Question about Manitowoc Kitchen Appliances - Others

1 Answer

Have a manitowoc ice machine, model qd0212a. Not working. E When I turn it on I hear a sound like a tripped breaker inside the unit. Any ideas?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Manitowoc Master
  • 66,248 Answers

SORRY NONE HERE CONTACT THE MFG

Posted on Dec 08, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 540 Answers

SOURCE: AC breaker trips after 10 minutes

Whats the amp breaker? Is this for the inside unit or the outside condenser? If the inside and gas heat you have a bad fan motor, If its an electric furnace , the same, but if its the outside unit, the fan could be going bad, locking up and the compressor still runs and pulls high ampsand tripps breaker or the compressor is just pulling too many amps due to plugged coils with dirt , grass or weeds blocking airflow.(koolbreezes74401@yahoo.com)

Posted on Jun 09, 2008

mike bare

  • 116 Answers

SOURCE: is there a reset for the a/c unit itself

check for fuses in disconnect at the out door unit or a reset button where the copper line set goes into the unit at make sure stat wires have not been damaged hope this helps

Posted on May 15, 2009

dieselpro

  • 183 Answers

SOURCE: breaker keeps tripping on outside air conditioner unit

The compressor is probably drawing to many amps. Breaker could be weak also.. Need to check the amp draw on the compressor.

If the breaker is hot when it blows, the compressor is probably going bad.

Posted on Jul 27, 2010

blanchettohd

robert blanchette

  • 143 Answers

SOURCE: Craftman Garaged Door Unit Stopped Working

This sounds like you will have to replace the logic board. Whether you repair or replace get a surge protector 900 joules or higher unless you want it to happen again. You can get replacement parts at searspartsdirect.com. Thanks BB

Posted on Sep 03, 2010

Joe Palazola

  • 124 Answers

SOURCE: Manitowoc Ice machine only makes 2/3 bin of Ice

The unit shuts off based on the magnetic reed switch in the plastic curtain on the front of the evaporator. If the ice is not falling as one single sheet with about 1/4"-3/8" of a bridge conecting all of the cubes then the ice is too thin. When the ice falls (in a single sheet of ice) if there is enough ice in the bin to hold that ice up and keep the curtain open the unit shuts down. A full bin may only be what appears to be 2/3 or 3/4 of a bin full because the ice sheet is propped up behind the curtain. If the ice sheet is too thin and does not fall as a single sheet more often than not a single cube or a piece of a cube can get caught between the curtain and the evaporator plate. This can shut the unit down for several hours until that piece melts and the curtain closes again.

Posted on Jan 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I fix my Taylor Soft Serve Ice Cream Machine? It often trips the breaker even though the machine is switched off.


Contact a service engineer. It has a dead short probably from the compressor or the paddle motor. It is a refrigeration unit, so you can't really work on it yourself.

Jun 30, 2018 | Washing Machines

1 Answer

The machine will make a couple of cycles of ice then stop. If i turn it off to clean then turn it on it will work for a few more times but then stop again. Any ideas?


Sounds like the bin switch. If it stays in the open position then the machine thinks it is full of ice and go to automatic shut down.

Sep 19, 2015 | Manitowoc Ice Machine QD-0212A Air Cooled...

1 Answer

Manitowoc q270 ice machine won't make ice .. It doednt sound like its turned on?


unplug and plug back in or turn breaker of and on to reboot the computer

Mar 07, 2014 | Kitchen Appliances - Others

1 Answer

My ice machine manitowoc q 132a starts up stops after few seconds while water pump start


There is a high pressure switch that stops the unit running if a fan fails or the condenser is clogged. Next time you start the ice machine, watch the bottom led on the pcb. It will tell you if there is a fault. Meantime, reset the hp switch and clean the condenser thoroughly.

Sep 06, 2012 | Refrigerators

1 Answer

I have a Manitowoc QD0212A 120v. It makes ice, but after the bin gets full, it appears that the compressor does not run to cool the ice box. Is there some type of relay or solenoid that could be bad?


Try cleaning the radiator for the ice box compressor it could be tripping it's thermal overload switch, if that doesn't work check to see if the termostat setting is in the range for the compressor to turn on when the ice starts melting.

Jun 29, 2011 | Manitowoc - QD-0212A/115-1

2 Answers

Ice machine starts on harvest mode and will not go on to production


you will have to find the main board unplug the connector for about a mintue plug back in. This should reset unit

Aug 05, 2009 | Manitowoc MAN-CVD2075 Condenser Unit...

1 Answer

A/c outside not working


The buzzing noise is your contactor drawing in from your thermostat. The fan part of your unit is on a different circuit from your outside A\C unit. Your thermostat is the conductor of the orchestra tying ths units together. It may well be that your A\C circuit breaker has tripped, if it has there is a reason for it's tripping. Resetting the breaker by turning it off then on may get your unit running, but a technician needs to ascertain why it tripped. Or it could be a bad contact switch inside the outside unit not letting enough electricity through the switch. More than likely the first issue. Good Luck

Jul 15, 2009 | Goodman CKL36AR36 Air Conditioner

1 Answer

Manitowoc ice machine that will not produce ice


This is odd that Manitowoc is listed on a page showing a Whirlpool refrigerator model and number. What is the model number listed on your Manitowoc? Not the base model number. The number listed inside the top section. Manitowoc has a really good service reputation. Their control boards have a series of self diagnostics. Get me your model and we will go from there. Sea Breeze

Jun 11, 2009 | Whirlpool ES5FHAXS Side by Side...

1 Answer

Manitowoc 210 ice maker


The thickness control (Im not sure if its like the bigger models) isa plastic piece that has 1 or 2 metal prongs that as the ise is frozen to the evap plate the water trickels closer to these probes. eventually commin gin to contact with the probe and allowing the board to "see" that the ise is ready for harvest. Perhaps this is set too close?

Or the machine may need a good cleaning. DO NOT USE LIMEAWAY on manitowoc. It has a nickle coating on the evap plate and the cleaner has to have inhibitors in it to keep the nickle plating from flaking off.

From your genmeral information these are a general idea of the 1st 2 things that can cause your problem.

Please ratem me as high as you can and let me know if you have tried anything and the results or if you have more information to add.

Mar 29, 2009 | Manitowoc Koolaire Undercounter Freezer...

Not finding what you are looking for?
Kitchen Appliances - Others Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Manitowoc Kitchen Appliances - Others Experts

Joe Palazola

Level 2 Expert

124 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

George Merkley
George Merkley

Level 2 Expert

194 Answers

Are you a Manitowoc Kitchen Appliances - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...