Questions & Answers for: Makita black square

Ad

Question about 10" Dual Bevel Sliding Compound Miter Saw

1 Answer

not cutting square have adjusted the maximum with the fence but still significantly off square You might have an adjustment on the swing arm itself, for fine tuning the cut. If you still have the ...

Ad

Question about LS1214F 15 Amp 12 Inch Dual Bevel Sliding Compound Miter Saw With Fluorescent Light

1 Answer

...square it up at a 45% angle in the vertical position To adjust the bevel, (blade angle), loosen the black lever at the back of the unit, tilt the blade housing using the handle (this may require a ...

Ad

Question about 10" Dual Slide Compound Miter Saw with Light LS1013F

1 Answer

promblem with Makita 1013 ajusting blade to cut square Just found your problem, what you need to do it unplug tool and get a good square. Set the blade at 0deg. and then put the square on the left ...

Question about Circular Saw - 15 Amp, 7 1/4in. Dia., Model# 5007FAK

1 Answer

the table of my saw is not square w/ the blade.will not cut square.how can you adjust it back to a true 90 deg. How old is your saw?

Question about 10" Dual Slide Compound Miter Saw with Light LS1013F

1 Answer

recalibrating the angles look on top of fencesee 4 holes loosen 4 bolts (probably hex wrench) and  fence will loosen alsoframing square against loose fence and lowered blade (to calibrate ...

Question about 12" Compound Miter Saw LS1220

1 Answer

i dropped my makita ls 1220 and put it out of square want to know if there are adustments to fix it thank you Page 20 of the manual on the link below will tell you how to square the saw. ...

Question about 10" Dual Bevel Sliding Compound Miter Saw

1 Answer

My blade is not square to the table i,e if I make a 90deg cut, it is about 1/16 wider at the top of the board than it is at the bottom. I've lost my owners manual and was wowndereing holw I go about ...

Question about BFR750 18-Volt LXT Lithium-Ion Cordless Autofeed Screwdriver Kit

1 Answer

Do you know if this screwgun will accept square head autofeed screws. Also can I use other bradnd screws than makita? There is an accessory for a #2 square drive bit part number 784647-5 which you ...

Question about Circular Saw - 15 Amp, 7 1/4in. Dia., Model# 5007FAK

1 Answer

Saw cuts bevel at 0 degree setting. Needs to set to about 3 degrees for square cut. Multiple saws with this problem. Is something bent, or worn out? Check that the bed of the saw (the flat metal part ...

Question about 10" Miter Saw LS1030N

1 Answer

Square up fence to blade with the tool unplugged from power . u need a good square drop the blade down to cutting position place thesquare against the fence then slide it up to the teeth on the blade ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Makita Saw Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

ray gallant
ray gallant

Level 3 Expert

65332 Answers

fisherman816
fisherman816

Level 2 Expert

68 Answers

Are you a Makita Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...