Question about GE GSH22JFR Side by Side Refrigerator

2 Answers

How do you adjust the doors to closed completely?

Door height and close adjustment?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GE Master
  • 1,606 Answers

Loosen the top door hinge on the freezer door . Pull the top of the door as far to the left as possible ( with the door closed ) . Re tighten the hinge screws . On the fridge door , do it the same way , except pull the top of the door to the right . Also , there is a screw at the bottom hinge , which can be turned to raise the door to even level with the freezer door , to make them even in height .

Posted on Sep 07, 2009

Ad

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,070 Answers

The lower hinge on each door may have a door closing cam. It raises the door up ¼ inch when opening and this assist in closing the door. If it’s wore out and doesn’t work the door may not seal and the gasket can be damaged. Watch the operation of the door to see if it rises up when opened.

Leave the door shut and let the magnetic gasket hold the door in place. Put something between the bottom of the door and the floor to hold it in case it slips.
Remove the bracket holding the pin and hinge assembly taking note of order of removal of parts. Slide new cams on. You probably need two.

Posted on Sep 03, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I adjust the sealing of the door when closing


The adjustment for this is usually on the back or side of the motor unit. Clockwise movement of the screw will lower the door position - keep adjusting till it seals. Do not over seal because then the door will reverse itself as the obstacle circuit might kick in and open the door.

Dec 25, 2014 | Building Materials

1 Answer

Dishwasher blows out steam and has ruined wood floor in kitchen have to replace wood floor


The door seals (Gaskets) surrounding the door are not tight. The door adjustment, is dependent on the tilt backward and height adjustment (adjusting levelers) on the corners. If the upper locking tab screwed to the counter tops underside is loose or misaligned, bent, or broken, the door won't close fully and cause the same problems.

Mar 17, 2014 | Dishwashers

1 Answer

Door open light on in the dash lights flicker on and off. but doors r closed


one of the door ajar switches are not adjusted properly and the door is not contacting the swtch enough to open it completely. close all doors and have someone watch the light and go around to each door and just start bumping the door and see which switch it is. replace or adjust the switch to better contact the door when it is closed

Mar 06, 2011 | 1995 Nissan Pathfinder

1 Answer

Door not closing completly


There is no adjustment, make sure that the door or the door arms are not bent outward, or that there is no debris around the door seal.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

Jul 21, 2010 | Thermador P304CS Gas Kitchen Range

1 Answer

I have a new Sears 315mhz garage door opener and the door fails to reverse when an object is placed under the door


It sounds like the force adjustment may be set too high. Check this:

The force adjustments control the pressure used to open and close the door. A new garage door opener from the factory is set to the lowest possible force adjustment. If you have a properly balanced door, the forces required to open and close the door should be minimal.


The force adjustments are usually located on the rear of the garage door opener and/or under one of the light lenses, If your opener has two lights. If you have lights on the side of your opener, the force adjustment will be located under the right light lens. The force adjustments are labeled with an arrow indicating open or close and numbered 1 to 9, with one being the lowest force and nine the highest. The force adjustments can only turn 260 degrees, or ¾ of a complete turn. Changes to the forces should be done in 10-degree increments. Please remember that too much force will interfere with the proper operation of the safety reversal system. Do not increase the force beyond the minimum required to close the door. Do not use the force adjustments to compensate for a sticking, binding, or unbalanced door.



Mar 09, 2010 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Track rail bends when closing the door


I think you need to take the cover off the motor unit and watch the limit switch assembly in operation. Takes only a few seconds to see how it works and see if it is damaged in some way. You need to turn the down limit adjustment in the opposite direction of the arrow printed on the cover to stop the door sooner. I think the down force adjustment on the rear of the motor unit is out of adjustment also. This adjustment affects the safety of the opener and should only be adjusted high enough to consistently close the door.

Oct 08, 2009 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Belt drive track arm bows up


YOU MAY NEED TO GET THE SPRING ON THE DOOR ADJUSTED.

WHEN AN OPENER IS INSTALLED THE SPRING SHOULD BE SET A LITTLE HEAVY. YOU WANT THE DOOR TO SLOWLY DRIFT CLOSED IF LEFT HALFWAY UP.

IT SOUNDS LIKE EITHER YOUR SPRING NEEDS ADJUSTMENT OR THE DOOR BINDS AT THE BOTTOM - HOW DOES IT WORK MANUALLY??

IF YOU CAN'T CLOSE IT WITH 3 FINGERS THE OPENER WILL HAVE TROUBLE.

YES THE CRAFTSMAN RAIL IS WEAK MAKING IT THAT MUCH MORE CRITICAL TO SET THE HEIGHT PER INSTRUCTIONS AND MAKE SURE THE DOOR WORKS EASILY,

HOPE THIS HELPS

Apr 05, 2009 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Garage door won't close by remote in cold weather


There are ususally two adjustments on garage door openers...
One is for the pressure and the other is for the travel. Assuming that the travel adjustment is properly adjusted...

On a cold day things are a little tighter and it "wants" a little more downwards pressure to complete its cycle. Sorta like me in the morning -- I need a little coffee to get going on a cold morning.

Adjust the down pressure/force just enough to make the unit close properly. Do not over adjust the down pressure or you will find it won't stay closed. Sometimes the manufacturer doesn't make it too clear where this adjustment is, but you should be able to find it if you look around.

I have seen units that were installed for years all of a sudden need a little tweak of this adjustment.

Good luck

Mar 11, 2009 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Adjustment to door hinge, as door does not close completely


In most cases door hinges needs to be replace but some time with old stile ovens and ranges help this trik:
1. Put small towels on right and left hinge between the door and range/oven body
2. Close door and gently push like you try to close completely.
3. Try several times.
4. Open door, remove towels and see if it helps
5. If not replace hinges

I’m happy to help further over the phone at https://www.6ya.com/expert/vitaliy_f406165329c75ede

Nov 29, 2008 | DeLonghi Kitchen Ranges

1 Answer

Oven Door Doesn't Completely Close


no adjustment. probably needs new hinges - hinge spring gone slack

Mar 10, 2007 | Miele Novotronic H350-2B Electric Single...

Not finding what you are looking for?
GE GSH22JFR Side by Side Refrigerator Logo

742 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Ron Beer
Ron Beer

Level 1 Expert

11 Answers

Vish Iyer
Vish Iyer

Level 2 Expert

75 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...