Question about GE WSXH208A Front Load Washer

1 Answer

I have a front load ge adora and it is locked and wont open and it wont wash.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Reset your circuit breaker. it should power back on in less than 30 seconds. the circuit may be on the outlet or the breaker box. let me know how it worked out for you. hope this helps

Posted on Jan 16, 2010

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is an E70 error code in a GE Adora Front load washer?


E70 stands for a stuck key. Try unplug for 60 sec. Then try again. If not unplug and try to open and clean buttons of debris

Oct 27, 2013 | GE Energy Star 3.7 IEC Cu. Ft. Front Load...

1 Answer

My ge adora wont pump in water an the wash light does not come on


Remove the lower kick plate on the front of the unit. You will see a "drain boot" going from the tub to the pump. Remove the boot and check for any obstructions in the boot and also while the boot is off, reach into the tub opening to see if there is anything stuck in there.
Here is a picture of the boot.

11_17_2012_1_27_25_am.jpg
Be sure to have some towels handy as there will be some water in the boot.
If that is clear, you will then need to check the door lock assembly to be sure a wire did not come loose and then check it for continuity.
Post back your findings to me.


Regards,
Richard Roth
http://appliancecafe.com

Nov 15, 2012 | GE WSXH208A Front Load Washer

1 Answer

GE Adora front load washer turns until water is added then won't turn or spin


You should contact GE or qualified appliance repair center to be looked at professionally.

May 06, 2012 | GE Wh12x10309 Heater for Adora Front Load...

1 Answer

GE Adora front load wont lock the door or start at all. GE service is not existant.


the door switch has broken and needs replaced can be got online,adrian;;;;

Nov 11, 2009 | GE WSXH208A Front Load Washer

1 Answer

My washer will not start. I press the start/pause button and it just beeps twice and does not lock door or start wash. ge adora model wcvh6260


clean the drain filter located behind the front lower panell, its prob. holding excess h2o and wont let the water fill cycle activate. this happened to mine.

Aug 11, 2009 | GE Energy Star WCVH6260F Front Load Washer

1 Answer

Wont spin


I found the solution to clean the lint filter on the GE Adora. Go to http://www.instructables.com/id/GE-Adora-Lint-Filter-Cleanout/?download=pdf

I just did this and my washer is now running instead of the flashing start/pause and door unlocking. It was fairly easy. Make sure you have towels and a flat pan to catch the water if you don't have the machine on a riser. There may be water inside so a wet vac may be helpful too. Once my washer finishes what was in it, I have these funky towels to clean. You'll be very surprised what you find in the filter! Best of luck!

Sep 17, 2008 | GE WSXH208A Front Load Washer

1 Answer

Washer won't drain


http://www.instructables.com/id/GE-Adora-Lint-Filter-Cleanout/?download=pdf

Had the same problem, this fixed it!

Aug 05, 2008 | GE Energy Star WCVH6260F Front Load Washer

2 Answers

GE Adora front load washer overloaded now won't start


Washers - Resetting Electronic Controls on a Washer

If there is a pause in the washer cycle, the controls will lock up. The pause can occur because of a power failure or it was put in the test mode at the factory.

Also, if the washer was stopped before the cycle was complete or the consumer has pushed the stop/pause button to temporarily stop the cycle and the cycle is not reset. Over a period of 24 hours, the washer will pump out and spin, but will stay in the final spin.

To correct the situation, shut off the circuit breaker for 30 seconds or unplug the washer, then turn the timer knob around and back to any position other than final spin. Verify the water is turned on and restore power. This should resolve the issue.

Apr 23, 2008 | GE WSXH208A Front Load Washer

2 Answers

GE Energy Star WCVH6260F Front Load Washer: door locking problem


http://www.instructables.com/id/GE-Adora-Lint-Filter-Cleanout/?download=pdf

Had the same problem, this fixed it!

Mar 12, 2008 | GE Energy Star WCVH6260F Front Load Washer

Not finding what you are looking for?
GE WSXH208A Front Load Washer Logo

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Washing Machines Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

geapptech

Level 2 Expert

157 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a GE Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...