Question about Coffee Makers & Espresso Machines

2 Answers

K cup stop brewing half way through cycle - Coffee Makers & Espresso Machines

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 27 Answers

There is a seal or gasket when you open the machine. It needs removed, cleaned and re seated back into the lid. Any dirt onn it breaks the air tight seal and messes everything up.

Posted on Aug 10, 2019

  • 1 more comment 
  • Mike Daniel-Keehn
    Mike Daniel-Keehn Aug 10, 2019

    There is a seal or gasket when you open the machine. It needs removed, cleaned and re seated back into the lid. Any dirt onn it breaks the air tight seal and messes everything up.

  • Mike Daniel-Keehn
    Mike Daniel-Keehn Aug 10, 2019

    There is a seal or gasket when you open the machine. It needs removed, cleaned and re seated back into the lid. Any dirt onn it breaks the air tight seal and messes everything up.

  • Mike Daniel-Keehn
    Mike Daniel-Keehn Aug 10, 2019

    There is a seal or gasket when you open the machine. It needs removed, cleaned and re seated back into the lid. Any dirt onn it breaks the air tight seal and messes everything up.

×

Ad

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 33 Answers

Make sure You have it on the right setting for the amount You want.

Posted on Aug 10, 2019

Ad

5 Suggested Answers

Anonymous

  • 25 Answers

SOURCE: Keurig starts & stops without brewing coffee, just descaled

The pic is clogged with coffee or the air bladder is bad. Use the tool on the underside of the tray to clean out pic. If that doesn't work, the bladder will be bad.

Posted on May 14, 2009

sonofbeach

  • 18 Answers

SOURCE: will not brew a full cup

Mine started off this way, then quit running any water through. I overcame the problem with a reusable K-cup. They are available online and at some national chain stores for about $15.00. It's a little more inconvenient than K-cups, but better than throwing out a $150 coffee maker.

Posted on May 21, 2009

Anonymous

  • 1 Answer

SOURCE: delayed brewing

The problem is in the sensor that tells the coffee maker when the brew cycle is complete. This is a heat sensor that's clipped to the heating element. The sensor gets overly sensitive and shuts things off too soon. Since schematics and parts aren't available for this unit, it's pretty much junk after it starts to fail. You can remove the sensor, but this creates a major fire hazard. My advice is to pick up a good percolator and forget the drip units. The Grind-N-Brew makes excellent coffee, but they barely last out the warranty and the cost of replacing them mounts up. I've gone through two (same problem with both) and it's no longer worth it to me.

Posted on Jul 26, 2009

Anonymous

  • 464 Answers

SOURCE: My Cuisinart 10 cup Grind & Brew does not

you need to run a few pots of straight white vinegar through the machine to clean out the lime build up in the tubes. the first time you do it, after it starts to pump the water, shut it off for a few hours and let the vinegar sit in the tubes. after doing this run a few pots of cold water through before making coffee.

Posted on Nov 08, 2009

heatman101

D. Floyd Kolb

  • 43501 Answers

SOURCE: My Keurig does not brew

Hi,

Here is a tip that I wrote that will give you some things to try that will help you get your Keurig coffee brewer working again.

Keurig Coffee Brewer not making a full cup of Coffee


heatman101


';][-0

Posted on Feb 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am descaling my Keurig for the 2nd time, it fills 2 cups w/vinegar and stops and won' start again, tells me its ready, help


A. Prepare
Step 1: Make sure you have 48 ounces of white vinegar on hand. You will also need an empty sink and a ceramic mug (Do not use a paper cup.)
Step 2: Empty the water in the water reservoir
B. Fill and Clean
Step 1: Pour the vinegar into the water reservoir and fill it to the top edge of the clear viewing area.
Step 2: Place a ceramic cup in the drip tray and run a brew cycle. DO NOT USE A K-CUP...just press the large cup button. Pour the contents of the cup into the sink.
Step 3: Repeat the brew process until the water reservoir is empty, pouring the contents of the cup into the sink after each cycle. Remember to open and close the lid between each cycle.
Step 4: Now fill the reservoir with fresh water and let the brewer stand for 4-hours while it is still on.
C. Rinse
Step 1: Ensure the water reservoir is filled with fresh water.

Step 2: Place a ceramic cup on the drip tray and run a regular brew cycle. Once again, DO NOT USE A K-CUP...Pour the contents of the cup into the sink.

Step 3: Repeat the brew process until the water reservoir is empty.

Step 4: You may need to perform additional brew cycles if you notice any residual taste.



Jun 01, 2014 | Keurig Platinum B70 Coffee Maker

1 Answer

Brew group/thermostat ?


Definitely sounds like an overheating issue. Especially if you have to wait a half hour for it to cool down and then it brews again. If it is under warranty I recommend replacing it.

Jan 24, 2014 | Saeco Vienna De Luxe Espresso Machine

1 Answer

Need cleaning info


Manual version: Prepare a cup of white vinegar and 4 cups of water. Pour into reservoir and initiate "clean" cycle. Boiler was warm up, shut off and repeat over the period of about a half hour, and then finally cough up all the stuff and end the cycle. Then, fill with cold water and run a full brew cycle to rinse.

My version: Dump about a quarter cup of CLR into the reservoir, let stand for a half hour. Then, add 4 cups of water and run the "clean" cycle. After finishing, unplug and turn unit over over the sink to completely drain, use tap water to clean and flush the reservoir thoroughly, dry thoroughly and then plug in, reset the clock and brew time, and run a full load of drinking water/distilled water through to final rinse. It will last forever with my method.

Feb 19, 2013 | Mr. Coffee 12-Cup Programmable Coffeemaker

1 Answer

Gevalia 12 cup coffee maker slow brewing


The pipes are blocked with build up scale or water dirt. You can try to descale the machine by adding in the water half cup of lemon juice and brew it without coffee leave if for 20 min and the clean it by brew it with fresh water these will make a diference then try this again in a week.

May 16, 2012 | Gevalia CM-500 12 Cup Coffee Maker

1 Answer

Hi My Kuerig B60 is not filling my cup like is was when I first got it. I have had it for about 5 months. I wait until it is ready to brew and select the big cup and it fills about half way meanwhile it...


Hello - I recommend that you purchase a de-scaling agent, white vinegar works very well. Simply run a cycle with only vinegar (do not dilute). Then run 4 cycles with water only. This should solve your problem.

May 11, 2011 | Keurig Special Edition B60 Coffee Maker

1 Answer

Only brews half a cup on the largest cup setting?


1.Power off machine.
2.Using a metal paperclip, insert it into left side of top needle. It must insert at least 1" deep.Insert it into slot on right side and again from back of needle.
3.Remove KCup cradle.Separate bottom from top.In the top section, insert the paperclip up into bottom needle from the bottom upwards.It will not go all the way thru and this is normal.
4.Reassemble KCup cradle and reinsert it back into coffee maker.
5.Power on machine.
6.Brew a cup of water only.There may be coffee grounds in the water and these should eventually clear during the remaining steps.NOTE: A large cup brew cycle should output a full 8 ounces (235cc).Less means there is still a blockage
7.Empty reservoir and fill with undiluted distilled white vinegar.Repeatedly run brewing cycle until Add Water light comes on.
8.Make sure Auto-OFF is NOT set and let last cycle of vinegar remain inside machine for 4 hours.
9.Refill reservoir with fresh water and repeatedly run brewing cycle until the water is clear and odorless.
10.Set Auto-OFF, if preferred.

Mar 26, 2011 | Keurig Special Edition B60 Coffee Maker

1 Answer

My Pot wont brew


mcdevito75 here, Your Mr. Coffee may need cleaning, here"s how, Fill the resovoir with white vinegar, cycle thru the machine 3 times, half way thru the 3rd time stop 1/2 way thru and turn off machine for 30 minutes, then recycle. After that rinse your Mr, Coffeee by cycleing thru fresh water each cycle takes another resovoir of fresh water to get rid of the vinegar. If this is not the problem, maybe the pump is shot. Contact Mr. Coffee by phone or online at Mr. Coffee.com or replace the machine.

Jul 09, 2010 | Mr. Coffee 072179228578 12 Cup Coffee...

2 Answers

Water doesn't come down when brewing


I had the same problem, and it turned out it was the top needle that was clogged. I used a safety pin to clean out the needle and it worked again . . . I descaled immediately, just in case it needed that too. I am back to coffee goodness!

Jul 07, 2010 | Keurig B60 Coffee Maker

1 Answer

Braun coffee maker starts brewing, then stops after a few seconds


ijustam1

I have the same machine, Braun KF180 12 Cup Coffee Maker. In normal operation the brew cycle is stopped when the water reservoir is empty. The only way the coffee maker knows if that is true is when the water-brewing heater gets too hot. Your brewing heater is probably encrusted with calcium deposits if you have been heavily using the coffee maker. Vinegar will work but it is weak and you will have to cycle this solution through many many times. You should instead use "Lime Away" or "CLR" and let it sit there in a brew cycle or multiple brew cycles for a while. NOTE: Remove the filter when cleaning this way and when the brew cycle is complete, rinse thoroughly -- your taste buds will let you know if the machine is not rinsed thoroughly. -- Good Luck!!

Jan 22, 2009 | Braun FlavorSelect KF 180 Coffee Maker

1 Answer

Cuisinart DCC2000 quits brewing after 1or 2 cups


I have the same problem with the exact same coffee maker I have tried pushing the 1-4 cups button. That worked for a couple weeks, now it is back to only brewing half the water in reservoir whether I push the 1-4 button or not. It is very annoying.

Nov 14, 2008 | Cuisinart DCC-1200 Coffee Maker

Not finding what you are looking for?
Coffee Makers & Espresso Machines Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Coffee Makers & Espresso Machines Experts

ThaMp3Doctor
ThaMp3Doctor

Level 3 Expert

8597 Answers

Pierre Laplante

Level 3 Expert

2042 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Are you a Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...