Question about Canon Office Equipment & Supplies

1 Answer

How do I resolve my problem related to canon printer error code 6000?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

The paper feed tray may be blocked. Something is covering the tray such as a large document.

If this happens, remove anything blocking or covering the tray. Turn the printer OFF, the ON and restart your print job.
*Hold large documents away from the tray while printing.

Posted on Feb 11, 2020

Ad

5 Suggested Answers

shaggyrat

Christophe Thompson

  • 1224 Answers

SOURCE: canon pixma mp460 code error 6000

Solutions for error 6000 Issue: ERROR LCD: Error code (5xxx through 9xxx) appears on the display

1. Press ON/OFF switch to reset the multifunction device 2. Removing paper jams MP450 / MP460 3. The MP460 may require repair
heres the problems currently with mp460 and at bottom is the link
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=238&modelid=13369

this is the solutions for the mp460

for the guest
clean out your ink absorber after unplug
reset printer you still have a little credit card sized paper in your printer that you need to remove it

Posted on May 21, 2008

Ad
jonniewalker

Starnley Johnwells

  • 1031 Answers

SOURCE: Canon MP830 error code 6A00

The problem apparently is related to the purge unit located at the far right side on where the printhead moves back and forth.
there appears to be three common problems that causes the error, which is related to a paper jam error. 1) If its a new printer or even an older one, there are two sponges that collect ink and two plastic wipers located in purge unit may be loose or missing. Check to see if its it there. If not, it may actually be stuck somewhere.
2) there may some paper stuck somewhere around the printhead and or the purge unit or
3) there is a build up of gooey ink on the purge unit.
, I turned off the printer & unplugged it, move the printhead to the left and used long Qtips with Windex to clean up the ink around the purge unit including a little white plastic spring-loaded lever. also dampen the sponges with Windex. If you do this be careful not to dislodge the sponge or wipers. If you do, you can alway stick the pieces back in. After cleaning it, and checking the sponges and wipers are seated correctly, plug the unit back in and hopefully it will work fine. hope this helps.dont forget to rate as fixyaa

thanks and Godbless

Posted on Oct 12, 2008

Anonymous

  • 1 Answer

SOURCE: Canon MP830 Service Error 6000

Canon PIXMA MP830 all-in-one Inkjet Printer
Error code 5C10 on computor screen and on the printer it says 6A00

Posted on Mar 25, 2009

Anonymous

  • 32 Answers

SOURCE: canon mx310 error code 6000

Error 6000 is a service call error, meaning that the printer needs to be taken into a canon authorized service facility for repair.

This is a line feed error, with the problem originating from the timing **** disk film or the printer's logic board.

Posted on May 28, 2009

pineworks

Clive

  • 4345 Answers

SOURCE: canon pixma ip1980 service error 6000

Hi there

You can try this may help you.
These are the steps:
1. Turn On iP1980
2. Push and Hold Resume button about 2 minutes
3. Release Resume button
4. Printer back to normal again

To get Permanent , follow the steps here :
Manual Resetter canon Pixma iP1980/1900 Download

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.

All The Best: Pineworks

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is service code 6000?


Hello Richard Miller

The error that you have, it means that your printer has a paper jam, this is the error appears in you computer, may be in the printer have the next error number. P3 followed E3

If you are writing this review, it is because they believe you have a paper jam, if they have seen and removed yourself.

Principally printers and Canon, in many cases the system detects a paper jam, but is not exactly a paper is causing the problem, in many cases can be any object that has entered and is obstructing the passage of the pages.

My first recommendation is to look carefully where they enter the pages on your printer, if necessary use some lighting for better viewing, you might find something there.
service-code-6000-xnnjabddbe1z3hwtjta3ekn0-4-0.jpg
If after all get nothing related, follow the steps below to solve your problem. http://www.en.rellenadodecartuchos.com/2015/04/delete-service-error-6000-or-p3-fallowed-e3-canon-pixma-mp240-printer.html

Even then, you can not solve the problem, I recommend the following way, which is to eliminate jam Canon inbox.

service-code-6000-xnnjabddbe1z3hwtjta3ekn0-4-2.jpg Remove error 6000 printer Canon PIXMA MG2410 en Rellenado

To be honest most of the time are other elements that influence paper jams, which can not be determined on the Canon printers.

Nov 20, 2015 | Canon PIXMA Office Equipment & Supplies

1 Answer

My printer canon mx328 error 6000


This information is directly from the Canon website, basically it suggests something is stuck inside. Other articles I found mentioned one person found a paperclip stopping the works.
---- quoting Canon ----
6000/P03 - Orange and green light blinking 3 times Description:

A service error has occurred.
Resolution:
  1. Turn off the printer.
  2. Disconnect the power cable.
  3. Open the printer cover.
  4. Check for any orange protective tape or white polystyrene and remove if necessary.
  5. Check that there are no foreign objects in the printer (such as a paper clip) and remove if necessary.
  6. Close the cover.
  7. Reconnect and turn on.
If the above solution has not resolved your error, please contact your nearest Canon authorised service facility using the link at the top of the page.
----- end quote ---
Best wishes -
http://www.canon.co.uk/support/consumer_products/product_ranges/printers/maxify/error_codes/#6000
PIXMA Printer Error Codes and Error Messages

Jul 05, 2015 | Canon Office Equipment & Supplies

1 Answer

Error 6000


If you're gettting the message "Canon printer error 6000," it may be related to a LCD error, so to fix it reset the printer by pressing the ON/OFF button.
It can also be related to a paper jam, so check for that and if you have had one and cleared it, make sure there is no paper left inside. Once this is done, again reset the printer

Jun 05, 2014 | Canon PIXMA MP600 all-In-One InkJet...

1 Answer

Error code 6000


Go To Below official Canon Printer Page For Your problem http://forums.usa.canon.com/t5/errors/FilterErrorHandlerPage Hope It's resolve all Your Printer Problem,
Or

Still having Problem Then follow Us ForCanon Printer Support

Mar 12, 2014 | Canon Pixma MX360 Printer

1 Answer

When i start my canon pixma mg5200 iu get an error code 6000


error code 6000, is related to printer cartridge problem. Did you use genuine cartridge?

Nov 13, 2013 | Office Equipment & Supplies

2 Answers

Canon mx350 code error 6000


  • 6000 is displayed:
If any object is placed in front of the machine, remove it.
Open the Paper Output Tray gently, then turn the power off and back on.
  • In other cases:

Turn off the machine, and unplug the power cord of the machine from the power supply.
Plug the machine back in and turn the machine back on.
If the problem is not resolved, contact the service center.

Jul 04, 2012 | Canon PIXMA MX350 Wireless All-in-One...

4 Answers

My Canon MP980 is showing Printer Error code 6000. Have turn off machine and turned on again - no change - still showing.


error [6000] or light blinking 3 times is mean there is an error occurred in the LF encoder signal.

May 20, 2010 | Canon PIXMA MP980 All-In-One InkJet...

3 Answers

Error code 6000


Error 6000 is a service call error, meaning that the printer needs to be taken into a canon authorized service facility for repair.

This is a line feed error, with the problem originating from the timing disk film or the printer's logic board.

May 16, 2009 | Canon PIXMA MP810 All-In-One InkJet...

3 Answers

Canon pixma mp460 code error 6000


Solutions for error 6000 Issue: ERROR LCD: Error code (5xxx through 9xxx) appears on the display

1. Press ON/OFF switch to reset the multifunction device 2. Removing paper jams MP450 / MP460 3. The MP460 may require repair
heres the problems currently with mp460 and at bottom is the link
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=238&modelid=13369

this is the solutions for the mp460

for the guest
clean out your ink absorber after unplug
reset printer you still have a little credit card sized paper in your printer that you need to remove it

May 16, 2008 | Canon PIXMA MP600 all-In-One InkJet...

Not finding what you are looking for?
Office Equipment & Supplies Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment & Supplies Experts

old marine
old marine

Level 3 Expert

2279 Answers

Ekse

Level 3 Expert

13434 Answers

Tareq Bin Mostaq...
Tareq Bin Mostaq...

Level 3 Expert

1449 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...