Questions & Answers for: Ford Ranger drive shaft

Ad

Question about Ford Ranger

2 Answers

...drive shaft and physically checked uj s? as one may be showing no wear/movement as suggested however it may be siezed on the needle rollers cups and not moving at angles when 4wd selected have had ...

Ad

Drive shaft for 1988 Ford Ranger extended cab Will any other drive shaft fit this vehicle? I have a '88 Ranger XLT extra cab 4X4 w/auto tranny (2.9L V6) that had a 2-piece driveshaft on it. After ...

Ad

Question about 1983 Ranger

1 Answer

...drive shaft out use some thing long to slide in onto the head of the stuck drive shaft. use something soft like a old wooden broom handle then knock out using hammer. ford have used simple spring ...

Question about 1983 Ranger

2 Answers

...drive shaft from the upper u joint to the end of the trany where the slip yoke slides in, it broke off today and was free spinning around. it looks like it was attached to the drive shaft by rubber ...

Question about 2006 Ranger

1 Answer

...drive shaft. To place back in original position. Remove the u joint cap retainers. Spray some lube on the tops of the caps,for ease of removeing from the shaft ilets. Use a vice or a c clamp tool to ...

Question about 2006 Ranger

1 Answer

...drive shaft - I suspect you have one going out. With the vehicle in park or 1st gear and the wheels blocked, raise the vehicle so you can get underneath. Grab drive shaft and wiggle with sharp ...

Question about 2006 Ranger

1 Answer

...drive shaft as you lower the assembly back into the drive housing. When you feel resistance, wiggle and rotate the drive shaft and it should drop into the driver end. Do NOT try and force it, just be ...

Question about 1989 Ranger

1 Answer

drive shaft from turning when i go to take the bolts that hold the front piece of the drive shaft (this is a 2wd truck) to the disk that continues to the transmission. i hope this is clear enough i do

drive half shaft must be uncoupled from coolant pump (impeller drive) half shaft using special wrench kit available as loaner from AutoZone (free with $79 approx deposit). Best done after shroud &

...drive shaft (torque tube) checked for any loose end play... paying particular attention to the "U-joint" area. As bad as you are describing it it sounds like you are really close to dropping your ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...