Question about Intel D865PERL Motherboard

1 Answer

Computer will not turn on. Possible power surge.

Computer will not turn on. Get no response when on/off button pressed. Had power outage from ice storm. Possible power surge. Checked power supply and all voltages low. Replaced power supply but now only get voltage if pin 14 on ATX plug connected to motherboard grounded. Voltages are good and fans run when pin 14 grounded but computer does nothing.
Bad motherboard??

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 46 Answers

If the power supply is good then your motherboard must have gone bad during a surge.

Posted on Dec 27, 2009

Testimonial: "Thanks for the quick response!!"

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung Rs2530B frig had power outage, now cubed ice is blinking and water and ice dispensers are not working.


CONTROL BOARD ON REAR PANEL IS MOST LIKELY THE PROBLEM .THIS IS COMMON WITH STORM DAMAGE..

Apr 26, 2017 | Samsung Washing Machines

1 Answer

There was a power cut mid cycle after which the start/pause button just flashes but wont start.


Is it possible that the outage was caused by a power surge that might have killed your programmer?

May 30, 2015 | Washing Machines

5 Answers

After an overnight power outage, my computer will not turn on. You can hear the fans run when you press in the power button but everything is dead as soon as it is released. If I hold down the power button...


Sounds like the Power supply got surged. Have the power supply tested or take one from an older computer and use that to test the main board and other components.

Oct 04, 2011 | HP Compaq Presario SR2050NX PC Desktop

1 Answer

Hi there,pls help I have problem with this. Power not come at all..it was working fine till the we had a power outage then while the computer was on then the outage went back on my monitor just didnt work...


Hello derick, Unfortunately power surges have been known to have some pretty nasty effects on your computer hardware. If you turn on your power (may have to toggle the power button behind your computer before pressing the button, worth trying in each position just in case) and your computer doesn't come on at all. This means that if none of your lights come on AND none of your fans come on, then your power supply may have blown out in the surge. If this is the case then you can't even begin to try and diagnose the rest of your PC to see if it's working. You need power to attempt diagnostics on your other components. Even if you replace the power supply, there is no guarantee that it was the only thing that was ruined by the surge. I hope this helps you out derick, and wish you better luck in the future :(

May 15, 2011 | Computers & Internet

1 Answer

I had a power outage & now my pc won't turn on.


It is possible that either the power supply or the motherboard is faulty.
Try swapping out the power supply (borrow one if you can) and if the PC power LED does not light up or the PC boot up, then you need a new PC.
I suggest you get a surge protection power board and connect your new computer to this surge protection power board. It will protect your computer from power surge problems.

Mar 31, 2011 | HP Computers & Internet

1 Answer

Canon PIXMA ip4500 will not turn on


Sounds like the power outage was a power surge and destroyed your printer, especially if your printer was not plugged into a power surge protector strip. Check with others in your apartment to see if they experienced the same. If so, your landlord may be responsible and can put in a claim. If your printer is still under warranty, contact Canon. Also, check to see if this item is covered by tenant insurance, if you have coverage. Hope this helps.

Jul 16, 2009 | Canon PIXMA MP830 All-In-One InkJet...

1 Answer

Presario 2200 won't turn on after local power outage


Hi Mellisa,
If there isn't any lights on the laptop when it is plugged into the mains supply there is a power problem.
Check the surge protector, has got a reset button?
Plug a lamp into this surge board, if the lamp lights up when the board is connected to the mains then the surge board is OK.
Next check the laptop's power adapter with a multimeter, the voltage reading should be as per the label on the adapter. If the voltage is less than the voltage on the label, then it is faulty and needs to be replaced.
Borrow another adapter to connect to your laptop to see if it powers up or take it to your friendly computer shop to test it.

Jan 08, 2009 | HP Compaq Presario 2200 Notebook

2 Answers

There was a power outage in the middle of the night. My computer was turned on during the outage (Presario 2200). Now it will not turn on ; it is plugged in (was in a surge protecting power strip during...


Please try to remove the battery and than try to switch on the laptop directly from mains power and if it works than its your battery problem or if it still not starts than there is possibility of some components of your laptop may fired due power fluctuation. So go and contact service station.

Jan 08, 2009 | HP Compaq Presario 2200 Notebook

2 Answers

My printer won't turn on after a power failure.


No, there is no reset button.
disconnect the pirnter from the computer and the power cord. press and hold the power button for 30sec. connect the power cord, and connect it back to the computer.

Dec 01, 2008 | HP Photosmart C3180 All-In-One InkJet...

1 Answer

Power outage then wont turn on


contact the power company to see what they will do for you they are responsible for power damage also the surge protection should have replacement warranty. may just be blow caps but take to a service center to have it looked at better yet have a service person come to your home to look into it.

May 22, 2008 | Emerson EWL20S5 20 in. EDTV-Ready LCD...

Not finding what you are looking for?
Intel D865PERL Motherboard Logo

Related Topics:

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Intel Computers & Internet Experts

Alun Cox

Level 3 Expert

2679 Answers

Ekse

Level 3 Expert

13434 Answers

Joe Negus
Joe Negus

Level 2 Expert

652 Answers

Are you an Intel Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...