Question about Computers & Internet
When i go to menu settings system info then whole home pvr info it shows i have two receivers. I should only have one. Any ideas?
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: scratch & windows error
You must change the location of Photoshop's primary scratch disk to a different HD or other HD partition. You can do this using the Windows Explorer
Posted on Nov 05, 2008
I turned the TV off. I held in all of the (4) buttons on the front of the TV and turned the TV back on again....this seemed to free up the remote control access and I was able to work the TV normally. The four buttons were the channel and the volume controls.
Posted on Dec 27, 2008
SOURCE: conversion to home theatre
You will need a separate stereo amplifier for the 901's to accommodate the need for the Active EQ. There is no way to separate your receiver's front L&R channel preamplifiers from their amplifiers.
I run a Carver AV-406 (5-channel amp) for my 901's in Front, 2 Subwoofers and the Rear Surround channel, with the Active EQ between the receiver and the 901's amp channels. My receiver controls everything and just drives the Center and Surrounds. You would probably just get a nice 2-channel amplier for the 901's. If your receiver requires a powered Subwoofer so you would need another amplifier channel for that, too. Therefore, you might look around for a powerful 3- or 4-channel amplifier so you could drive the Sub, too.
Modest amps would work but at very loud volumes may go into clipping, which is bad for any speaker. I'm using only 100W for mine and it has plenty of steam for the 901's.
For connection I would run a pair of RCA cables from the Front L&R Audio Line OUT to the Active EQ's Line IN; then the EQ's Line OUT to a separate amp's Line IN. Attach the 901's to the new amp, run through the receiver's setup procedures for volume, etc and you're done.
Not what you might want to hear but 901's have special requirements. I've had mine for 25 years and have no regrets.
A separate subwoofer channel on the amp could be used. Just run a single RCA channel from Sub OUT to one available channel IN on the amp and attach the subwoofer to it. Two would work, also. That's what I do. You could use a 1-2 RCA splitter to feed two available channels on a 4-channel amp. The iterations are many. Have fun.
Posted on Apr 13, 2009
SOURCE: No image at menu 'digital'
you connected the converter to AV1 that is the ONLY place you will recieve any signal leave the tv in av1 and run setup on the converter ONLY you should be all set
Posted on Nov 20, 2009
Has your home wifi got SSID broadcasting disabled? Also check if you can connect to any other wifi points, if you cannot see any others, there may be a fault with the wifi board of your itouch
Posted on May 20, 2010
Tips for a great answer:
Aug 29, 2014 | Televison & Video
Jun 19, 2012 | Samsung PS42C430 42 Plasma TV
May 25, 2011 | HEWLETT-PACKARD G56-129WM Laptop PC
Jan 10, 2011 | Uniden BC72XLT Handheld Scanner
Dec 19, 2009 | Office Equipment & Supplies
Nov 12, 2008 | Motorola DCP-501 Receiver
Jul 19, 2007 | Toshiba P205-S6267 Notebook
20 people viewed this question
Usually answered in minutes!