Questions & Answers for: drive cables

Ad

Question about Computers & Internet

1 Answer

...cables, the Master connector is on the end of the cable where it should be. In situations where you are using a newer Ultra DMA drive and cable, you can use Cable Select or standard Master/Slave ...

Ad

Question about Dimension 3000® Pentium® 4 2.8GHz, 256MB, 80GB, 48x CD-RW PC Desktop

2 Answers

Trying to add another internal hard drive to Dell Dimension 3000 I am trying to add an additional internal hard drive to my Dell Dimension 3000. I ordered it from Dell so I would think its compatable.

Ad

Question about 200GB USB 2.0 Portable External 200 GB Hard Drive

1 Answer

...cables with the canon 4. Use a 2.0 hub The drive should have come with a "split" USB cable (USB "Y" cable). The drive requires a "data" and a "power" connection to your computer. Get one at Radio ...

Question about 200GB USB 2.0 Portable External 200 GB Hard Drive

1 Answer

...cables attached to the motherboard, on IDE 1 connector/cable will be your boot hard drive (C drive) and this will be jumpered to Master and you can attach the CD ROM drive to this cable and set the ...

Question about (SOHR-5239V) CD-RW Burner

1 Answer

I installed a LiteOn SOHR-5239v cd-rw drive. It doesn't show up on my computer and i looked on the website and couldn't find the driver. Ok thats probably your problem. J You will have to remove the ...

Question about (SOHR-5239V) CD-RW Burner

1 Answer

...drive and the other for the CD/DVD's Most cables have two slots but it depends on your computer. On the newer machines the hard drive cable looks somewhat different than the CD/DVD cable because the ...

Question about Media Center PC 873n (P9875A#ABA) PC Desktop

1 Answer

...drive. If you don't see any such "ribbon" cables, look for two wide-as-your-pinky-finger's-nail cables connected to the motherboard. One cable will connect to the "back" of your CD/DVD drive. The ...

Question about AV8 Motherboard

1 Answer

...machines. What i find most often the reason the bios will not recognize them is because the hard drive has gone bad. Troubleshooting 1. Unplug power cable from computer before doing anything

NEED JUMPER SETTINGS FOR MASTER HARD DRIVE NEED JUMPER SETTING.WONT GO INTO STANDBY MODE, REBOOTS ITSELF Set The Jumper Setting On Your Hard Disk DriveThe hard disk drive will be detected as 32 GB if ...

...drive ide cable. I assume you have two cables that are ide in the pc you could make the cdrom drive a slave via its toggle switches and the hard drive as master and run them on one cable if the cable ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Brad Brown

Level 3 Expert

18165 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...