Question about Kenmore Washing Machines
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
i fixed by unplugging the microwave with the door open. I plugged it back in and the F6 was gone. I was then able to set the clock and turn the light on/off . When I closed the microwave door, the F6 came back on and the microwave was making a humming noise. I slapped the side of the microwave near the keypad, and the F6 cleared from the readout and the humming stopped. The microwave is working fine now. Don't know why, except maybe slap on the side reset a relay or something. Anyway, I will never by a Sears Kenmore appliance for the rest of my life. The door rattles when you open a close it (like a part inside the door is broken) and this is the second time a fault code has appeared during use. I had GE Profile appliances at my last house, which are more $$ initial cost, but who wants to screw around buying a new microwave every four or five years. I'll happily spend a couple hundred more for the peace of mind and knowing that it will work during Thanksgiving dinner with the family over.
Posted on Dec 09, 2007
SOURCE: Kenmore Elite HE3t
The machine control is unable to properly detect motor speed and the machine will
shut down. If a failure occurs during high-speed spin the door will be
unlocked after 3 minutes.
• Check Wire harness connections between the Drive Motor/Tachometer and the Motor Controller, and between the Motor Controller and the Machine Control
• The Drive Motor has failed
• The Motor Controller has failed
Posted on Jun 15, 2008
Depending upon which make and model you have, F6 is the code for either relay failure or shorted tempurature probe.
Posted on May 02, 2009
SOURCE: f21 code on kenmore he2 plus
Clean the filter in the pump behind the bottom panel,but remember it's full of water,If it's on a pedestal you can take the pump loose from the mounting pull it out a little and put a small pail or bucket under it before you open the trap.if it isn't on a pedestal it's a bit more challenging unless your in a basement with a floor drain. Open it very slowly and let the water drain a little at a time don't take it all the way out or you'll be in for a flood....good luck
Posted on Sep 03, 2009
Tips for a great answer:
Jul 31, 2018 | Heating & Cooling
Jul 10, 2008 | Whirlpool Microwave Ovens
Nov 24, 2012 | Kenmore Elite 45986 Front Load Washer
Apr 10, 2009 | Whirlpool GH7145XF Microwave Oven
Dec 08, 2007 | Microwave Ovens
38 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: