Question about Minn Kota Endura 30 Freshwater Transom Mount Trolling Motor

Open Question

I.e. The black wire the Hot wire on a min Kota 30 ?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hot plug connector


if everthing else is hooked up properly and the battery connections are tight i would suspect a loose connection in either the plug or the receptacle. anytime an electrical connection heats up it usually means there is a loose connection or too many amps running through it than what its designed for. remember trolling motors should not be run out of the water for more than 30 seconds as they use the water to cool the output shaft at the prop. good trolling.

May 30, 2010 | Minn Kota Maxxum 55 Freshwater Bow Mount...

1 Answer

I lost my Leviton 6230M 30 mins timer installation sheet.


Switch has 2 black wires. One black is hot wire. One black is wire going to fan. Turn off power. Remove wires from switch and separate. Turn power back on. Using ordinary tester, test each black wire to bare copper ground wire. Only one of the black wires will test hot. The other black wire goes to fan.
Timer black wire connects to black hot
Timer blue wire connects to black wire going to fan
Timer white wire connects to white neutral (in absence of white neutral, connect Timer white wire to bare ground)
Timer green connects to bare ground wire

May 24, 2010 | Leviton 1000W / 20A 1HP-120V - 6230M-I -...

1 Answer

Why does the switch keep burning out?


call the 800 number on the motor for min kota they are great about ansering these questions. the first thought for me is that things are heating up due to too much amperage being drawn by the motor or a loose connection.you will needs to check the specs on that motor to tell and need to know what normal readings are which minkota will gladly supply you.

May 17, 2010 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

Burning out fuses on trolling motor at battery


not enough info. I went the the min kota website, they show four maxxum 80's at different voltages.is it a 12v 24v or larger? without a year model I'll have no reference to what wiring schematic Is the fuse connected inline with the trolling motor? what size amp fuse are you burning up? well I can give you some troubleshooting tips. tools to buy (1) amp gauge. if you are unfamilier with amp gauges make sure you get instruction book with gauge or you could burn yourself. Toubleshooting(1) Remove cover off minn kota trolling motor. black cover ontop of unit were the foot control wires go into.turn over foot control remove cover (2) check for corrosion. any exposed terminals should be cleaned.(3) go to your batteries and clean all connections. make sure the batteries are fully charged.(4) take amp gauge and test positive wire for amp draw as you tun on trollling motor and run it through all speeds. if batteries are in the rear away from trolling motor get a 2nd person to control trolling motor. if the trolling motor is more than a 12v system you will have more than one positive lead to test.GOAL. What your trying to find out is how many amps the trolling motor is really pulling. and at what speeds. under a load in the water and out of the water.how many more amps than the fuse raiting? newer trolling motors come with inline breakers not fuses so I'm guessing your using 30 amp fuses. again without more info i can only guess.

Oct 29, 2009 | Minn Kota Maxxum 70 Freshwater Bow Mount...

1 Answer

I need Minn Kota Power Drive operators Manual


I'm installing a Minn Kota Power Drive 70# on my Crestliner Fishhawk. I understand the 24 volt system. however the boat has 2 black, an orange and a red wire running to the batteries. I know black to neg. but where do the orange and red wires go.

Jun 09, 2009 | Minn Kota Maxxum 55 Freshwater Bow Mount...

1 Answer

Overheated Minn Kota Endura28


This sounds like a fairly big deal. You need to check it water got into the motor. Turn it upside down and see if water comes out of the handle end of the motor. This may be a shop deal.

May 31, 2009 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

Wiring diagram for a minn kota mk220 2 bank charger


First. the +/positive/hot wires go to the respective/separate +positive/hot side battery terminals.. and the -/negative/ground wire go to their respective/separate -/negative/ground battery terminals.
The wires from the charger are "paired out".. meaning the + and - pair must go to the same battery. .. you can't mix and match.

Feb 27, 2009 | Johnson Minn Kota Mk 25 & Mk 35 On Board...

1 Answer

Minn Kota Trolling Motor will not run


Hi!
For starters, here is a schematic:
Endura 30
Check to see if there is appropriate voltage getting to the switch (with an ohm meter).
You can (please do this carefully) disconnect the battery positive and negative as well as the motor red and motor black wires and connect the Batt positive to the motor red and the Batt negative to the motor black. If the motor runs, the switch is faulty. If it doesn't then I suspect the motor needs looking at.
Best of luck!
Mike

Feb 06, 2009 | Minn Kota Endura 30 Freshwater Transom...

2 Answers

Minn kota turbo 35 27lb thrush trolling motor


I have a minn kota turbo 35 27lb thrush trolling motor after 3 hours of running it the motor dies

Mar 01, 2008 | Minn Kota GPS

Not finding what you are looking for?
Minn Kota Endura 30 Freshwater Transom Mount Trolling Motor Logo

Related Topics:

290 people viewed this question

Ask a Question

Usually answered in minutes!

Top Minn Kota Boating Experts

Gene Pitts

Level 2 Expert

159 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

29431 Answers

Are you a Minn Kota Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...