Question about Hardware & Accessories

1 Answer

Need to have 6, 3 way LED units replaced that I purchased @ Home Depot. All bulbs in all of the units burned out.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,150 Answers

Contact Home Depot or the manufacturer for warranty replacement or out of warranty parts

Posted on Nov 02, 2019


6 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Franklin Ouchida

  • 725 Answers

SOURCE: Water Filter location

the filter is in the toe grille under the freezer door is a filter pn#4396508 you should be able to get it at Home Depot/Lowes

Posted on Sep 06, 2008


Wayne Mineard

  • 1901 Answers

SOURCE: Reviews

If you have not had it for the full warranty period, by all means. (I would call their Customer Service number first.) Here is the site for phone numbers:

Home Depot Contacts

You might also be interested in this website. You might use this for "ammunition".

Posted on Apr 11, 2009

SOURCE: Stovetop lamp sockets very brittle and are disintegrating.

In effect (given the unit is wired correctly) without insulation on the socket, you have an exposed neutral wire in your oven -- this is certainly not as dangerous as an exposed hot wire, but does present risks. I recommend replacing the light sockets -- you'll sleep and cook a lot better.

Posted on Apr 23, 2009


William Miller

  • 9179 Answers

SOURCE: I purchased a Magic Chef under cabinet microwave

Since it's a clearance item, it may not have a warranty.

But you should check with Home Depot on that if you haven't already.

Otherwise, you'd have to have it repaired yourself.

We see (and repair) this a lot. The problem is on the control panel, which we regularly repair nationwide by mail for $39.95 postpaid in about a week or so.

This light failure often occurs when a bulb goes out and the filament shorts, or when the bulbs are removed or installed without first unplugging the oven from the power line. Either can cause such a failure on the controller.

This can often also affect the exhaust fan, cooling fan, turntable, and/or inside light operation, too.

Details of our service are at our Web site, along with a video showing how to remove a typical over the range control panel assembly in under 5 minutes.

Feel free to contact me directly with your brand, full model number and symptoms.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

William E. Miller

Posted on Oct 11, 2009

Eugene Rounds

  • 1169 Answers

SOURCE: Where can you purchase replacement

You use part lookup for the HU80709. Homelite site doesn't list the a version but parts should be the same. is excellent source for parts and is very reasonable on the parts.

Posted on Jan 13, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where can I buy replacement light bulbs for my AS 3DN ceiling fan it has three prong plug in for the LED bulbs

I think that the model number that you have is for a remote control not the fan.

Also conflicting question 3 Pins in title 6, Pins in question.

Sep 15, 2014 | Dryers

1 Answer

Set of three glomar track lighting purchased at home depot, one by one the lights burned out, when I replaced the bulbs, nothing happened, still do not come on, unit was taken to another location and...

well first if it worked some where else it is not the lighting, did you replace it with another fixture and diid it work, if not i would have an electrician look at your wiring to make sure it is ok

Sep 05, 2013 | Home

1 Answer

Need replacement halogen lights for SU3

These Halogen bulbs are inefficient, and run so hot that they often damage the reflector and bulb socket if they are left on too long. Fortunately there is an easy fix for this. At most stores that sell the exact replacement Halogen bulbs (Lowes, Home Depot and others) you will see a selection of LED bulbs on the same display rack that will fit into the same socket the Halogen bulbs use. It is IMPORTANT that you know the code number stamped on the base of your Halogen bulb AND its voltage because some Halogen bulbs are 12 volts and some are 110 volts. If you can't read the labeling on the bulb, look for the wiring diagram usually glued inside the range hood or look in your owner's manual. Once you know your Halogen bulb's code number, look at the packages that the LED replacements come in. There will be a list of Halogen bulb code numbers that the LEDs are meant to replace. The male sockets on these LED replacements will be shaped just like the sockets on your original Halogen bulbs so they will plug in easily. However, just like LEDs bulbs that replace the old incandescent bulbs in your table lamps or ceiling sockets, they have an electronic section included in there base to run the LEDs and it makes the LED bulb slightly longer than the much simpler Halogen bulb. For my stove hood it meant that the bulb would not quite fit into the reflector in the hood. I had to use a Dremel tool to remove a bit of the reflector to get a proper fit. The LED bulb runs SO much cooler and uses so much less electricity that now I can use the range hood as a night light in the kitchen. I never felt safe doing that with the two Halogen bulbs since they ran so hot that they were burning the fixture that held them in the stainless steel hood and were melting the wiring entering the socket base. This upgrade to your range hood is well worth the effort.

Mar 07, 2013 | Sirius Hoods SU3

1 Answer

Change light bulb


Jul 21, 2011 | KitchenAid Refrigerators

1 Answer

The clock dial on my Malibu Transformer has begun rotating in reverse. Therefore, it cannot turn the lights on or off because it is going against the direction the switch moves. Any ideas what caused...

There are no fixes for Power Packs once they go bad.
"Harry" wrote in with a work-around: He purchased inexpensive plug-in timer, set power pack to override, and then plugged power pack into wall timer.

Harry also said his power pack gave out after 4 years and he was negoiating with for the 5 year warranty. No word how that was resolved.

Some guys write into fixya saying they took the timer apart and messed around with it, but I've never heard anyone say they fixed it. Once the little motors and gears malfunction, the motor slows down, and when motors slow, they overheat and lose power. New Power Packs at Home Depot are digital.

After hours looking for power pack solutions at Intermatic,, ebay, Home Depot etc, the best I found were tips for next power pack that might save money:
The reason I add these tips now, before your power pack needs replacement is some fella wrote-in.
He bought 500 Watt power pack to replace 300 Watt > thinking bigger was better.
Power pack burned out. Here's why:
1) Match wattage of bulbs with wattage of power pack
-15 each X 20 watt bulbs = 300 watts, so install 300Watt power pack
2) Installing a 500W power pack on 300W of bulbs will burn out bulbs and power pack.
3) Replace bulbs as soon as they burn out or other bulbs will burn out and power pack will burn out.
4) When working on bulbs, unplug power pack or it may burn out.

Add a comment for more free help.
Also take advantage of fixya phone service.
For a price, fixya expert speaks with you over phone while you work on any do-it-yourself project.

Jan 11, 2011 | Malibu ML600TW - Low Voltage Power Pack -...

1 Answer

My microwave cooktop lights keep burning out. why? i've changed the 10 watt low volt bulbs 4 times in the last 6 mos. each time being careful not to touch the bulbs with my fingers. they will work for...

Are you keeping them on all the time?

Or is the the microwave subject to excessive vibration or door slamming while the lights are on?

Both these conditions are factors in premature bulb failure.

I would also avoid cheap Chinese bulbs from grocery stores and get the GE-specified bulbs either from here online or a local home center such as Lowe's or Home Depot. etc.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Dec 13, 2009 | KitchenAid KHMS155LSS 1000 Watts Microwave...

1 Answer

The light bulb burned out in my Magic Chef microwave oven. I took the burned out bulb to Home Depot to buy a replacement. The manager recommended a different bulb that he said would work. I came home and...

It's possible that it is ruined, but the Home Depot guy should NOT have suggested a different bulb anyway--I would say contact the manager of the Home Depot store that you got the bulb from, and tell them what happened. If you can remember the employee's name, they might be able to help you better. This is something they should be able to compensate you for, because it was THEIR recommendation that may have ruined your microwave, therefore THEY are at fault, and should hold responsibility.

Good luck!

Aug 21, 2009 | Microwave Ovens

2 Answers

This Hampton Bay light fan fixture eats Light Bulbs

Read the manual to find out which size bulbs (base size and wattage) you need.

If you did use the right type of bulb and it lasted only 2 weeks, take them back to the store where you boght them for a refund.


Jan 17, 2008 | Hampton Bay 24750 Huntington III Ceiling...

Not finding what you are looking for?
Hardware & Accessories Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hardware & Accessories Experts

Gene Haynes

Level 3 Expert

5390 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Brad Brown

Level 3 Expert

18121 Answers

Are you a Hardware and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides