Question about Toro Garden
If you didnt treat fuel before storage last season then likely the carburetor is fouled. Try adding a fuel treatment e.g. Seafoam, but likely ithe carb will need a thorough cleaning or replacement.
Posted on Oct 29, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: screeching snow blower
On one side of your machine you will find a cover that you can remove, the belt for the auger is in there. From what I can see there is no adjustment. Check to see how the belt looks.If it's chewed up it will need to be replaced.If you remove the belt try to turn the impeler to see if it turns freely, if it doesn't then check to see if there is something wedged. if nothing is wedged and the belt is off and it still don't turn by hand it could posibly be a bad bearing.if it does turn by hand. Also check the belt pulleies to see if they are ok, the only pulley that will sshould spin freely is the idler pulley, the one on the engine shaft should spin the moter so make sure you pull the spark plug wire off to check that one, and the auger pulley should spin with the auger.
Posted on Jan 15, 2009
I would check it at the start of every season and clean it. If you note that it seems to be running rich and might have fouled the plug, you can always pull it and check it again. Probably not a bad idea to check it before you put it away for the season. As for replacement, it depends on condition. I would think that you should get two or three season's use out of it before needing to replace it, at least.
Posted on Jan 25, 2009
SOURCE: carb adjustment
Screw both screws right in (don't force them) Then turn each screw out 1 & half turns each OUT. This will get engine running. To fine tune- turn low speed screw out, bit by bit, while idling, till engine revs change, then turn screw in till revs change, the correct setting will be somewhere between the 2 adjustments you just made. Do the same thing to the high speed screw, but with full revs. Good Luck. Stevo..
Posted on Feb 18, 2009
I have a toro 98 cc powerlite snowblower model 38182 it was running fine one day then bog down and died after that i cant get it to start it has a good fire on the plug plug isnt very wet it pops threw carb once in a while help
Posted on Dec 27, 2009
Tips for a great answer:
Dec 13, 2016 | Toro Garden
Feb 19, 2014 | Toro Snow Blowers. Power Max 724 OE 24 in....
Feb 17, 2014 | Toro 51599 Electric Blower 12 Amp
Dec 15, 2013 | Toro Power Max HD 926 OXE 26 inch 265cc...
Dec 15, 2013 | Toro Power Clear Snowblower 418ZR - 38272
Oct 10, 2013 | Toro Snow Blower Ccr 1000 Belt 715381...
Oct 21, 2011 | Toro Lawn Mower With Toro Power Tools
Feb 25, 2011 | Toro Snow Blower Ccr 1000 Belt 715381...
Nov 15, 2009 | Toro Blowers Rake and Vac - Electric...
38 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: