Questions & Answers for: KitchenAid drive shaft

Ad

Question about KSM50PR Professional Series Stand Mixer

1 Answer

...drive pin (part #9705443) at the bottom of Vertical Center Shaft. I've been able to purchase a replacement pin, but need dis-assembly instructions. It is not immediately appearent how to remove the ...

Ad

Question about KP2671 Professional 6 Series Stand Mixer

1 Answer

...drive shaft, but cannot figure out how to remove the original. Please help. Thanks. hi there is a ring clamp on top of the main worm follower gear on the drive shaft. you might not see it due to the ...

Ad

Question about K5SS Heavy Duty Commercial Stand Mixer

3 Answers

...drive-shaft and would not move up, down, or sideways - like it was tack welded onto the drive-shaft. I tried all the initial recommended steps: oil-soak, hot towels, pouring boiling hot water, etc, - ...

Question about KT2651X Epicurean Stand Mixer

1 Answer

that the main shaft that drives the sun gear was slipping. My cure was to drill a 5/32 hole a 1/4 inch down through shaft and drive a 5/32 roll pin through it and it solved the problem. See my picture

Question about 5KSM150PS Mixer

1 Answer

...shaft? You need a small steel hammer and a pin punch. Do not try to drive out the Groove Pin any other way (i.e. don't force it out with a regular size hammer and a screwdriver), you will only ...

...mixer runs but the beater doesn't turn. Drive shaft? the mixer runs but the beater doesn't turn. Drive shaft? a gear or gears. their usually plastic and will damage before the drive ...

Question about K45SS Classic Stand Mixer

1 Answer

...shaft replace Yes If you have not gotten this taken care of yet. Turn your mixer upside down and remove the silver drip ring and then take out the drive pin with a punch, the pin holds the planetary ...

Question about KSM150PS Artisan Series Stand Mixer

1 Answer

drive the gear. There are driving pins in the system from fuse gear to paddle. 1) in the fuse gear 2) inside gearbox above planetary joining shaft to bevel gear 3) through planetary and shaft There is

Question about kitchen aid"" classic stand"

1 Answer

...drive shaft provided with the shredder, insert it through the drum, and raise the little bar in the rear of the slicer assembly. Insert the whole assembly into the front of the mixer so that the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top KitchenAid Food Mixer Experts

Appliance engineer

Level 2 Expert

198 Answers

CJ C
CJ C

Level 2 Expert

66 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a KitchenAid Food Mixer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...