Question about ASUS Televison & Video

Open Question

My asus zen aio pro all in one shut off snd nos tgere is no power or stand by light ,cgecked voltage out of power supply is good is there a fuse inside the computer that may have blown?

Posted by on

  • Mike Wood
    Mike Wood May 24, 2019

    Mine too... exactly the same. Have checked the drive - fully functional. Have changed the power cord unit - no effect. Will not power up or show stand-by light. 29 months old, so 5 months out of warranty!

×

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

tennisgal

  • 1 Answer

SOURCE: Insignia model IS-TVHD30

Wierd....I have the same tv and last week the same problem occurred.  I'm googling to see if i can find out how to fix this prob lem

Posted on Oct 25, 2007

Ad
freetek

Steve Allison

  • 5569 Answers

SOURCE: ESA Plasma PDP4294LV No video,sound

 checked voltages meter set to AC referenced to chassis VA, VE, etc no voltages. 
Do not try to measure voltages on the primary side of the power supply with a meter; you may damage the meter and cause new damage to the supply. There are switching frequencies somewhere between 50,000 - 100,000 Hz and possible voltage peaks of several hundred volts. 

Checking AC is only useful before a diode bridge that converts incoming AC into raw DC that is then chopped at higher frequency into an approximate HF AC, coupled to the secondary, then tapped and connected to more diodes to produce DC, finally regulated and sent on its way.
Your plasma set uses some higher voltages that could have caused the cracking sound they heard but the DVD player didn't cause the problem directly; maybe just caused the HV for the display to surge for a moment.
You may have additional fuses on the secondary side of the supply. If test points are accessible there, check for DC voltages and be suspicious of any fuse or test point that measures nothing at all.
I can't tell you which voltages to expect since that varies from one design to another but you should find several lower voltages such as 5 VDC for logic circuits and perhaps a 12 V point. The plasma's HV could be produced from a separate board fed from the AC line or get its supply voltage from the main supply. There aren't many standards to rely on here.      

The most likely semiconductor failure would be on the secondary side and diodes come in many different packages, many cylindrical, some in the TO-220 package with a metal flange and mounted on upright aluminum heatsinks. These will have only two leads and there will be some in the same package with three legs. The latter can also be checked statically but unless you know what kind of transistor or regulator (look about the same) you are measuring, you will not be able to ferret out a defective one with any luck. 
While you have the set open, check for any dust bunnies that can act as sponges, collect moisture and create a discharge path for higher voltages. 

Posted on Dec 27, 2008

No_ky

  • 59 Answers

SOURCE: reverse lights dont work

Check reverse light switch

Posted on May 07, 2009

gessneruk

David Melbourne

  • 22 Answers

SOURCE: MLT386X power supply

We have a page with pictures and descriptions on this supply.

Hope it helps!
http://www.findonefindall.com/toyota-sienna/LCT37SHA_Scott_Akai_LG_LCD_tv.htm

Posted on Sep 17, 2009

Anonymous

  • 46 Answers

SOURCE: Computer will not turn on. Possible power surge.

If the power supply is good then your motherboard must have gone bad during a surge.

Posted on Dec 27, 2009

Testimonial: "Thanks for the quick response!!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do not turn on. Power failure. Replaced all the electrolytic capacitors, but still does not work.


good day check if their is a stand by 5v voltage at the power supply and a light indicator on the front panel. now if no stand by voltage and indicator light the problem is with in only at power supply. check for shorted mosfet transistor and bad regulators. now if their is an stand by voltage but doesn't turn on check the inverter board and back light for shorted parts because the main board will not turn on. check also for bad processor. hope this will solved the problem thanks for consulting the fixya.

Aug 09, 2011 | Televison & Video

1 Answer

A friend gove me her lg plasma and ive plugged everything in and it hasnt even got a stand by light it has no remote


When no standby light the unit has a problem in the power supply circuit, you may need to first check the line fusee on the power supply to make sure its not blown. If the fuse is good then you may need to futher troubleshoot the power supply. All televisions have standby lights you just may not be visible because of a falty 5 volt stanby voltage..

Aug 03, 2011 | Televison & Video

1 Answer

The inline transformer in the power supply for my wife's Asus Eee1000HD Netbook was damaged in the folding mechanism of the recliner sofa. Now the activity light on the transformer fails to glow and no...


It sounds like the battery is fried. Replace the battery, and purchase the appropriate charger. This should get you up and running again.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Feb 18, 2011 | ASUS Eee PC 1000HD Netbook

1 Answer

I have a LG 37lc2d and it suddenly turn off and wont come back on, the stand by lights doesnt turn on either. i was wondering if its just the power supply? or how can i troubleshoot this my self to see...


There is a fuse on the power supply close to where the A/C is connected to the board. If the fuse is blown, look at the board and see if there are any burned components and or swollen capacitors. If there are bad components, I would suggest getting a new board.
If the board looks OK, disconnect the connectors from the board but leave in the A/C connector (this way you can isolate the power supply board), replace the fuse, and power up the TV.
If the fuse pops after the power is applied to the unit, then the power supply is bad.
If the fuse is still good, then power off the TV, connect on the main board’s connections, and power up the TV.
If the fuse is still good, then power off the TV, connect the inverters, and power up the TV.
If the fuse blows now, then the inverters and or the panel are bad.
A working power supply will create 5vdc for the main board’s stand by source voltage. This can be found on the power supply at the main board’s connector and it is labeled in black text.
I hope this information helps you.
Good Luck.

May 28, 2010 | LG 37LC2D Television

1 Answer

Cpu failure Light Stays On Cant Boot To Post Start up Asus P7p55


Check your power supply. Sounds like a bad or insuffecient power supply.

Mar 22, 2010 | ASUS P7P55D PRO Motherboard

1 Answer

No Display


hi....good day...>try to replace the ATX power supply...< thanks and good luck...^_^

May 29, 2009 | ASUS M2A-VM (0610839149438) Motherboard

2 Answers

Tv won't turn on..


need to replace the power supply

Sep 03, 2008 | Hitachi 53UDX10B 53" Rear Projection...

1 Answer

LCD HITCACHI TV


obvious your power supply internal supply blown a fuse or in shut down mode due to short. I guess since you have a light the 5v supply is working but power supply makes many voltages to work your set properly probable at least 5 diffent voltages. one or more maybe shorted ...shutting down the power supply's higher voltages. it gonna take a tech to fix it. good luck

Aug 21, 2007 | Hitachi 60V500 60" Rear Projection...

3 Answers

No picture


The power supply or sweep power supply blew up, or the Horizontal/high voltage circuit went bad. If you have no tV repair experience, call in a pro to assist you in this repair. Good Luck

Mar 31, 2007 | Sony KP-51WS510 51" Rear Projection...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top ASUS Televison & Video Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1176 Answers

B.Th. Pluijm
B.Th. Pluijm

Level 3 Expert

558 Answers

 Mike M
Mike M

Level 3 Expert

3324 Answers

Are you an ASUS Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...