Question about Whirlpool Dishwashers

1 Answer

Whirlpool dishwasher doesn't drain. I have drained it by hand then did one cycle. Water remains in the bottom.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 128 Answers

Check pump clean strainer

Posted on Aug 06, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 126 Answers

SOURCE: dishwasher not draining

if its new call your dealer its a warranty call

Posted on Dec 22, 2007

aborcass

Ron Coons

  • 2651 Answers

SOURCE: dishwasher not draining

try pressing the cancel/drain button.Do you hear water draining into sink freely?? if not i would disconnect drain undersink look for a clog right there first

Posted on Feb 22, 2008

elhomspam

Raymond Cardona

  • 58 Answers

SOURCE: Whirlpool Dishwasher DU850DWGX1 won't completely drain

Commonly this is result of low water pressure or hose height/length

As long as the water is below the heating element and the dishes are getting clean its actually normal. Sometimes the pressure or hose length/height meets specs but will not always drain all water.

But as long as it is below the heating element this is normal

I am sure.

Posted on May 02, 2008

Mike Waldron

  • 1019 Answers

SOURCE: dishwasher not draining

Hi,
the first things to look for, are the simplist faults.
1:) Check that the Outlet Hose-Pipe Isn,t Blocked-Kinked Or Bent.
2:) Check that the Pump, is not clogged/Blocked or not-functioning.

Hope this helps you start, your fault-finding successfully.

Mike @ Compurepair.

Posted on Aug 02, 2008

rylee_smith

Rylee Smith

  • 8619 Answers

SOURCE: Bosch dishwasher has water in bottom after cycle is complete

Hi

Kindly check for the following :

Check for hose kinks or food plugging drain hose. Start at the drain port exit.
Check the check valve and drain hose for debris.
Check pump motor for reversing during the pump out make sure the dishwasher is pausing between the wash and drain cycles letting the pump/motor reverse for the drain cycle.
Check pump motor assembly for a drain solenoid, during the pump out make sure the solenoid makes that distinctive "clunk" noise
If you have recently installed a new garbage disposal, check knock-out plug at connection.

93cb8b1.jpg

Check pump impeller for damage.
Check that the water inlet valve isn't seeping fresh water into the dishwasher when off.

Please contact for any further clarifications.

A Fixya Rating would be appreciated if.

Thanks
Rylee

Posted on Feb 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Machine won't pump out last water after cycle.


Does not drain the water at the end of cycle - Dishwasher ...

https://www.ifixit.com/.../Does+not+drain+the+water+at+the+end+o...
iFixitThe dishes seem clean, but the water from the last cycle remains in after it has stopped. ..... noticable cracking noise when the machine was triying to drain the water.... to purchase a timer unnecessarily and they usually won't take them back.
Checking a Drain and Circulating Pump in a Dishwasher ...? 4:17www.youtube.com/watch?v=oLPBlkIsB5sMar 26, 2010 - Uploaded by ApplianceHelpOnlineIf your dishwasher doesn't pump out or will not wash watch this video. ... GE Nautilus Dishwasher wont run - fills water and doesnt drain - motor ...How to repair a dishwasher, not draining - troubleshoot ...? 6:18www.youtube.com/watch?v=rO19zoOyNHAFeb 26, 2014 - Uploaded by AdamDIYHow to repair a dishwasher, not draining - troubleshoot Whirlpool ... awhile but now blade on grinder won't spin. what should be my next step? thnx ... from the bottom to access the water pump. but this was much simpler and it worked. thanks. ... If I manage todrain it now, I'll do what this video instructed :).

Oct 19, 2015 | Dishwashers

1 Answer

After dishwasher run through it's cycle, the water does not drain properly and remains in bottom of the dishwasher


Hi
Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. First make sure that the drain is not clogged and remove clogs if present. If no visible lint is present then remove the lower front access panel to check the drain filter and drain pump for any clogs, you'll need to clean the drain filter and drain pump completely. Also, check for any food pieces stuck near the pump impeller & clean the chopper assembly. Please note that dishwashers don't drain out the complete water such that heating element doesn't overheat. Hope this helps... Please post back for any further assistance.
Daniel

Aug 10, 2011 | Jenn-Air 24 in. JDB1100AWS Built-in...

1 Answer

The unit runs through cycle fine, but ends with water remaining in the bottom, that has not been drained and dishes are covered with soap residue.




Hi,


Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems -
Water will not drain out

heatman101

Dec 16, 2010 | Whirlpool GU2400XTP Built-in Dishwasher

1 Answer

D/W does NOT drain. Water remains in bottom after cycle is completed


Hi


Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dishwasher and remove the drain hose and check for any visible clogging. If still not visible then the drain filter or drain pump is clogged and you'll need to clean the drain filter and drain pump.


Please note that dishwashers don't drain out the complete water such that heating element doesn

Oct 20, 2010 | Whirlpool 24 in. GU980SCG Built-in...

1 Answer

The water used to completely drain out of the whirlpool dishwasher after the last rinse cycle. now water remains in the bottom. Also noticing decreased flow when actually draining into the garbage disposal...


Pumps. There are 2 pumps in most dishwashers. The drain pump,( which describes itself -it pumps the water out of the machine.)
The recirculating pump which forces the water at high pressure through the spray nozzles and arms. (This is how the cleaning action is performed)
These pump may either leak, or burn out. Either way, the only solution is replacement.

Mar 09, 2010 | Whirlpool 24 in. ADG6340iX Built-in...

1 Answer

We have a Whirlpool Gold Quiet Partner GU980SCGZ0 model. When rinse cycle is over the water only trickles out when draining. We checked the drain and it is not plugged. Water remains sitting in bottom of...


I took the check valve assembly off the bottom of the pump assembly and there was a big chunk of string balled up in the line which created a plug against the screen when trying to drain.Works great now!

Feb 15, 2010 | Whirlpool Dishwashers

1 Answer

The only button that works is the cancel drain


Sounds like a keypad malfunction or the control board has gone bad.

Feb 13, 2009 | Whirlpool GU2400XTP Built-in Dishwasher

1 Answer

Ran on normal cycle when done 2 inches of water on bottom


Test by restarting the cycle and see if water drains if it does not then there is either a blockege in the pipe ,pump,or in the machine where the water passes out normally through a filter if you have checked and cleaned out filter and drain pipe and there is still no draining then listen to the pump if you can hear a humming niose then there is something in the pump itself and you need to take it out and inspect the impelar houseing remove what ever is there put back and enjoy if there is no noise and pump is clean then it is proberly fualty and nedd replaceing.

Jan 23, 2009 | Whirlpool Gold 24 in. Built-In Dishwasher...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Dishwashers Experts

Mike

Level 3 Expert

4367 Answers

Bruce Denton

Level 2 Expert

273 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Are you a Whirlpool Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...