Question about Kicker Car Audio & Video
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: kicker amp
if you amp is in the PROTECTION MODE its means that there some defective part , like for example the main ICs or TRANSISTORS output might be defective , and thats why its on the PROTECTION MODE , needs to be taken to a expert technician for repair.
Posted on Apr 16, 2008
SOURCE: best amp for Kicker Sub
The Kicker 08ZX400.1 would be a great amp for your subwoofer. It will work into a 4ohm load with no problems.
But you can buy an amp with more power, looks better, has a smaller footprint, and cost less than the 400.1. I'd look at the Alpine MRP-M500. Take a look at it here at Crutchfield. The M500 is also easy to install, runs cool, and is very efficient.
Hope this helps.
Posted on May 21, 2009
Tips for a great answer:
Jul 19, 2016 | Kicker Car Audio & Video
Aug 23, 2012 | Kicker Car Audio & Video
Jun 30, 2012 | Kicker IK150 Digital Docking System w...
Mar 17, 2012 | Kicker 06ZX750.1 Car Audio Amplifier
May 04, 2010 | Kicker CVR12 Car Subwoofer
Oct 08, 2009 | Kicker CompVX CVX104 Subwoofer - 10" Dual...
Jul 12, 2009 | Kicker SX650.1 650W Mono-Block Amplifier...
Jul 11, 2009 | Kicker 02S10L74 Car Subwoofer
Your Kicker L7 Ohms may be too low for the MA Audio Mono block amp. The MA Audio Amp is probably 2 Ohm Stable. The kicker will either be 2 ohm or 4 ohm Dual voice coil. To eliminate the low ohms as a possible threat to causing the map to go into Protect, Wire the kicker Voice Coils in Series. This adds the ohms, so that you either have 4 or 8 ohms.
I am using the following codes to show wiring. VC1+ stands for the Kicker Subs Voice Coil #1 Postive post. AO+ is the MA audio Amp output positive.
AO+ to VC1+
VC1- to VC2+
VC2- to AO-
This shopuld give you 4 or 8 ohm depending on the 15" L7 setup. Crutchfield does not carry the Kicker L7 in 15" They do have the L5 in 15".
If you know how to read a Volt Ohm Meter, set it to OHMs 20 and measure across VC1+ to VC1- and you should see between 1.5 and 5 ohms.. Do the Same with VC2+ to VC2-. you should see the same voltage. Also read from the Voice coil metal housing to VC1+ , VC1-, VC2+, and VC2-. and you should not read any ohmage to the case. The meter should say OL, or -1.
Oct 15, 2007 | Kicker Solo-Baric L7 S15L72 Car Subwoofer
Jun 29, 2019 | Kicker Car Audio & Video
117 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: