Question about Kenmore Dryers

1 Answer

There are only 3 wires going to the thermostat on my Kenmore Series 70 dryer but 4 connectors.

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kenmore Master
  • 4,328 Answers

Yes that is correct. electrical requires 4 wires 2 are power 1 is neutral and other is ground



https://www.thespruce.com/change-dryer-cord-3-prong-to-4-1152248


How to install Electric Dryer Cord 3 or 4 prong Ground Wire explained

Posted on Jun 24, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1122 Answers

SOURCE: kenmore dryer series 70 won't turn on

most of the time it is the door switch that goes bad,also you can check the main fuse inside the dryer on the blower box,and always make sure your dryer vent and wall vent are clear to vent,let me know what you find-mike

Posted on Oct 29, 2008

Anonymous

  • 117 Answers

SOURCE: My Kenmore dryer 70 series

You can go to this website and put in your model # to see if your wiring schematic comes up. http://www.servicematters.com/docs/wiring/wiring_main.htm

http://tclaundryrepair.com/home

Posted on Feb 19, 2009

jsrock516

Jeff Rockwell

  • 5911 Answers

SOURCE: Kenmore series electric dryer need to replace 3 prong w/4 prong

The following link explains how to convert a 3-prong appliance cord to a 4-prong and vice-versa:

http://www.fixya.com/support/r793520-3_prong_4_prong_power_cord_conversion

If you still have questions, please let me know. I hope this helps you.

Posted on Feb 27, 2009

James Chandler

  • 686 Answers

SOURCE: Kenmore 70 Series Dryer Model# 110.64742400

check the thermal fuse if it is blown also change the high limit thermal cut-off fuse www.repairclinic.com shows your parts. go there and enter model number. Also check the heat element. to get into it remove the lint filter and the two screws you'll see there then pry the top up at the front corners. And through the back you should find the heat element and blower housing and thermal fuse and high limit fuse and cycling thermostat.

Posted on Apr 06, 2009

Anonymous

  • 1122 Answers

SOURCE: kenmore series 70 electric dryer will not heat up, but will rotate.

remove the back cover and check the heater box fuse and the heating element,do you have a meter?

Posted on May 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenmore 70 Dryer won't heat


Hi Jason
There is no fuse to replace only thermostats/thermistors...and heating element.
Here is some things to check:

Apr 25, 2013 | Dryers

1 Answer

I have a Kenmore Series 70 Dryer and I changed the thermal fuse got hot for a few minutes the model #110.74722400


The cycling thermostat must also be replaced when replacing the thermal fuse. The cycling thermostat's failure to cycle off the heating element results in overheating of the dryer which consequently blows the thermal fuse open.

jahn27_559.jpg


Replacing only the thermal fuse should the dryer stops running and fails to start will result in its premature blowing or even the thermal cut-out (cut-off) located on the heater duct. Like the cycling thermostat, the high-limit thermostat must also be replaced once the thermal cut-out blows open. Refer to the parts diagram in the link below and look for item numbers 31(thermal cut-off), 34(hi-limit thermostat), 39(thermal fuse), and 41(cycling thermostat.

Kenmore Series 70 Electric Dryer (110.74722400) Bulkhead Parts

Aug 21, 2011 | Dryers

1 Answer

I have a kenmore 70 series gas dryer. It won't


Check the thermal fuse and thermostats first, then the ignitor and the valve coils are the next possibilities.
Eric

Jan 24, 2010 | Kenmore 63942 Dryer

1 Answer

Have a kenmore series 70 dryer. Won't shut off


Yes it deffinetley sounds like you may have a timer issue, if your timer stops and the dryer is running, or if the timer keeps going around and around this will be the problem, however there are thermostats inside the dryer and if you have it set on a HEAT and not a TIMED setting the thermostats won't advance the timer because they havent been set.Hope this helps

Thanks.

Nov 22, 2009 | Kenmore Dryers

1 Answer

Kenmore series 70 dryer will not heat up replaced heating element thermostats check ok with ohm meter


If heating element was replaced and still no heat, Then what I would do is test the voltage current in the wiring and see if there is actually power to the element.

All parts to make dryer heat are:
heating element
thermal fuse
thermostat
timer

any one of these units can be faulty


Oct 10, 2009 | Kenmore Dryers

1 Answer

Kenmore 70 Series Dryer Model# 110.64742400


check the thermal fuse if it is blown also change the high limit thermal cut-off fuse www.repairclinic.com shows your parts. go there and enter model number. Also check the heat element. to get into it remove the lint filter and the two screws you'll see there then pry the top up at the front corners. And through the back you should find the heat element and blower housing and thermal fuse and high limit fuse and cycling thermostat.

Apr 06, 2009 | Kenmore 64742 Electric Dryer

Not finding what you are looking for?
Dryers Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Dryers Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Ned Halaweh
Ned Halaweh

Level 2 Expert

240 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a Kenmore Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...