motor needs new brushes
    needs the commutator bars to be machined smooth again
    needs the armature to be replaced
    needs to have the field windings checked for failing insulation
    allowing the motor to operate in this condition builds up a heat from the arcing that will produce a smell and will eventually burn out the motor

  • Anonymous Sep 18, 2015

    Thank you Bill

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Hobart Master
  • 53,757 Answers

Go google and type in--hobart food mixer manufacturer and there are pages of hobartfood.com.au and hobartcorp.com/products/food-prep/mixers /
all of these pages will have a contact us section where there will be phone numbers and e-mail addresses
contact them direct in a area /country near you and see what is available

Posted on Sep 14, 2015

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Hobart kitchen aid mixer and I need a Manuel for it.


Hello, Fran -

The Whirlpool Corporation purchased the Hobart Kitchen Aid manufacturing unit in 1985.

I suggest you contact the Whirlpool Corp. directly and ask about the availability of a copy of a user manual for your model of Hobart mixers. Whirlpool probably took over the Hobart Kitchen Aid archival records. With luck the manual you need is still in the company archives.

This is the link to the Whirlpool Corp. Contact Us page:
https://www.whirlpool.com/services/contact-us.html

Best wishes.

Mar 29, 2018 | Hobart Food Mixers

2 Answers

Trying to find the age of a Hobart Mixer serial number 1569386


Contact hobart directly, they tend to keep a record of machines, and would probably be able to as sit you

Feb 15, 2018 | Hobart Food Mixers

1 Answer

Kitchenaid stand mixer KSM8990DP repair manual


Google kitchen aid with make a model you should be able to down load a Manual .

Jan 09, 2018 | KitchenAid Food Mixers

1 Answer

A200, 1st gear had no torque(I could stop by hand). Found & replaced key on low speed gear. It sheared it again. It is just shearing it on the flat gear part, not the bevel gear part. I'm thinking it...


I have had my Kitchen Aid since 2003 and never had this problem. If this has happened to you more than once, I would call Kitchen Aid and explain the issue to them. My sister had an Issue with her new Kitchen Aid and they had her bring it for service and they replaced it with a NEW mixer. Kitchen Aid is very good with brand accountability.

Mar 01, 2014 | Hobart Food Mixers

3 Answers

Kitchenaid K45 Mixer will only run at one speed, fast


is it a K45 or a K45SS? If it is a K45 you will have to replace the filters inside and probably the speed control plate, if it is a K45SS then you need a new phase control board. The K45 is pre 1978 and the K45SS is post 1978. Your information is correct on pre 1978 K45 models that the capacitor is bad, but it might be cheaper to go garage sale hunting and find a second machine as the parts are no longer made and having spares on hand may be a significant advantage in the future, also there are a great many of the K45SS parts that will also repair the K45 mixer so it may not be a practical solution. Watch ebay regularly for K45 parts, they come up every couple of months. On the parts diagram also look for the K5 diagram as it is identical to the K45, one is a 5 quart mixer and the other one is 4.5 quart, same parts same motor same everything.

Jan 30, 2013 | KitchenAid Food Mixers

3 Answers

Which is the better mixer of these old models: K5A K5-A or K45 SS and what is the difference? KITCHENAID HOBART K5A K5-A 300 WATT MIXER and the KitchenAid Hobart Vintage K45 250 WATT. Thank you


Hello ajlina,

All of these are great home use units, all the attachments are interchangeable between these. The difference between these mixers is the K5 is a 5 quart mixer and the K45 is a 4.5 quart mixer. As I own both of them they are great in the kitchen and have the same durability.

Have any more questions please post to this thread and I will be happy to assist. Thank you for using FixYa.

Dec 09, 2010 | KitchenAid K45SS Classic Stand Mixer

1 Answer

Mine is a K5-A Hobart Kitchen Aid mixer and the back bowl pin broke off so I can't click the bowl in place any more. Please help!


sounds like you need a new bowl lift cam, on the n-50 which is a hobart table-top model pull top off pedestle, you will see the cam you have to remove one cotter pin and remove one split pin install new cam reassemble

Dec 31, 2009 | KitchenAid K5SS Heavy Duty Commercial...

2 Answers

Kitchen aid 300 watt counter mixer model ksm90


no there is no adjustment . worn hinge on the base , no parts made , not that i have ever seen ...... sorry i wish i had better news

Jan 05, 2009 | Hobart A200 Stand Mixer

Not finding what you are looking for?
Food Mixers Logo

Related Topics:

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hobart Food Mixers Experts

Ross Keen

Level 3 Expert

1363 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Bruce Showalter

Level 2 Expert

133 Answers

Are you a Hobart Food Mixer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...