Question about Dryers

1 Answer

Hi I have a NordicTrack C990. Its switches on just fine, but as soon as I hit the start button, the breaker trips. Please advise. Thanks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 10 Answers

Motor is shorted out, need to replace the drive motor

Posted on Oct 25, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 121 Answers

SOURCE: my ac circuit breaker keep tripping

If your outside condenser has a locked rotor or short circuit, than the unit WILL trip the breaker - as it should. On the other hand if a breaker is tripped a few times it will have less of a capacity that the rating, (this is designed in it). You will need to determine if the unit is locked (and broken) or the breaker has become too sensitive.

Posted on Apr 22, 2008

Joe Hogan

  • 10865 Answers

SOURCE: Pond pump trips circuit breaker

The circuit breaker trips because there is an electrical short in the pump itself or in the wire feeding the pump. A cause of this could be a bare wire, or a crack in a wire. Remove the pump and put it in a five gallon pail of water and test it. If it still trips the breaker you will know the problem is in the pump or the cord to the pump.

Posted on May 02, 2009

Joe Yoder

  • 132 Answers

SOURCE: two 15 amp arc fault breakers installed on two

It's possible that the first breaker that you said does not trip - it could be that breaker is failing to trip on a bad circuit. That is, it could be you have a bad circuit but that first breaker is not detecting it and pretends everything is OK. If your new breaker trips on the first breaker's circuit, the curcuit it probably bad and the breaker in not working properly. The most common problem for failed circuits is a stray ground wire in a box somewhere in the curcuit resting against a hot or neutral wire. You'll have to take apart every connection on that curcuit to find it. Not fun.

Posted on Jun 27, 2009

fredericksim

  • 98 Answers

SOURCE: breaker relay tripping out

If the unloading valve trips , which i think is the safety valve that tells me the compressor is pumping up past its maximum allowed pressure. that black switch should be the overload switch. check the amps of the wires going to the motor while its running and then look at the name plate of the motor to see the maximum amount of amps that the motor is allowed to draw.

Posted on Jul 21, 2009

jyackle5

Jyackle5

  • 8197 Answers

SOURCE: copy of the NordicTrack C2100 owners manual.

You can get the manual here on link below.

http://www.iconservice.com/cgi-bin/ncommerce3/ExecMacro/nordictrack/manuals.d2w/report?man=NORDICTRACK&name=c2100&lan=&x=52&y=11

Posted on Dec 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The screen on my treadmill seems to work fine. I can enter and progam without any problem but as soon as I hit start and the motor turns on then the circuit breaker immediately trips. I have tried oth


Either a faulty Motor Controller Board or Motor.
Disconnect the power lead.
Disconnect the Motor from the Controller board.
Then reconnect the power lead.
Press 'start' and see if this trips the electrics.
If the electrics trip when the Motor is not connected to the Controller board, then the Controller board is faulty.
Disconnect the power lead then test the Motor.
Try running the Motor with a Drill Battery, connected to the Motor leads.
These tests should only be done if you are competent to carry out the tests.
Caution at all times Lethal Voltages are present

SAM Fitness Solutions

Oct 04, 2014 | Nordic Track NordicTrack A2350 Pro...

1 Answer

Lg microwave mv2297fspl


Magnetron is gone, just to be sure remove the microwave and use on a different socket. sometimes the breaker becomes faulty after 10 AMPS.

Tony

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

Nov 21, 2013 | Microwave Ovens

1 Answer

I have a Ntl 1094 Track C 1900 and the problem i have is ; the drive motor for the belt trips a breaker in the house breaker box. The belt will start and run for approx 5 seconds and the the breaker...


first check and see what the circuit is rated at. it you have too many thing on that circuit(light,tv,etc) this will trip your breaker because of the amp draw of the treadmill. nordictrack recommends a dedicated circuit of 20amp. you may nned to have a circuit put in with 12/2 wire

Oct 17, 2013 | NordicTrack Exercise & Fitness

1 Answer

Reset button ac unit


Hello jerrydj1021 - Often when the breaker trips, it is a mainly because there is too much current running on one circuit. Is the unit plug into a GFI outlet? It is not recommended to use GFI outlets or too many appliances plugged into that one circuit. Try plugging the unit into another direct outlet and see if the breaker trips again. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if the unit's status has changed successfully. Thank you.

Jun 26, 2013 | Frigidaire Heating & Cooling

1 Answer

I have two Haier HDN655E dehumidifier's. One works fine and the other wont come on. I have tried unplugging and plugged back in, hit the start button and nothing happens. Is there a reset switch or a...


Have you tested the outlet it's plugged into, to make sure it still has power? If it doesn't, check the circuit breaker panel in you home for a tripped circuit breaker. If there is one, unplug the dehumidifier, before resetting it. Then plug the dehumidifier back in. If the circuit breaker trips again, the problem is within the dehumidifier or the outlet is faulty (i.e. Loose wire, burned wire, broken outlet). If the outlet is not faulty, you should contact Haier America Parts and Repair 877-337-3639.

Hope this helped you to troubleshoot and solve the problem. Please let me know. Thanks.

Apr 28, 2011 | Dehumidifiers

1 Answer

Two 15 amp arc fault breakers installed on two adjacent circuits. One works fine - does not trip. The afi breaker beside it trips as soon as it is flipped on. We tried switching circuits, but both circuits...


It's possible that the first breaker that you said does not trip - it could be that breaker is failing to trip on a bad circuit. That is, it could be you have a bad circuit but that first breaker is not detecting it and pretends everything is OK. If your new breaker trips on the first breaker's circuit, the curcuit it probably bad and the breaker in not working properly. The most common problem for failed circuits is a stray ground wire in a box somewhere in the curcuit resting against a hot or neutral wire. You'll have to take apart every connection on that curcuit to find it. Not fun.

Jun 14, 2009 | Siemens 20Amp 1-pole arc-fault circuit...

2 Answers

Neff U1421 main oven trips the circuit breaker.


It might be that the breaker is overloaded and it's no longer supporting the load of all the appliances together.If you do not want to change your breaker you can still use your oven by switching off other appliances that is running while you are using the oven

Feb 04, 2009 | Neff U1421 Double circotherm Electric Oven

Not finding what you are looking for?
Dryers Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

jimorris77

Level 3 Expert

411 Answers

Brad Brown

Level 3 Expert

18110 Answers

Are you a Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...