Question about Ultra Health & Beauty
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Please make sure your charger is okay, can you try another charger ?
the other thing is , the FREEWHEEL lever can it move itself say when you go down a kerb , what are they replacing ? do you have the part ? send me a photograph if you do ?
Posted on Jun 13, 2009
the lever at the back may be slack and missing the turn-point. Try moving up and down a few times, very gently, this may get the correct position,.
Posted on Sep 14, 2009
Check the connections between the battery and motor, if the rear come apart check there connections there,
If the connection with the batteries string loaded, rough them up slighty with a wire brush but be gentle and is there freewheel lever right in position for drive.
Posted on Oct 25, 2009
Do not use batteries with different amp-hour (Ah) capacities. Do not mix old and new batteries. Always replace both batteries at the same time.
MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! Always use two batteries of the exact same type, chemistry, and amp-hour (Ah) capacity. Use 12 Volt deep cycle batteries.
1.Remove the battery pack from the Travel Scooter.
2.Carefully turn the pack upside down.
3.Remove the eight (8) screws from the perimeter of the battery pack.
4.Carefully turn the pack right side up and remove the lid.
5.Disconnect the black (-) and red (+) battery cables from the battery terminals.
6.Remove the old battery.
7.Place a new battery in the battery pack.
8.Connect the red battery cable to the positive (+) battery terminal.
9.Connect the black battery cable to the negative (-) battery terminal.
10.Position the lid back onto the battery pack ensuring all wires are inside the pack so they don’t become pinched.
11.Carefully turn the pack upside down.
12.Reinstall all screws and tighten.
13.Charge the new batteries for 8-14 hrs before the first use.
I hope this helps and good luck!
Posted on Feb 24, 2010
Hi. If the knocking noise happens with each revolution of the wheel, it is probably the square key in the axle that drives the wheel. Remoce the wheel and wipe a light smear of grease on the axle and key where it fits inside the wheel. As the wheel normally rotates, the weight comes on to the key and off again, causing the noise. The grease allows it to move without making the noise. Sometimes also caused by a stone in the tread, but most likely to be a dry key.Good luck. Neil.
Posted on May 27, 2010
Tips for a great answer:
Sep 01, 2016 | Pride Mobility Products GoGo Elite...
Nov 17, 2014 | Pride Mobility Products GoGo Elite...
Mar 01, 2014 | Pride Mobility Products GoGo Ultra X...
Mar 26, 2011 | Pride Mobility Products GoGo Ultra X...
Sep 19, 2010 | Activeforever Pride GoGo Ultra 4 Wheel...
Apr 06, 2010 | Pride Mobility Products Go Go Ultra X 3...
Oct 24, 2009 | Pride Mobility Products Go Go Ultra X 4...
Sep 13, 2009 | Pride Go-Go Ultra X 3-Wheel Travel Scooter
Jun 10, 2009 | Pride Mobility Products Go-Go Elite...
32 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: