Question about Hardware & Accessories
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: When pool pump stops at
Could be loose wiring, or bad clock motor.
Check if wires are connected, and make sure only the copper part of wire and no insulation is under the screw plate.
Make sure all wires are same gauge so that screw plate clamps down on wires.
Open following link to identify timer and then add a comment with model number and voltage for possible help. Tork T1100 series has replacement clock motor.
Posted on Jun 30, 2011
Tips for a great answer:
Jan 02, 2016 | Simpson Washing Machines
Aug 10, 2013 | General Electric GE 24-Hour Timer, 2-Pin...
Mar 24, 2013 | Cars & Trucks
Feb 01, 2013 | Washing Machines
When the timer is
plugged in, the timer's dial will turn clockwise. The pointer, on the face of
the dial, points to the current time of day.
1. Locate the segments
on the outer edges of the timer's dial. These segments, each representing 30
minutes, can be pushed down (try using the tip of a pen or pencil). Conversely,
segments pushed down can be easily pushed back by hand. Be sure all segments
are pushed up before programming. Select a time period (or periods) you want
the device turned on, push down the segments that fall on or within that time
period. For example, to have the timer turn a device on 10PM and off at 2AM, push
down the segments representing 10PM and 2AM, and ALL the segments in between. See
Figure 1.You may need to turn the dial clockwise to access the desired
2. Rotate the timer's
dial clockwise until the pointer on the face of the dial points to the current
time of the day. Note: Nighttime hours (from 6:30PM to 6:30AM) are highlighted.
3. Plug the timer into
an electrical outlet convenient to the device to be controlled.
4. Plug the device into
an outlet on the timer. Turn the device's switch to the on position for
automatic control. The timer will not turn the device on if the device's switch
is in the off position. The device will now turn on and off at the times you
have set. In case of power failure, reset the time of the day as explained in
Sorry no Image.
Dec 04, 2011 | Televison & Video
Jun 29, 2011 | York Hardware & Accessories
Dec 13, 2010 | Hardware & Accessories
Oct 05, 2009 | Garden
Sep 14, 2005 | NEC MobilePro 900 Handheld
67 people viewed this question
Usually answered in minutes!