Question about Honeywell L4064B2236 Fan/Limit Control Heater

1 Answer

Blower motor will not come on. This is a new motor

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 120 Answers

If you have this fan switch as showen in your post you should be able to pull the on/off switch, white button, to turn it on and off to test. if it doesn't work you have no power or it is wired wrong

Posted on Feb 15, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My heater blower will not work on my 2002 Grand Am. I have checked the two fuses on each side panel and put a meter and even a new blower motor and no reading or power to the new motor.


Power for the blower starts at the fuse, goes thru the HVAC control panel, then the resistor block, then thru the high speed blower relay, then to the motor.
You should have voltage at the resistor and at the relay.

Jan 29, 2013 | 2002 Pontiac Grand Am

1 Answer

Heat, a/c blower motor does not blow, tried new resistor, and then new blower motor neither worked is there a fuse for blower?


Hi Mary,It seems you have replaced almost everything but the blower motor relay,here's a link to it and where it's at,if it doesn't fix,take back for a refund,hopefully it solves the problem.

Dec 18, 2012 | 2000 Lincoln Town Car

1 Answer

2003 buick rendezvous blower motor has 12 volts but isnt working even with new blower motor


The motor has to have voltage and a good ground.
Could be a faulty ground connection.

Sep 30, 2012 | 2003 Buick Rendezvous

1 Answer

Air condition blower motor does not work


put in a new blower motor-
  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 30, 2010 | 1999 Cadillac DeVille

    1 Answer

    Heater does not work


    Check heater fuse.
    If fuse good - could be a failure of the blower fan motor or blower control switch.
    If fuse bad - bad blower fan motor could have blown the fuse.
    DO: check fuse, then blower motor.
    Pricing: new blower motor: Duralast PM270 $43.99
    new heater control switch: Duralast SW229 $46.99 (without
    A/C).
    I'd expect your blower resistor to be good - when they fail, the blower only will work on HIGH setting.

    Oct 23, 2010 | 1993 Dodge Caravan

    1 Answer

    How to replace a blower motor in a 1996 ford thunderbird lx


    Removal
    1. Remove the glove compartment liner to gain access to the heater blower motor and blower motor wheel assembly mounting screws.
    1. Use a small screwdriver to remove clip retaining hydraulic damper strut.
    1. Remove four screws and remove the heater blower motor assembly and blower motor wheel assembly from the heater blower motor housing.
    Installation
    1. Using a new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). Install the four retaining screws.
    1. Tape the heater blower motor power lead to the air inlet duct to keep the wire away from the blower outlet during installation.
    1. Install the heater blower motor and blower motor wheel assembly in the vehicle.
    1. Install the glove compartment liner.

    Oct 07, 2010 | 1996 Ford Thunderbird LX

    1 Answer

    My heater and ac dont work but the blower motor turns on?


    sounds like something wrong with control head

    Apr 15, 2010 | 2001 Chevrolet Impala

    1 Answer

    My air conditioner only work on high. It is clicking in on the low setting but will only work in high. We checked the two fuse panels and they are all good, what else could be the problem.


    I own a 2006 HHR, had the same problem, I found water leaking onto the blower motor which caused the blower motor to fail.
    I replaced the blower motor & blower motor resister. No problems. (I also fixed the water leak)
    The blower motor isn't fun to replace, you have to use a box cutter knife to cut out the blower motor.
    When you buy the new blower motor it will come with proper instuctions on how to cut the old one out and install the new motor.

    Dec 15, 2009 | 2006 Chevrolet HHR

    2 Answers

    How to install a new blower motor in a Goodman gas


    remove the blower unit it slides out on some gas furnaces you may have a control bord in the way if you dont have a goodman motor you will need a belly band to clamp to new motor to provide the mounting arms also after loosening the shaft set screw spray w wd40 turn on side and shake motor should fall out if gas furn 115v motor hope this helps

    Jun 09, 2009 | Heating & Cooling

    Not finding what you are looking for?
    Honeywell L4064B2236 Fan/Limit Control Heater Logo

    82 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honeywell Heating & Cooling Experts

    Bill Long

    Level 3 Expert

    606 Answers

    Paul Carew

    Level 3 Expert

    3484 Answers

    Cindy Wells

    Level 3 Expert

    6069 Answers

    Are you a Honeywell Heating and Cooling Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...