Question about Uniden Cordless Phone

1 Answer

The light atop my handset flashes continously. Why? how can i Stop it?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Uniden Master
  • 64,773 Answers

Mine does that when I have a voicemail only .and it continues untill i listen to and delete the voicemail .

Posted on Nov 11, 2015

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes a red light on an TB Wood Etrac XFC 1001 inverter and the motor will not start Is there an internal fuse Do I need 3 phase for the input


Is that red light flashing or continous lighting? You do not need 3 phase input for that model. Do you have the input wiring diagram? If the red light is flashing maybe the emergency stop input is active. If the red light is on continously then it maybe in stop mode or torque limit, ask electrician to check the wiring.

Dec 31, 2016 | Inverter Electronics - Others

1 Answer

Red light on my handset is continously flashing. It is a 6.0 dest single handset


You have unheard messages on the voicemail system provided by your telephone company. This system takes messages when someone calls while you're already on the phone. Please contact your telephone company for instructions on accessing their voicemail system.

Dec 27, 2010 | Uniden Cordless Phone

1 Answer

Dash board of my 2000 crysler voyager keep flashing, and the out side lights do de same thing.


the hazard switch is the problem or it is cause by passive alarm, remove the hazard switch or hazard fuse and observe the function of the lights, if lights stop flashing, change the switch, if continous flashing check the keyless entry reciever or the body control module

Aug 06, 2010 | 2001 Chrysler Town & Country

1 Answer

Battery fully charged but warning light


has your battery being replaced new one might not have sensor if so you can fit a 50 k resistor between the positive terminal and sensor wire located next to the battery this will stop light flashing

May 25, 2010 | 1992 kawasaki GT 750

1 Answer

Controller (control panel) is flashing continously


see if flashing fl1 and flashing if so shorted temp sensor

Feb 04, 2018 | Jandy Lite2 LJ125 Ceramic Gas Heater

1 Answer

The flashing light on phone


Press down the "find handset" button until the paging beep stops (about 5 seconds) and this will reset the indicator lights on the handsets.

Dec 11, 2008 | Uniden 5.8GHz Cordless Phone

2 Answers

GE Cordless DECT 6.0 - Model 28111EEZ-A


Mine says on all handsets "New Voice Mail" but I can't not find out how to listen to it or delete it so the handsets will stop flashing and the message light on the base will also stop flashing. The instructions say you get this from your service provider but does not tell you how to do it or how to delete it.
Help

Jul 07, 2008 | Uniden Cordless Phone

5 Answers

New Voice Mail flashing light


press "mute" key to access menu, press the up or down arrow key labeled "caller ID- volume" until you get to "handset setup", press the "mute" key again, press the down or up arrow until you have "defaultsetting" selected, press "mute" key, press "1", then press "mute" once more. At this point your handset will reset clearing the indicator for all the handsets. I've had to do this twice on my phones and it worked every time.

May 10, 2008 | Uniden Cordless Phone

1 Answer

Message Light flashing continously


Resetting the New Message LED
If the LED remains on after you’ve retrieved your messages, you may need to reset
the indicators. With the phone is in standby mode, press and hold find handset on
the base until the paging sound stops (about 5 seconds).

Dec 12, 2006 | Uniden TRU8865-2 Expandable System...

Not finding what you are looking for?
Uniden Cordless Phone Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Uniden Lands Phones Experts

k24674

Level 3 Expert

8081 Answers

Cindy Wells

Level 3 Expert

6046 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you an Uniden Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...