Question about RTO New Yamaha Inverter Ef2400is / Yamaha Generator Ef2400 / Perfect For Camping, Emergency Home Use, Construction Sites And More!

1 Answer

Generator only runs with the Choke all the way out. Stops when pushed in.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Only a suggestion. Sounds like the carberator has trash in it. You need to try to clean out the carb and check out the gas tank to make sure that that there is no trash in the tank. When opening the choke lever that allows another way for the fuel to get to the engine in order for it to run.

Posted on Aug 13, 2009

Testimonial: "Cleaned it out good and it runs just fine. Thanks"

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does it surge with choke pushed in?


I guess your air cleaner needs cleaning , take air cleaner off and try it. Its starving on gas, may have water in gas tank and would cause this also or plug fuel filter if it has one..

Nov 12, 2015 | Yamaha Inverter Ef2000is 2000 Watt...

1 Answer

Will not run without manuely chocking


Sounds like the unit has sat, and carb gum, Try draining the carb bowl and re-filling. There is a screw at the base of the bowl. Also make sure when cold choke is closed. And it opens fully after 3 minutes. Check battery voltage on choke coil.

Dec 17, 2013 | Onan 5500 Microquiet Generator

1 Answer

My honda vtx 1300 will not run with choke all the way in but will run with the choke half way in. what is the problem?


If your bike will only run with the choke half way out it's starving for feul. You have a clogged jet. By choking the bike you cut off the air and allow more feul to run through the carb.

Oct 30, 2012 | Honda Motorcycles

1 Answer

Yamaha ef1000 will start then push choke in and generator stops


clean tank fuel lines air filter and completely clean all carb parts and jets just did mine runs mint now did the same thing i also put in a new spark plug changed the oil a good once over goes a long way just take your time use a good carb cleaner like crc or gumout and check the jets they have small holes on the sides that can clog up hope this helps

May 07, 2012 | Yamaha 1,000 Watt Portable Generator...

1 Answer

How to start the generator


Hi Joe, I had asked for a little clarification and have not received any information. I will answer this question based on the generator is in good working order and it is a recoil start. Open the petcock, (this is the fuel valve) and give it about a minute to fill the fuel bowl on the carburetor. If your generator has an engine an on/off kill switch, set to on. If the generator has an auto idle switch set it to off. If the engine has a throttle lever located under the carburetor, push it all the way down (full throttle). Pull the choke knob out completely, there is a detent on the choke for half choke, pull it past this for full choke. pull the recoil starter rapidly. As soon as the engine starts running push the choke knob to half choke, this will allow the engine to run smooth while it's warming up. Depending on the climate that you are in, warm up time will vary. After a minute or two in cold climates start pushing the choke knob in, if it starts to run poorly pull it back out too the half position and let it warm up some more. When you can posh the choke in without the engine faltering it is ready to go. In warmer climates you might be able to start the engine without the choke or in the halfway position. Robin Subaru makes some of the finest small engines available. I would choose a Robin over a Honda every time. I hope this gets your generator going, and once again this is based on the generator being in good working order. Good luck, Michael Burke.

Dec 03, 2011 | Coleman Powermate Subaru 5000W Portable...

1 Answer

How to start a gas generator (should the choke be in or out, to the right or the left before starting


Most Generac generators have a lever for the choke that pulls out. So if the generator is being started for the first use or cold you should choke when starting . Let it run for 30-45 sec. then push it in . Once the engine has been run or warm you dont need to choke every time when starting .

Nov 04, 2010 | Generac Power Systems Generac 0057890 3250...

2 Answers

Generator will start and run with the choke on but stalls when you push the choke off.


Carburetor needs cleaning. You can try adding a gas preservative to the fuel and see if that helps, otherwise start by removing bowl on carburetor and cleaning.

Sep 22, 2010 | Yamaha EF2400iS Portable Generator

1 Answer

Coleman Powermate 5500 runs rough


vent in gas cap.
fuel filter.
dirt or gum in the carb.???

Dec 26, 2008 | Coleman Powermate Powermate 5000W...

2 Answers

Runs rough when choke pushed all the way to run position


Where can i obtain a manual for the 5500 gas generator

Dec 26, 2008 | Coleman Powermate Powermate 5000W...

2 Answers

My Coleman OHV 3000 will not start


dont use starter fluid ,will ruin engine.Sounds like the float in the carb is stuck.and keep lookin for a filter.

Dec 21, 2008 | Coleman Powermate Premium Plus 6250W...

Not finding what you are looking for?
RTO New Yamaha Inverter Ef2400is / Yamaha Generator Ef2400 / Perfect For Camping, Emergency Home Use, Construction Sites And More! Logo

Related Topics:

2,127 people viewed this question

Ask a Question

Usually answered in minutes!

Top RTO Electrical Supplies Experts

Thomas F. Schneider

Level 3 Expert

2715 Answers

Gene Haynes

Level 3 Expert

5391 Answers

knot
knot

Level 3 Expert

429 Answers

Are you a RTO Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...