Question about Office Equipment & Supplies

1 Answer

I have an EP5920 projector. It stopped projecting in the middle of use and shows an orange light blinking on the power and a red (steady) on the lamp.

I've changed the bulb (lamp) but it still does the same.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

Typically this means the device is overheating. Check if the fans are doing their job and if any filters / air intakes need cleaning.

Posted on Sep 23, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 14 Answers

SOURCE: i have 2003 2.5 z4,

check the socket the bulb goes into

Posted on Mar 03, 2010

Rajkumar S

  • 104 Answers

SOURCE: changing high mounted stop light bulb

HMS Lamp will be mounted in roof or in rear parcel tray.

You have to locate the screws which will be closed/covered by a dummy cap. Remove the cap and unscrew the assembly, you will be able to replace the bulbs

Posted on Jun 06, 2010

emissionwiz

Marvin

  • 85206 Answers

SOURCE: Oil light blinking

there is always the possibility that you really have low oil pressure when you get this light, at idle the engines oil pump produces the least pressure and if there are problems then that is when it shows up, so have the oil pressure tested by a shop with a mechanical test gage, if the oil pressure is within spec then replace the oil pressure light sending unit on the engine, I don't recommend you drive this until u are sure of the pressure, u can SEVERELY damage the engine is the pressure is really low.

Posted on Jun 23, 2010

Testimonial: "Ok..Thank you very much!!"

muntejaya

Muntejaya Ginting

  • 10421 Answers

SOURCE: Right rear tran signal lamp does not work. changed

Please check the cables lead to your rear turn lamp for loose connection. Both turning lamps ( rear and front) should work to keep turning lights back to normal blink.
Regards

Posted on Apr 29, 2011

Bill Boyd

  • 53755 Answers

SOURCE: I have this orange light show up on a 2011 Volkswagen jetta it's orange parenthesis with and exclamation in the middle

I suspect that it may be an engine or tranny fault report light As it is coloured I suggest you have the fault codes read befor the fault becomes critical Check in the owners manual for what it means

Posted on Mar 10, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Orange light blinking when turned on and doesn't project picture


First check your manual for trouble shooting the lights meaning. I think it is the bulb.

Jan 10, 2013 | Toshiba TDP T1 Multimedia Projector

1 Answer

When I hit the start button on my NP 115 it begins to sound like the fan labors and pulses until it shuts down and the red light blinks in a series of 6 blinks. It also has a very hit frequency squeak that...


after 5 minute image go out n power indicator steady light orange n status indicator red light blikns in a series of 6 blinks. in the manual book said lamp error.. what mind "lamp error". please help me.

Jul 28, 2011 | NEC NP115 DLP Projector

1 Answer

I have a NEC VT470 Projector. The power light is steady orange and the status light blinks red 6 times.


steady orange means projector in standby mode
red light 6 times is a lamp error.
either the lamp is old and wont start up or the ballast power pcb is not working.
can you hear the sparking of the high voltage trying to strike the lamp.
if you can then the lamp may be dodgy.
can you borrow one to test it out

Mar 02, 2011 | NEC VT470 Multimedia Projector

1 Answer

I have an orange light blinking on the power and a red (steady) on the lamp? What is the problem?!


The projector bulb has failed to light.
This could be due to a bad connection on bulb (remove and reinsert ) or that the bulb has failed.
Unfortunately they are not cheap.

---


Please dont forget to vote this answer was helpful

Many thanks

------



Feb 14, 2011 | BenQ MP620p DLP Projector

1 Answer

I have a wd52525 the status light keeps blinking


There are 3 different LEDs on the front of this televison. The TIMER will blink green. The STATUS will blink orange and the LAMP will flash red or orange depending on if there is a failure or if the lamp timer is showing over 5000 hours.

If I answer your question directly and the status is blinking a steady orange light, then you have left the side filter cover or the front lamp cover off or they are loose.

Also holding the menu and device buttons together until the timer light blinks will reveal a code that will help in diagnosing your problem. Goodluck.

Jul 04, 2010 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Power light is steady orange and lamp light is red but there is a new bulb in it. NEC VT676


Power light is steady orange and lamp light is red but there is a new bulb in it. NEC VT676

Mar 02, 2010 | NEC VT676 Multimedia Projector

2 Answers

Projector screen turns off after 10-20 seconds


Is the projector receiving a source signal? if not it will power itself down after whatever time you have it set to do so when no signal is present.
Just an idea?

Jan 03, 2010 | NEC NP-1000 Projector

1 Answer

It's on, then it's off


Is the fan running properly or are any vents blocked?
Sounds like it is overheating.

Feb 15, 2008 | NEC MultiSync MT1050 Multimedia Projector

2 Answers

Lamp will not come on


try pressing and holding the enter button on the projector for about 30 seconds - this resets it. It worked for me!!

Feb 10, 2008 | NEC VT460 Multimedia Projector

Not finding what you are looking for?

Open Questions:

Office Equipment & Supplies Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you an Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...