Question about Vehicle Parts & Accessories

1 Answer

My 1997 4 cylinder Chevy S10 won't start and has no compression do you think it could be the ignition security system

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 17 Answers

If you lost all compression on all cylinders at the same time check your timing belt or timing chain. good luck .

Posted on Oct 09, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Ronnie Wilson

  • 1596 Answers

SOURCE: 1997 Nissan Altima Cylinder 1 misfire detected.

This Sounds Like a COIL PACK Problem

Posted on Aug 05, 2009

Anonymous

  • 1 Answer

SOURCE: 2001 Chevy Impala Security System

I have a 2001 Impala. My security light will flash and sometimes the car won't start. My dad told me turn the key to the start position, place your foot on the break, put your car in the last gear it was in (D, R, or N). Then shift all the way back into park. Make sure you shift all the way into park. Take your foot off the break. Then turn ignition back to off. Your car should then start right up. He said the sensor still thinks the car is in D, R, or N although it's in park. So it confuses the system and it doesn't start because it doesn't know which function to do. It pretty much locks up. I'm pos. this will work. My car does it every few months. Hope this helps.

Posted on Oct 05, 2009

nicholas tuttle

  • 218 Answers

SOURCE: 1997 chevy s10 blazerdash wont light up when key

the dash sound's like a fuse, check the fuse box under the hood and in the door jamb on the side of the dash, also check your fuel filter and fuel pump, im betting on the pump because i have a 2001 chevy blazer that has had two replaced and it has 233000km on it!

Posted on Jun 05, 2010

pcdj64

Steve

  • 1150 Answers

SOURCE: I have a 2001 Olds

you can not bypass the security in that car, it is built into the main computer, they have problems with the ignition switch screwing up and the only way to start it while the light flashes is to turn the key to ON but don't crank engine, leave on for 10 to 15 minutes until light goes out then start car.

Posted on Sep 22, 2011

redds55

Ricky Peters

  • 2620 Answers

SOURCE: s10 chevy 98 just started sputtering, losing power, it won't go over 50mph. engine light is on and blinking

First thing you need to get the trouble code out of the computer.

Posted on Jan 31, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Chevy Cheyenne won't stay started


Most likely a bad ignition switch (unless you just installed a security system) these have a history of ignition switch Failiures.

Jun 04, 2014 | 1995-1997 Chevy 1500 Truck Ignition...

1 Answer

Misfire in cylinder4 97 tahoe


Check the plug and wire by taking them out and swapping them with a plug and wire from another cylinder. If the miss follows the parts, they are bad. If the miss stays with the cyl you may have a bad injector, bad compression or bad dist cap.

Mar 19, 2013 | 1995-1997 Chevy 1500 Truck Ignition...

1 Answer

Reseting ignition in 2000 chevy s10


Follow this link. It tells of a way to reset the system, and a way to bypass if that doesnt work
http://vatspasslockpasskeysecurityhelp.yolasite.com/

Feb 23, 2013 | 1995-1997 Chevy Tahoe Ignition Starter...

1 Answer

1997 chevy 1500 z71 cylider 1 misfire


Start by inspecting the spark plug. If it looks ok, swap it with another cyl and see if the miss follows the plug. Do the same with the wire. If the miss changes with the part, that is the problem. If it stays with the cyl make sure you are getting spark from the dist cap. If the miss is still there, check engine compression. If it is good, may have a bad injector or mechanical problem or vacuum leak

Feb 17, 2013 | 1995-1997 Chevy 1500 Truck Ignition...

1 Answer

I have a 96 Chevy s10 it cranks but won't start I


You need to find out if the fuel pump is working, getting gas up to the engine.
If the pump is working and seen to have good fuel pressure, check ignition by checking for spark.. To work, the engine needs, you know, gas, air, spark, and compression. Why people say, check for gas, check for spark.

Dec 20, 2012 | Cars & Trucks

1 Answer

1990 Chevy s10 won't start, have replaced plugs, wires, timing chain, fuel pump,distributor, starting fluid nothing helps


Have you checked for a broken timing chain, that would be the next step. Make sure number one cylinder is up on compression stroke when the timing mark is on 0 degrees BTDC on the crank pulley. Pull the plug and feel the pressure as it nears TDC.

Aug 06, 2012 | Chevrolet S 10 Cars & Trucks

1 Answer

Misfire on number 6 plug code p0306on 1997 chevy silverado


that code means the #6 cylinder is not putting out power, it doesn't mean any paticuliar part is at fault, it can be low cylinder compression, a defective fuel injector or computer, a defective plug or ignition coil or a large intake manifold vaccum leak .

Feb 18, 2010 | 1995-1997 Chevy 1500 Truck Ignition...

1 Answer

I changed the steering column and put the factory key switch in it and it will start and die and the security light is blinking


you couldve damaged the wire on the ignition cylinder,inspect the orange wire and make sure its plugged in good under the dash,if it checked out ok then you may have to get a new key and cylinder from your local chevy dealer

Jan 18, 2010 | 1995-1997 Chevy Suburban Ignition Starter...

1 Answer

Can i get a t-harness for a 1997 s10 blazer


1997 blazer needs GM-1 harness
S10 blazer were only made until 1994 I think

Jan 15, 2010 | Bulldog Remote Starter & T-Harness Kit for...

2 Answers

Anti- thief system keeps car from starting.


try locking and unlocking using key cylinder in driver's door

Jan 13, 2009 | 1995-1997 Chevy 1500 Truck Ignition...

Not finding what you are looking for?
Vehicle Parts & Accessories Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vehicle Parts & Accessories Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14764 Answers

Brad Brown

Level 3 Expert

18110 Answers

Are you a Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...