Question about Stanley Measuring Tools & Sensors
Most stud finders have a sensitivity adjustment that should be carefully adjusted per instruction manual before use.
Failure to do this results in erroneous indications.
If you have adjusted exactly per the instructions with the same result the unit is probably faulty.
Posted on Sep 22, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Posted on Jun 05, 2010
SOURCE: I have a Stanley stud
The 77-110 does not detect electrical wiring. The model 77-720 model does detect electrical wiring but not the 77-110. You must first place the stud finder against the wall, press the button and wait for the light and audio signal to stop. Once this happens the unit is calibrated and while still holding the button down, you then move it across the wall to find the studs. Problem is that this unit is very unreliable and does not work as advertised most of the time. It has a lifetime warranty so my advice is to take it back and get a refund if possible. I have tried many stud finders an most are not reliable and cannot be depended on 100% of the time and this Stanley is one of the worst. The best inexpensive stud finder I have found is the Gardner Bender stud seeker at around $12.
Posted on Sep 20, 2010
SOURCE: I have plaster walls in
Your stud finder keeps beeping because old plaster walls have lath boards behind the plaster that are attached to the studs and running horizontally. Try adjusting the sensitivity of the stud finder by placing it on the wall and turning the sensitivity down until it just stops beeping. Then move it back and forth in a wide enough arc to be sure that you have crossed a stud, turning up the sensitivity ever so slightly until you get a tone when you cross a stud. Hope this works out for you.
Posted on May 08, 2011
SOURCE: my stanley stud sensor 200
Without knowing what room you are using it in it could be a underlayment of wire mesh that you are reading. If it is an older home this was used often as a backing for plaster instead of lath.Thank you.
Posted on Jun 06, 2011
Tips for a great answer:
Sep 24, 2017 | Measuring Tools & Sensors
Aug 26, 2014 | Stanley 77 500 Intellilaser Pro Stud...
Aug 04, 2014 | Stanley 77-720 Stud Sensor 200
Mar 05, 2012 | Stanley Measuring Tools & Sensors
Jul 31, 2011 | Stanley 77 115 Intellisensor Plus Stud...
May 08, 2011 | Stanley Garden
Jan 19, 2011 | Stanley 77-720 Stud Sensor 200
Oct 17, 2010 | Stanley Intellisensor 77110
Jul 24, 2010 | Stanley Proto Stanley Magnetic Stud Finder
Jun 04, 2010 | Stanley 77 115 Intellisensor Plus Stud...
4,875 people viewed this question
Usually answered in minutes!