Question about Refrigerators

Open Question

My model # if FLBO75LANA DOES this one have more problems than usual .I put a 3 in 1 in last week but freezer still not cold enough any thing else I can do

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 14 Answers

SOURCE: Freezer just not getting cold enough

The defrost heater element is bad, Do you know enough engineering to tackle the job ? You will need some hand tools and a spare Saturday afternoon .. Alternaively you could call a technician...

Posted on Sep 17, 2007

Ad
barkencoa

Barry Coates

  • 3463 Answers

SOURCE: red light on not cold enouth

The red light bis indicating that the temp is too high, if you can ,turn the thermostat to a colder setting, if this makes no difference, then you have a serious problem, you will have to call an engineer.
Plz rate this solution,
Thanks.

Posted on Dec 25, 2008

jumptrout51

steve

  • 3361 Answers

SOURCE: Frigidaire upright freezer Model #FFU17C3AW1 Not keeping cold

Yes that is the correct part number.
If a new cold control does not correct the problem. Replace the compressor start relay.

Posted on Mar 12, 2009

bobicehouse

Robert Moller

  • 1524 Answers

SOURCE: Control board reset?

Amana version of adaptive defrost : Press refrigerator light switch five times in six seconds to initiate defrost cycle. Pressing five more times within six seconds will cancel defrost and go straight into the run mode. Similar operation on both bottom mount and SxS refrigerators. After the defrost terminator/thermostat opens, six minutes of dwell time occurs before the compressor and condenser fan motor will operate. After defrost terminator/thermostat open, 10 minutes of dwell time occurs before the evaporator fan motor will operate.

Posted on May 04, 2009

mallik1971

  • 20 Answers

SOURCE: amana bottom freezer problem

It sounds like the condenser coil might be freezing up. This happened to me on my bottom freezer. The cooling part of your fridge is only in the back of the freezer compartment. The cold air from the freezer blows up through a vent in the back to the fridge and comes out at the top. If the coils do not defrost (which is what happened with mine) the air flow is blocked by the ice and can't get to the fridge compartment. Your freezer will still be cold but your fridge won't. If you pull the plug on it and time things right you can defrost the coils but this will only postpone the problem. Both will work for awhile again until the coils ice up again. You can also pull out the freezer drawere and try to defrost the coil with a blow dryer. You have to disconnect the icemaker and pull out the back panel behind the freezer to get to it though.

Posted on Jun 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Model LFC25776SB/00 one side of freezer not cold enough


There should be a fan inside circulating the air...

Jun 13, 2016 | Freezers

1 Answer

1999 kolpak walkin freezer not staying cold


Is the compressor cycling on and off? Is there any oil around fittings at components? Gas is the last thing you put in a refrigeration system. You need to find the leak before you put any more gas in the system. Hope this helps good luck.

Apr 08, 2014 | Kolpak Freezers

1 Answer

FREEZER NOT FREEZING PROPERLY


There could be a large list of things that cause the freezer to warm up from the temperature it was before. The most likely reason is you probably have a defrost problem. Defrost heater, defrost thermostat and the defrost control are all things that may have failed. If your model is not a frost free let me know. Look inside freezer for a layer of frost building on the rear wall. If your refrigerator is not defrosting it will be a short time before the fresh food compartment begins to warm. To extend the time your refrigerator and freezer can keep food safe defrost by placing a bucket of hot water inside the freezer and close the door. Please place food from freezer and fresh food compartment into another refrigerator or cold storage area. By keeping doors shut as much as possible the refrigerator and freezer will last up to a week this way before defrosting again, Sea Breeze

Sep 12, 2012 | Hotpoint Refrigerators

1 Answer

My refrigerator is not cold enough. I have the model GX5FDXVT00. The freezer on the bottom seems fine. It is set on level 5 as is the freezer since the hurricane 3 weeks ago. What can be...


Hi,

Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing thencheck out the last two tips.

If your refrigerator is running but warm, then...

Check out these tips that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay
Refrigerator or Freezer not Cooling or Getting Cold

heatman101

/.';';][

Sep 19, 2011 | Whirlpool Refrigerators

1 Answer

Our 3 months old refrigrator will get so cols that freezes food products.


There are actually 2 cold controls on refrigerator-freezers. The main control is within the refrigerator cavity, the other is located in the freezer cavity. The one in the freezer is usually only a cold air deflector. It takes the cold air that is produced and divides it proportionally between the freezer and refrigerator sides. Set the control in the refrigerator to about mid-range. Set the control in the freezer to mid range. That is your starting point. If the freezer is not cold enough, adjust the freezer control. If the refrigerator s not cold enough, adjust the fridge control. After any adjustments, you MUST wait at least 24 hours for the temp to equalize before making any more adjustments. It may take a week to get it set right. This is true for all refrigerator-freezer combinations. Be patient.

Oct 09, 2010 | KitchenAid Refrigerators

1 Answer

Frigidaire White 16.5 cu. ft. Top Freezer Refrigerator (FRT17HB3)- The freezer works, the refridge portion is warm, it started last week ans seemed intermitten, we turned the cooling higher and it was fine...


Hi,

All of your cooling coils on this model are located in the freezer. If you are cold enough in the freezer your problem is air flow to the fresh food section.

- There is fan behind the back wall of the freezer, be sure that is running.

- Look for frost build up on the back wall of the freezer, if present we have a defrost problem

- look for the duct or channels between the floor and freezer and top of the refrigerator they could be blocked with ice, if so we have a drain problem.

Let me know what you find and I will help you from there.

Apr 18, 2010 | Frigidaire 20.6 cu. ft. Top Freezer...

1 Answer

Frigidaire upright freezer Model #FFU17C3AW1 Not keeping cold


Yes that is the correct part number.
If a new cold control does not correct the problem. Replace the compressor start relay.

Mar 12, 2009 | Frigidaire 14.1 cu. ft. Upright Freezer...

1 Answer

GE Profile model TFH30PRTAWW


if there is ice on the back freezer wall you have a defrost problem,it is one of 3 things,defrost timer,defrost heater,or defrost sensor,if you have a meter you can check the defrost heater and sensor bt removing the back wall freezer panel,if the heater and sensor omn out good it is your defrost timer that bad-mike

Nov 21, 2008 | Refrigerators

2 Answers

Amana neither fridge nor freezer getting cold enough


the defrost system has failed. to get it working temporarily, take the back panel off inside the freezer. melt ice off with a hairdryer.
after that, fault can be in several areas - defrost heater, thermal fuse or the main pcb

Jun 30, 2008 | Refrigerators

Not finding what you are looking for?

Open Questions:

Refrigerators Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Brad Brown

Level 3 Expert

18110 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...