Question about Kenmore 65942 Electric Dryer
This is usually caused by a motor getting too hot. The motor has a shutoff to protect it against burnout. It will reset when it gets cool. As the motor overheats more and more these shutoffs become more frequent and longer
Motors get hot for several reasons:
1. Motor going bad
2. Lint around motor causing it to retain heat
3. Vent system open at some point inside or behind case allowing heated air to remain in motor area
Follow the procedure below to disassemble and check interior of dryer. Vacuum carefully especially around and in the ends of the motor.
Disconnect Power. Lift Cover on lint filter. Remove two Phillips screws taking care NOT to allow them to fall into the blower housing. Place putty knife in the seam between the top and front panel about 2” in from either side. Push in on clip while pulling control panel forward and tilting putty knife handle up, all at the same time. Same on opposite side. Raise top all the way.
Looking down inside dryer on left and right see a 5/16” hex head screw about 6 inches down. Remove each side while holding front panel in place. Pull top of front panel about 3 inches forward from sides and then pull up. This will disengage the front panel from lower pressure clips and allow you to turn it sideways and expose the dryer interior. Reverse process to re-assemble. Take careful note of belt configuration BEFORE removing it. Draw a diagram of its travel.
Motor and idler pulley for dryer will be on right.
Posted on Sep 11, 2009
Testimonial: "Sep 20, 2009 - Thanx alot for the response. Once inside the interior, I vacuumed around the motor and ends. Didn't seem especially built up with lint. After reassembling, did a few loads over a week or so with no problems. Now today, while drying, Wife opened the door to pull something out while still damp. When she closed the dryer and pressed the button to re-start....Nothing. Have waited over 45 min. and still won't start. Could it be something else? Thanx again"
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jan 13, 2013 | Kenmore 65924 Electric Dryer
Aug 21, 2011 | Dryers
May 18, 2010 | Kenmore 63942 Dryer
Jul 21, 2008 | Kenmore 64742 Electric Dryer
Jun 28, 2008 | Kenmore 60172 Electric Commercial Dryer
Jun 26, 2008 | Kenmore 60172 Electric Commercial Dryer
May 06, 2008 | Kenmore 62882 Electric Dryer
Jan 04, 2008 | Kenmore 64892 Electric Dryer
Nov 18, 2007 | Kenmore 60172 Electric Commercial Dryer
Jan 07, 2011 | Kenmore 65942 Electric Dryer
474 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: