Question about Denon Avr789 7.1ch 90w Hdmi Independent Zone Home Theater A/v Receiver
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Very important you have run system set up menu it configures your receiver with inputs analog or digital,speaker size,input,room correction etc Different input modes can be selected for the different input sources.
The selected input modes for the separate input sources are stored in
q AUTO (auto mode)
In this mode, the types of signals being input to the digital and
analog input jacks for the selected input source are detected and
the program in the AVR-3300’s surround decoder is selected
automatically upon playback. This mode can be selected for all
input sources other than PHONO, MD/TAPE and TUNER.
The presence or absence of digital signals is detected, the signals
input to the digital input jacks are identified and decoding and
playback are performed automatically in DTS, Dolby Digital or PCM
(2 channel stereo) format. If no digital signal is being input, the
analog input jacks are selected.
w PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM signals are
e DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS signals are
r ANALOG (exclusive analog audio signal playback mode)
The signals input to the analog input jacks are decoded and played.
t EXT. IN (external decoder input jack selection mode)
The signals being input to the external decoder input jacks are
played without passing through the surround circuitry Your remote is searching for inputs because you did not properly run system set up!!! Here is a link to your manual [PDF] AVR-3300/1 3.3E*
Posted on Jul 22, 2009
UNPLUG IT!!!!!!!!!! Open the cover, and replace the fuse nearest the Transformer, when this is removed, or blows the receiver appears to go into "standby". Exactly what happened to my AVR-1400. 99 cents for a multiple pack at Radio Shack, and your receiver will work like new. Make sure you match the old one EXACTLY.
Posted on Nov 03, 2009
Disconnect all speaker wires on back and then turn on. If it happens again, it's most likely a power supply problem. If it doesn't happen again, it was probably crossed speaker wires.
Posted on Dec 28, 2009
Tips for a great answer:
Aug 27, 2011 | Denon AVR-788
Jun 20, 2011 | Denon AVR-789 Receiver
Mar 08, 2011 | Denon AVR991 Receiver
Jan 25, 2011 | Denon AVR-3805 Receiver
Feb 13, 2010 | Denon AVR-682 Receiver
Jun 06, 2009 | Denon AVR-987 Receiver
Jan 19, 2009 | Denon AVR-1403 Receiver
Nov 06, 2008 | Denon Audio Players & Recorders
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: