Questions & Answers for: how to configure vlan

Ad

Question about EtherNav D7600 8-Port Ethernet Switch (D7600-VV-S)

2 Answers

...configure a VLAN using 3 ethernav d7600 switches and i connected to them 1 DECT3000, 1 DECR300 , and 2 DED2500 so basically 2 contactors and 2 converters can anyone help me on how to configure the ...

Ad

Question about Catalyst 2950 24x10/100 Mbps Networking Switch

2 Answers

...vlan about DHCP server using ip helper . in config mode. Just configure your 4 scopes on your DHCP server, and as long as your server is VLAN tagging and the trunk between the gateway and the switch ...

Ad

Question about ASA 5505 Firewall

1 Answer

...Configure the internal interface vlan ASA5505(config)# interface Vlan 1 ASA5505(config-if)# nameif inside ASA5505(config-if)# security-level 100 ASA5505(config-if)# ip address 192.168.1.1 ...

...VLAN? If yes how do I configure it? I want to tag a Base Station with my computer and my computer must support vlan for that process. Where do I get VLAN driver for my computer? cisco has set up vtp ...

...configure each NetGear port to use the same VLAN as the AP that is connected to it. You will then need either a switched virtual interface (SVI) for each VLAN on the NetGear or a trunk port (802.1q) ...

Question about Boxed Ls-s2318tp-ei-ac Quidway S2300 Switch

1 Answer

...configure user side interface of VLAN. [Quidway] VLAN 100 [Quidway-vlan100] quit [Quidway] interface Ethernet 0/0/1 [Quidway-Ethernet0/0/1] port default VLAN 100 [Quidway-Ethernet0/0/1] quit # enable ...

Question about Boxed Ls-s2318tp-ei-ac Quidway S2300 Switch

1 Answer

Why Is the VLAN Priority Configured on the S5700 Invalid? Fault Symptom The outbound interface of the switch joins a VLAN in untagged mode. When the remark 802.1p command is configured on the outbound

Question about PS2216 16Port 10100Mbps Smart Desktop Switch wPort VLAN and Trunking

1 Answer

How Do I Restore the Default VLAN Configuration of an Interface? We can take S5700-28P-PWR-LI-AC as example. The default VLAN configuration of an interface involves the default VLAN of the interface ...

...written on VLAN 1. If the port trunk allow-pass vlan 1 command is unavailable and eth-trunk is not configured for a port, the system infers that the port is not added to VLAN 1. Therefore, after the ...

What Are the Differences in AP-side Switch Interface Configuration and Intermediate Switch Configuration in Direct and Tunnel Forwarding Modes? Differences in configuration on switch interfaces ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Brad Brown

Level 3 Expert

18110 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...