Question about DeLonghi Heating & Cooling
Bin it would be my choice . they are not efficient units they work just like a water heater
Posted on Nov 24, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The pilot light has to be lit before gas valve will operate. That's a safety feature so the valve won't open and fill the garage with gas and possibly cause an explosion or fire. If you have a standing pilot and can't get pilot to stay lit, it's usually the thermocouple and it will need to be replaced. Once the pilot is lit, the gas valve comes on and heats the combustion chamber up to approx. 100° to 125° a thermostat controlled fan switch will close and bring the blower on.
Posted on Sep 10, 2009
THE LIGHTED SWITCH SHOULD BE THE 12V ENERGY SOURCE TO ACTIVATE THE LP SIDE OF THE HEATER. THERE SHOULDN'T BE A LIGHTED SWITCH FOR THE 110 SIDE. THERE SHOULD BE A SWITCH OR A COMBINATION OF SWITCHES. ONE ON THE WALL LIKE A LIGHT SWITCH AND ONE MOUNTED BEHIND THE HEATER.
Posted on Jan 09, 2010
Unscrew the four screws holding the front faceplate on (two are on the bottom of the radiator). From the bottom end gently pry up the faceplate, it will stay attached at the top end near the temperature selector. Look inside and you will see a black bridge like piece of metal with a plastic and metal thing stuck to it's center with two wires leading into it. It's basically a connection that melts when high temperatures are reached, therefore it must be replaced (pictured). You can bypass this by prying the metal bridge out, removing the wires leads from the switch and connecting them using a wire nut. BE AWARE THAT THIS WILL OVERRIDE THE HIGH TEMPERATURE SHUT OFF MECHANISM, so don't use it for drying off your coat again.
Posted on Dec 29, 2010
Probably air locked. check to see if one of the hoses leading into heater is hot. Other cause could be heater solenoid control valve faulty. Very unlikely that the heater matrix is blocked. Easiest way to bleed heater is to remove hose's when car is cold and GENTLY flush through with garden hose and push hoses back on when full of water, so you know you have a heater full of fluid. Hope this helps
Posted on Jan 11, 2011
Tips for a great answer:
Mar 05, 2016 | DeLonghi TRD0715T Oil Filled Radiator...
Nov 04, 2015 | DeLonghi EW0507 Oil Filled Radiator Heater
Nov 02, 2015 | DeLonghi TRD0820 Oil Filled Electric...
Jan 06, 2011 | DeLonghi EW0507 Oil Filled Radiator Heater
Jan 05, 2011 | DeLonghi 6707E Oil Filled Radiator Heater
Dec 16, 2010 | Honeywell HZ708 Oil Filled Radiator Heater
Aug 15, 2017 | DeLonghi TRD0715T Oil Filled Radiator...
Jan 29, 2008 | DeLonghi TRD0715T Oil Filled Radiator...
Apr 26, 2007 | DeLonghi 9707 Oil Filled Radiator Heater
Jun 21, 2019 | DeLonghi Heating & Cooling
44 people viewed this question
Usually answered in minutes!