Question about Daiwa Goldcast Gc120 S/C Reel 1Bb, 4.1:1 12Lb/100Yd

1 Answer

Advice on how to unjam Daiwa 7850 rl reel.

The crank would not turn. I opened the reel and tried to spray it with wd40, and could only get minimal movement. Is there something that needs to be loosened that I do not see?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 40 Answers

You don't say how long it's been since it didn't work. Guessing that this is a reel that you just picked up. Try breaking it down completely. Take the spool off. Take the side plate off. Don't force the handle. You could end up damaging it beyond repair. Check the shaft. Turn the spinning/bail mechanism. Watch to see if the shaft and gear drive turns. Check the shaft of the handle. All are points of corrosion. While you're at it if you get it unstuck then, I'd suggest changing out the drag too. Clean and grease all areas.

Posted on Jul 20, 2018

Ad

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

tees01

  • 1 Answer

SOURCE: How can I loosen the lever for the gas tank to

I have a 2007 Hyudai Santa Fe and had the same problem this morning. I wasn't sure what to do and couldn't find any solutions mentioning this, so I thought I would.

My tank wasn't frozen or anything and the cable tension seemed fine. If you go to the trunk there should be an access panel on the left side wall behind the tank (has a picture of a fuel pump on it), open this up and you will see an emergency fuel tank pull cord which will open the tank. Once I opened mine, I found that the little cord that holds the gas cap on was jammed in the door hinge. I tested it a few times with the "normal" release on the driver side door and it works fine now.

Posted on May 12, 2010

montehammons

  • 5527 Answers

SOURCE: Starter. Hyundai santa fe v6 2wd 2002. Took out

Check for another mounting bolt Some engines have a bolt from the backside into the starter-some Toyotas and Hondas do. And sometimes a mounting bolt is towards the inside of the starter, possibly hidden from sight by the starter solenoid.

Posted on May 24, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need the schematics for this reel please.Daiwa sealine LD 50


this schematic is not even on the Daiwa website
Saltwater Overhead Reel Schematics
but I suggest you as instructed and contact Daiwa for this

May 21, 2016 | Fishing

1 Answer

Where can I get an assembly diagram?


  1. Popular Daiwa Goldcast Spincast Reel Medium Heavy ...

    www.fixya.com > Forum > Fishing Rods & Reels > Daiwa
    Popular Daiwa Goldcast Spincast Reel Medium Heavy Action, GC120 questions, common issues & problems. Find solutions, answers, DIY tips, repair advice ...

Jul 20, 2015 | Daiwa Goldcast Spincast Reel Medium Heavy...

1 Answer

HOW DO I UNJAM SB 99C SHEDDER


Try spraying some WD40 into the cutting blades then turn it on to forward it may unjam itself.

Aug 25, 2014 | Fellowes SB-99Ci Shredder

2 Answers

Where can i buy a handle for a daiwa ar2600 fishing reel? Or can another model reel handle fit?


Hello there and welcome to fixya
Here is a link to the diawa corp main page they have the parts that you l need and some phone numbers

Service Request Form
Download, print and fill-out this form. Include it with your reel when requesting warranty or non-warranty service. Parts Diagrams
Click here to find schematics of all Daiwa reels, current and discontinued. US Authorized Warranty
Centers

Factory Warranty Service & Parts
Daiwa Corporation
11137 Warland Drive
Cypress, CA, 90630 Exclusive Dendoh Power Assist Reels
Warranty Service & Parts

Reel and Rod Services, Inc.
14645 SW 42nd St.
Miami, FL 33175
(305) 223-0811
http://fishingreelservices.com spacer.gif
Canadian Authorized Warranty Centers
Click here Frequently Asked Questions

Jan 02, 2012 | Sport & Outdoor - Others

1 Answer

I'm trying to take apart this reel in order to clean and oil it. However I'm not able to remove the handles or the spool. Ideas?


Unless you know exacly what you are doing don't bother. It is a very complicated reel and expremely easy to put back together incorrecly. Send it off to Daiwa Sports service department. It'll either cost you £5 or nothing to have it serviced.
Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} T: 08450 603603
E: info@daiwasports.co.uk


Apr 19, 2009 | Watches

Not finding what you are looking for?
Daiwa Goldcast Gc120 S/C Reel 1Bb, 4.1:1 12Lb/100Yd Logo

Related Topics:

660 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daiwa Fishing Experts

ray gallant
ray gallant

Level 3 Expert

64773 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

29424 Answers

Steve P
Steve P

Level 3 Expert

3577 Answers

Are you a Daiwa Fishing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...