Question about Furniture

Open Question

Kalorik WCL 20629 wine cooler upper zone fan runs slow and zone does not reach preset temperature range. Lower zone fan and temp okay.

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Lucas mulligan

  • 27 Answers

SOURCE: Thernoelectric Wine Cooler not cold

check internal and external fans are running if not replace them

Posted on Jul 29, 2009

Ad

gcarroll144

  • 1 Answer

SOURCE: chamber wc902 wine cooler which wont set temp

I have the same issue especially when there is a power outage. To reset it, press the preset until "1" appears, then adjust the temperature as low as it will go by repeatedly pressing the temperature "-" button. Usually works.

Posted on May 03, 2010

ttaylor800

  • 5 Answers

SOURCE: Magic Chef Wine Cooler Model MCWC44DZ Where can I

On the Magic Chef site you can order parts for the cooler. I took mine out and treid to find them on the web somewhere else and could not locate them anywhere except China and England. I know this isn't true but tried every search option I could think of. They are about $22 plus shipping (HIGH). You might try the following: https://www.fixya.com/support/t1814377-magic_chef_mcwc44dz_e4_error

Posted on May 17, 2010

misstanes

  • 1 Answer

SOURCE: Haier Dual Zone Wine Chiller - One Fan wont run

I have the same problem. When I first discovered this, both fans had stopped working and the temp for both zones was over 80. So much for the wine that had been stored there. After leaving the unit unplugged for a few days, the fan for the lower section started working again but the upper fan is still overheating. Haier customer service says too bad, so sad (I discovered this problem in the 13th month of ownership). I'm sure it is not worthwhile to fix this so it is going out with the trash and I'll look for a different brand for the next wine cellar that I purchase. Any ideas?

Posted on Jul 13, 2010

bobicehouse

Robert Moller

  • 1524 Answers

SOURCE: Temperature in both upper and lower zones will not

The condenser coils dissipate heat. If dust and debris accumulate around the coils, your refrigerator may not be able to cool properly, it may run continuously or it may stop completely as a result of an overheated compressor.

Before cleaning the condenser coils, unplug the refrigerator to avoid a shock hazard.

Vacuum or brush the coils. If coils have a filmy build-up, use warm soapy water to clean them. Take care not to spill or drip water onto the components of the refrigerator.

Posted on Jul 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wine cooler doesn't cool


I recommend that you maybe add more details to your question so it will be easier for Experts to understand the question and answer it.

Oct 06, 2012 | Kalorik WCL-20629 18 Bottle Dual Zone Wine...

1 Answer

Temperature in both upper and lower zones will not go lower than 50F. Cooler has 3 bottles of wine. Is there away to recharge with coolant/clean fans...? Thank you


The condenser coils dissipate heat. If dust and debris accumulate around the coils, your refrigerator may not be able to cool properly, it may run continuously or it may stop completely as a result of an overheated compressor.

Before cleaning the condenser coils, unplug the refrigerator to avoid a shock hazard.

Vacuum or brush the coils. If coils have a filmy build-up, use warm soapy water to clean them. Take care not to spill or drip water onto the components of the refrigerator.

Jul 10, 2011 | Danby DWC283BLS Wine Cooler

1 Answer

Upper & lower level does not cool. Temperature stays at 78 for lower level & 75 for upper. In attempting to set cooler temperature at 55 for top and 45 for lower it immediately reverts back to 78...


take shelves off. temp display unit in middle of shelf is where circuit board is for testing. pull middle unit forward and unscrew back panel. check lines for leak. color should look like a teal green. thats where your leak will be. Need tech. for the rest.......good luck!!!!

Jun 02, 2011 | Danby DWC283BLS Wine Cooler

1 Answer

Vinotemp 2 zone wine cooler flashes "Lo" on numeric display for lower compartment - will not hold temperature requested. Temp in upper compartment will not go below 67 even though it is set for 51. Room...


Not sure, but did you clean the filter in the back? Ours has that, and the temp starts creeping up every few weeks until I clean it. But we've never been able to get it below 58 or so, and in the last year, not below 60. I think that's just the nature of this type of cooling. Our house is also at 80. But, can keep it at 60 with the above cleaning.

Jul 22, 2009 | VinoTemp (VT60GNV) Wine Cooler

1 Answer

Haier Dual Zone Wine Chiller - One Fan wont run


I have the same problem. When I first discovered this, both fans had stopped working and the temp for both zones was over 80. So much for the wine that had been stored there. After leaving the unit unplugged for a few days, the fan for the lower section started working again but the upper fan is still overheating. Haier customer service says too bad, so sad (I discovered this problem in the 13th month of ownership). I'm sure it is not worthwhile to fix this so it is going out with the trash and I'll look for a different brand for the next wine cellar that I purchase. Any ideas?

Mar 01, 2009 | Refrigerators

4 Answers

MC wine cooler MCWC44DZ error code e3


I had an E3 on the upper zone. This fix was simple. Unscrew the 2 screws for the middle tray. Pull tray out as far as you can. Check the wires in the back, those are the wires for the fans in the back. The connectors over time corrode, and break off... All I did was connected the 2 wires that had broken off of their connector directly to eachother. E3 went away and the cooler is working as it should now.in

Jan 04, 2009 | Refrigerators

Not finding what you are looking for?
Furniture Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Furniture Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Tom Chichester

Level 3 Expert

54386 Answers

Brad Brown

Level 3 Expert

18110 Answers

Are you a Furniture Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...