Question about York Furnace Draft Inducer Blower Fasco # A224

1 Answer

My York Stellar PLUS furnace (Model P2UDD12N07601C) will not stay on; The ventilator fan runs, the main blower runs, the igniter comes on for approximately ten (10) seconds and you can hear the gas valve click to open and then the igniter dies without the burner coming on. The gas technician just replaced the flame sensor and the igniter - the furnace operated OK for approximately one hour and then - back to square 1! Any suggestions? LF

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 52 Answers

Check gas pressure, inspect manifold & make sure there is not a blockage.Make sure gas is present and main gas shut off valve to furnace is on also check the knob on the 24 volt gas valve and see if it is in the on position , check the MV terminal on the gas valve to 24 volt common with a volt tester to see if you have 24 volts present, if you do have 24 volts at gas valve, replace valve. if you do not have 24 volts at gas valve check high limit control & roll out limits for a open circuit, Good luck.

Posted on Mar 04, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My York furnace sometimes doesn't completely ignite


A noisy inducer probably is headed for replacement.

The igniter can produce a healthy glow and still be defective. Mine had to be replaced with a new, improved one.

The thermocouple could be defective even though it seems to open the gas valve when it should.

The heat sensor in the bonnet could be defective. That controls main blower operation.

The heat exchanger could be cracked.

Jan 10, 2014 | Heating & Cooling

2 Answers

Gas furnace


Hi check out the pressure switch clean the air filter and check out the fan control see if this is clean

Feb 16, 2010 | York Furnace Draft Inducer Blower Fasco #...

1 Answer

My furnace is in a 1994 manufactured home. It is


i think it is your fan because when it is supposed to come on (when hood is hot enough) it won't,...and when the gas valve doesn't get the o.k. from the fan that it is working, the unit will shut it self off so it doesn't over heat. Gas boilers and furnaces have alot of safety things like this,....see if the fan has an oiling place on it. I've seen control panels cause this too,....replace whatever is cheapest first. good luck

Jan 31, 2010 | Tools & Hardware - Others

2 Answers

I HAVE A YORK STELLAR PLUS,MODEL PEUDD12N09501C 15 YEARS OLD. THE AIR INDUCTION MOTOR RUNS FOREVER. THE AIR INDUCTION MOTOR COMES ON , THE THE THERMOSTAT CALLS FOR GAS, THE IGNITOR LIGHTS THE GAS, FURNACE...


Check the filters first, then check for blockage in the return or supplies. An easy way to do this is by putting your hand in front of the vents to make sure accurate airflow is there. Your furnace has limit switches on it that detect heat, and if heat is getting trapped inside the unit to much, you will trip these switches and the blower will just run forever. Then you have to reset it or wait forever. But try those few things first. Hope this helps.

Nov 26, 2009 | York Yankees Bedding MLB Comforter

2 Answers

Condensation from small blower shorts out circuit board.


Put a plastic bag over the control board that will allow it to breath. you can add sealant to joint but you should clean the old off first. Then use some cork tape after sealant dries. You may also use pvc glue but it will never come out after that, but can be cut w/ saw if that becomes nessary.

Feb 01, 2009 | York Yankees Bedding MLB Comforter

1 Answer

Owners Manual


York Corporate Headquarters
631 South Richland Ave.
York, PA 17403
Phone: (717) 771-7890

Contacting York
Mail:
York International Corp.
P.O. Box 1592
York, PA 17405-1592
USA
Phone: (877) 874-7378


York Website


York was purchased by Johnson Controls in 2005
Johnson Website.

I cannot find an actual manual online. I hope this information helps you. Good Luck.

Dec 27, 2008 | York Yankees Bedding MLB Comforter

Not finding what you are looking for?
York  Furnace Draft Inducer Blower Fasco # A224 Logo

2,300 people viewed this question

Ask a Question

Usually answered in minutes!

Top York Tools & Hardware - Others Experts

Brad Brown

Level 3 Expert

18166 Answers

Bob Janelli

Level 1 Expert

26 Answers

djbilo

Level 2 Expert

84 Answers

Are you a York Tool and Hardware - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...