Question about JVC KD-NX5000 Car Video Player

2 Answers

GPS shows car in washington

Showing calibration in process going to check the speed sensor but I don't have any other ideas ... been working on this for three weeks and can't even get JVC to figure it out?!?!

I AM STUMPED

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

When on the gps screen, hold donw the ent button for 2 seconds. you will now be on the stat. screen. if the speed sensor says 0 when you drive, it will not cal. The speed sensor has to be hooked up or it will not work. I don't know how it knows it is not hooked up. but it can tell.

Posted on Aug 04, 2010

Ad

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 58 Answers

Wouldn't be speed sense, that only helps with lag when you loose line of site with the satellites. As soon as it links with the satellites, it should know your position. More likely a software issue with the unit, or an antenna problem.

Posted on Aug 18, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My citron pricasso show on the dashboard - break fault and abs non function als doesnt show speed reading


speed reading may be a bad vehicle speed sensor or broken / disconnected wire to that sensor ~ it should also light up your check engine light ~ confirm by using a scanner to get a trouble code

abs brakes, similar process ~ need a scanner to find out which sensor went bad or wire disconnected to it or visual inspection of those sensors

Apr 13, 2015 | 2009 Citroen Xsara Picasso

2 Answers

My treadmill runs for 9 secons and stops and shows E1


Ok. So the first thing to try is to calibrate the speed.
You do this by doing the following:
  • With the SAFETY KEY in place, hold the ELEVATION UP and SPEED DOWN buttons for five seconds. The console will beep twice, "ENG0" will appear in the Distance window, and a number will appear in the Elevation window.
  • Press SELECT until "ENG3" appears; this is for Auto-Calibration.
  • Press START to Auto-Calibrate.
  • The treadmill will calibrate minimum and maximum speed, and minimum and maximum elevation. When Auto-Calibration is complete, the treadmill will reset to User's start screen. This process takes three to five minutes.
Make sure there are no errors. . .and that the speed goes from super slow to super fast and then stops. . .. if it stays slow. . or stays fast. .or error code appears during calibration, there is a problem.
If after a good calibration sequence, if it still does the stopping and E-1 after 10 seconds. ., then you need to (Power off and disconnect treadmill). . .then unplug the speed sensor from the lower power board, blow into the connector on the wire, and add a little contact cleaner spray to the connector on the board.
Recap: If it actually runs. . .but stops after a few seconds. . but the calibration runs and passes fine. .. .more than likely it is a speed sensor misread or a faulty speed sensor.

Sep 30, 2014 | Triumph 400T Treadmill

1 Answer

GPS elavation


Hello,

The altimeter requires calibration on the Edge 800.
To calibrate the altimeter:
1. Select MENU > > System > GPS > Set Elevation.
2. Enter the elevation, and select the check box.

You may also want to contact Garmin Support for assistance.
1-800-800-1020

Nov 13, 2011 | Garmin Edge 800 GPS-Enabled Cycling...

1 Answer

My Furuno gp1650wf chartplotter is showing the wrong speed in knots. It shows 20 knots when we are doing 28 knots. At an estimated 42 knots it says 32 knots. I have cleaned the GPS plug and the gps...


Congratulations the device is within functionality. As a matter of fact devices without shark lense are least impactful. For example, the device may least capture images or receive data in realtime however provides accurate flight resources.

Jul 24, 2011 | Furuno 1650wf/Nt...

1 Answer

No matter what address i input, it can find the location but when it start navigate, the map turns out a location in Kansas..i dnt know why is that..i input washington state address


You need to change the State. When you go to put in the address does it show the state as Kansas. If so press change state and change it to Washington.

Jul 19, 2010 | Garmin nuvi 260W GPS Receiver

2 Answers

Can't get Bowflex TreadClimber TC5000 to pass calibration.


DEAR
AT FIRST YOU MUST REMOVE COVER AND SEE CAREFULLY TO FIND SENSORS SOME SENSORS ARE PHOTO SENSOR AND GET ON DUST AND CAN NOT GOOD WORK THEN BETTER THIS IS YOU CLEAN DUST VERY VERY GOOD PERHAPS SOLVE YOUR PROBLEM.
you can countiue contact us with smart phone on wattsapp or telegram by :
+989195116738

Mar 29, 2017 | Bowflex Treadclimber

1 Answer

E2 error codes shows on my Pro Form 730 si treadmill


Did you find a solution for this issue? I have a similar situation

Sep 28, 2009 | Exercise & Fitness

1 Answer

GPS


i found out what thre prob was it was the speed sensor...it doesnt work on all vehicles cuz of the wiring

Oct 14, 2008 | JVC KD-NX5000 Car Video Player

2 Answers

CUSTOM WHEELS/TIRES SPEEDO PROBLEM


Go to a reputable transmission shop and find out about re-calibrating your speed sensor. They should be able to take care of that for you.

Jun 09, 2008 | 2006 Nissan Titan

Not finding what you are looking for?
JVC KD-NX5000 Car Video Player Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5013 Answers

Dalynn Turner

Level 2 Expert

346 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you a JVC Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...