Question about Krups Small Appliances Espresso Machine
E8050 does not exist in the Krups info I have, EA8050 does though. You need to remove the tamping piston and unhook all the wires from off the PCB on the side. Then the boiler assembly is attached to the base with 3 screws. This will allow you to tip the boiler over enough to get access to the screw up through the bottom that holds that plastic flange thing on the bottom of the ejection rod while you at the same time have another screwdriver in the screw from the top into the only screw that you see inside the boiler. One of the screws will come undone, it doesn't matter which one. That will allow you to remove the shaft that the seal you are trying to replace fits around. It is called a Barista seal part number MS5015004
Posted on Dec 02, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Posted on Aug 21, 2008
SOURCE: hi, I need a 'joint
The part for your XP4000 is the brew head seal. A Google search turned them up here:
This page is their Krups model list:
It doesn't show the XP962 but it gives their phone number and says to call if you don't see what you need. So maybe they can help.
In general, when you want to search for something on the Internet, start with a good search engine (I use Google but there are others of course) and give a search string like "krupps kp40000 parts". Then you can check out the links it gives you until you find what you need.
Posted on Nov 22, 2008
After I changed piston sealing I get the same error 09. It was caused by missing connection to the thermoblock temperature sensor. In my case both connectors for thermocouple were cracked. They are located directly on the body of thermoblock, below two fuses, covered by rubber housing. After I solder them again on the position error 09 disappeared. Unfortunately it is necessary to open at least front panel of the machine. Moreover I tink that there is also important to save polarity of those two cables.
Posted on Aug 07, 2009
I had the same problem. The issue was that the machine needed a clean to dissolve Calcium build up from the water. I used a commercial cleaner available at my local supermarket but have since used white vinegar and get just as good results. I just put about a cup of white vinegard in the water haopper and run the machine without the group attatched. I run the steamer wand and then put another cup through with the group attatched . I then rinse a few times with fresh bottled or distilled water.
Posted on Nov 27, 2009
Tips for a great answer:
Sep 19, 2018 | Krups Coffee Makers & Espresso Machines
Jul 03, 2018 | Krups Coffee Makers & Espresso Machines
May 05, 2018 | Coffee Makers & Espresso Machines
Feb 24, 2017 | Krups Coffee Makers & Espresso Machines
Sep 08, 2015 | Krups Coffee Makers & Espresso Machines
Jan 25, 2015 | Krups Coffee Makers & Espresso Machines
Sep 01, 2012 | Krups Bravo Plus 872 Espresso Machine
Aug 31, 2010 | Krups Coffee Makers & Espresso Machines
May 16, 2010 | Krups XP7230 Compact Super Automatic...
Nov 22, 2008 | Krups Small Appliances Espresso Machine
Jun 26, 2014 | Krups Small Appliances Espresso Machine
71 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: