Question about Kenmore Dryers

1 Answer

My Kenmore elite turbo dry Super Capacity quiet Pak 2 oasis is making a bad squealing sound. What could be thereason

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 775 Answers

The wheels that the drum rolls on are in need of replacement. They get worn after a while. Try SEARS PARTS DIRECT COM. You will find what you seek. Good Luck Friend.

Posted on Jun 25, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Lumpy816

Toby Norton

  • 246 Answers

SOURCE: My Kenmore Elite has an

F51 error code is beacause the computer board did not receive input from the motor on the bottom. Unplug the washer, pull the machine forward and tilt the machine back. On the bottom you will see a large white wheel with a silver allen screw in the middle I think it is a 6mm allen wrech that takes it off. Once you remove the screw and drop the white wheel, there will be a large coil of wires with 4 5/16 screws holding it on, remove these screws and drop the coils. On the right hand side you will see a connector with three wires , unplug it. Use sand paper or a scraping tool to clean all 3 male sides of the connectors. Reverse process to re-assemble.

Posted on Jul 11, 2008

Anonymous

  • 1 Answer

SOURCE: 22942 Top Load Washer: Our Kenmore Elite w/ Quiet Pak II Super Capacity t...

my kenmore washer elite11 leaks water in the rinse cycle on the floor.

Posted on Jun 19, 2010

blueextc3221

blueextc3221

  • 15935 Answers

SOURCE: kenmore elite he4 quiet pak 9 dryer display code

PF - Power Failure - PF error code indicates a power failure during the dryer's cycle. Press and HOLD start to continue the cycle, or press off/pause to clear display.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Posted on Sep 30, 2010

jerry earick

  • 96 Answers

SOURCE: kenmore elite oasis dryer quiet

Either your glide pads that the front of the drum rides on are worn out, or the rear drum bearing are worn out

Posted on Mar 24, 2011

heatman101

D. Floyd Kolb

  • 43501 Answers

SOURCE: my kenmore elite turbo super

Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check outthis electric no heat tip...

heatman101][]

-
=-=-

Posted on Sep 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Motor on kenmore elite washer quiet pak ii heavy duty capacity king size wont engage, just hums. and ideas?


Sounds like you motor coupling is gone this happens when over fill washer or place carpets/ bed blankets

Feb 15, 2015 | Kenmore Washing Machines

1 Answer

What is wrong with my Kenmore Elite Quiet Pak 4 HE3 Electric Dryer?


Might be a2 things: Vent blockage causing overheat OR bad thermistor. Repair clinic shows how to replace it:

PART AND VIDEO

Note: Make sure you order the correct thermistor for your dryer

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Dec 05, 2012 | Dryers

1 Answer

Can wash my clothes washer is giving a f1 announcement and stops.is a kenmore elite oasis model 110.27032602 quiet pak 2.thanks


Hello,

The F1 error code means that the control board has a detected a problem within the control itself and the control board would need to be replaced.

The part number for that control board is W10189966 it could be picked up at your local appliance parts store or online at;
searspartsdirect.com
apwagner.com
partselect.com
apdepot.com
repairclinic.com


GENE

Oct 12, 2011 | Kenmore Oasis HE 27082 Top Load Washer

1 Answer

My kenmore elite turbo super capacity drier will not dry.


Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check outthis electric no heat tip...

heatman101][]

-
=-=-

Sep 11, 2011 | Kenmore Elite HE4 Electric Dryer

1 Answer

Kenmore elite oasis dryer quiet pak 2 making loud screeching noises-


Either your glide pads that the front of the drum rides on are worn out, or the rear drum bearing are worn out

Mar 24, 2011 | Kenmore Dryers

1 Answer

I have a Kenmore Elite Heavy Duty King Size Capacity quiet pak 1 that is not heating up what could the problem be?


I have a Kenmore Elite Heavy Duty King Size Capacity quiet pak 1 that is not heating up what could the problem be?

Jan 13, 2011 | Kenmore Dryers

1 Answer

22942 Top Load Washer: Our Kenmore Elite w/ Quiet Pak II Super Capacity t...


my kenmore washer elite11 leaks water in the rinse cycle on the floor.

May 17, 2010 | Kenmore 22942 Top Load Washer

1 Answer

I have a Kenmore Heavy Duty, super capacity, quiet


It sounds like your heating element has broken. There are several links provided on this site on how to replace it. You might want to take a look at davesrepair.com to purchase a new one. He has pretty good prices on the element.

Mar 17, 2009 | Kenmore Dryers

1 Answer

My 18 month old kenmore elite oasis quiet pak 2 gas dryer smells as if there were a fire in it!!!!  and ironically, when i noticed the smell i also saw water around the base of the kenmore elite oasis top...


Hello plz make sure the gas burner does not have any lint build up on burner assembly inside the machine / plz clean.That usually causes a burnt smell. If there is no error codes on the display and the machines is operating fine you are chasing a ghost. If there is a pump or motor over load an error code should come up on the display.

Dec 11, 2008 | Kenmore Elite HE4 Electric Dryer

Not finding what you are looking for?
Dryers Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Dryers Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Ned Halaweh
Ned Halaweh

Level 2 Expert

240 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a Kenmore Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...