Question about Watches
Change the battery but can't see, to get the back plate back on the watch - Timex Indiglo WR30 M?
It is either a screw on case back or a "snap-on. I suspect that it is the latter since you don't mention that you used a tool to unscrew the case back. So getting the back on sometimes is very difficult. I have a special tool for that to apply even pressue and the necessary force and does not put pressure on the crystal. You have to be careful to not damage the crystal. If you don't get it done, then suggest you take it to a shop that has the right tool. If you have very strong thumbs you might get it done.
Posted on Dec 06, 2009
To open watch case, hold back of watch up with arrow pointer on the back plate pointing to the right. There is a pry point on the upper edge where you will see a small arrow pointing. Use a small flat end screw driver to pry the watch case open. Be sure to replace the back the same way with the arrow pointing away from the setting knob.
Take a 1-1/4 inch paddle bit and drill a hole in a 1-3/4 inch wide piece of wood about 1/8 inch deep. Then take another piece of wood about 2 inches long by 3/4 inch thick by 1 inch wide to lay across the back of the case plate. Place the crystal of the watch in the drilled hole. Used a vise or clamp with the watch between the two blocks of wood to press the back on. Be careful not to over press. Works great
Posted on Jun 05, 2010
I purchased this watch a few years ago, brand new, the battery died or was not working from the first day. I tried to open it, very difficult, got it opened to see the battery I needed. I could not close the back cover, struggled for a long time, eventually I ended up braking the crystal.
Today 2018-Oct-13 I purchased a battery of another Indigo that needed another battery.
There is a YouTube video, but I still could not get the cover on. So I used a C-Clamp the way he used a plyers. I had to take off the wrist band. I placed the watch face down with a large washer bigger than the crystal. It slip on the washer so I just flipped over my table mat on and it had a nice foam so it did not slip. I used the C-Clamp and still could not get it on. The o-ring seemed to have gotten out of shape and was squeezing out from the sides. Eventually after using a chisel to push the other side of the back that kept popping out when using the C-Clamp I got the cover closed, but the o-ring was partly out, I left it like that.
Quick TIP on How to open and close snap off watch back cover without special tools
Quick TIP on How to open and close snap off watch back cover without...
Posted on Oct 14, 2018
I tried everything and force wouldn't do it so I dropped by the watch repair place and the gentleman was kind enough to do it for me with the special tool he had and it worked. He didn't charge us which was a bonus.
Thanks for replying.
Posted on Dec 07, 2009
I found an alternative to the pill bottle cap. The back of my watch is just slightly smaller than a Kennedy half dollar . As I have serious balance problems, I wanted an approach that didn't involve me falling and breaking something.
I put the back into place with the Kennedy half on it, put padding on both sides of the watch. Gripped the whole thing with Vise-Grip® pliers and squeezed slowly until I heard the "pop." Huzzah!
Oh ... fun fact that most magicians know -- a 1901-1907 English Penny is the same diameter as the Kennedy half.
Posted on Aug 17, 2017
This is probably a bit more risky but I don't have a vice or the wherewithal to make recesses in bits of wood. Taking the back off is reasonably straightforward with a small screwdriver positioned alongside the arrow as others have indicated. After replacing the battery I snapped the back on by lining up the back in the required position and placing a UK 1p coin on the front and back of the watch and using a long handled pair of pincers to apply pressure. It worked for me - although I imagine too much pressure might have broken the glass. Good luck.
Posted on Jun 28, 2017
Direction of arrow on back is not important except perhaps to help you open the back. It opens easily enough if you drop it on the floor by mistake, incidentally
To close it just take two pieces of wood not wider than 1 inch for the back and any size for the front where the crystal resides. Pop the whole works in a vise and with little pressure, the assembly pops together.
Posted on Sep 17, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Dec 13, 2017 | Timex Watches
Mar 06, 2011 | Timex 27191 Wristwatch
Dec 19, 2010 | Timex 27191 Wristwatch
Oct 11, 2010 | Timex Indiglo Analog Watch
Jun 15, 2010 | Watches
Jul 30, 2009 | Timex 27191 Wristwatch
May 14, 2008 | Timex 27191 Wristwatch
17,290 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: