Question about Hobart Food Mixers
You can use a heavy weight gear oil or call the local hobart branch for it.To remove oil----Look under the mixer where the beater shaft is in the back and you will see a three quarter inch nut,remove this nut and drain the oil then put nut back in.To fill the unit remove the top cover screws and remove the top,you will see a long hexagon nut in length,remove this and grab a funnel then add the oil---be patient it takes time to fill as the oil is heavy.
Posted on Jul 26, 2008
there is an oil case drain pulg under the top by the clutch, you can drain the motor housing through there, \
i have used 5w30 in a pinch
but it would be better if you ordered hobart oil from the website
its cheap but very very good
Posted on Oct 16, 2009
underneath trans. you will find a drain plug remove, drain oil,replace plug ck the sight glass @ this time if not clear would recommend replacing glass remove top cover where the front cover screw theaded into remove that is your fill hole. add new oil till you hit level line in sight glass,reassemble
Posted on Jan 09, 2010
You're right, it's broken down grease. The A200 doesn't have a rubber seal to prevent this from leaking, either. That's normally OK, when the grease in reasonable condition, but when it breaks down bad enough, you see what you're seeing. The grease needs to be changed which requires disassembly of the transmission. It's quite a job (and very messy) if you're not familiar with it, but if you're interested I know I've read (and may have written one) instructions on disassembling the transmission on this website. If you decide to do the job yourself, be sure to remove the attachment hub (comes out to the inside of the transmission) and clean the passage well.
Posted on Jun 10, 2010
Tips for a great answer:
Sep 06, 2011 | Hobart H600 Stand Mixer
Aug 17, 2011 | Hobart A200 Stand Mixer
Jan 15, 2011 | Hobart HL600 Legacy Stand Mixer
Nov 04, 2010 | Hobart D300-6036 Mixer
Aug 02, 2010 | Hobart D300 Stand Mixer
Nov 19, 2009 | Hobart D300 Stand Mixer
Dec 23, 2007 | Kenwood KM400 / KM410 Chef Classic Stand...
125 people viewed this question
Usually answered in minutes!