Question about Pool & Spa
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Hi Big Wags
I would remove both water hoses at the back of the washer and check the Hot & Cold inlet screens for a clog/restriction.
They look like this;
You can turn the individual valves on in service mode using the procedure on page 16 of the Service Manual.
To enter Service Mode; press and hold simultaneously the Enviro Plus and Spin Only keys for three seconds or until the control beeps and the display reads “00”.
Now go into board output test by pressing the Delicates key.
Now press the Normal button to open the Hot Water Valve you can press the Normal button again to turn off the valve or just press the Off button to end the process. Or just use the wash cycle to toggle the H/C water valves on. I like folks to become familiar with using Service Mode and the SM.
If the inlet screens are free of debris and you have good water pressure from your source valve then you may have to replace the valve assembly Here is a link to check for FAV6800AW PARTS Sears Parts Direct. Shout back If you have questions. Rich
Posted on Jun 27, 2009
Tips for a great answer:
Jan 30, 2016 | Pool & Spa
on Mar 27, 2015 | Pool & Spa
Dec 26, 2015 | Pool & Spa
Dec 18, 2014 | Jilong Inflatable Hot Tubs: Prompt Set...
Jan 06, 2012 | Endless Summer Pool & Spa
May 12, 2011 | Bosch Integra® 500 SHX46A0 Dishwasher
Mar 28, 2011 | Dream Maker Spas Dream Maker Ez Spa Hot...
Feb 07, 2010 | Qca Spas Dream Series Dream Master Hot Tub...
Sep 20, 2009 | Whirlpool Ultimate Care II LSQ9564J Top...
47 people viewed this question
Usually answered in minutes!