Questions & Answers for: Oldsmobile Cutlass Ciera drive shaft

drive to the primary shaft and it spins free in the spigot bearing, if this bearing in Seized then it will keep spinning the shaft and hence you get your grinding noise, it's like putting it into gear

...drive shaft sensor or a bad crank shaft sensor. I don't remember which. They fixed it and it was ok until recently when it started doing the same thing again. The ''check engine light'' was on both ...

...to fix that issue??? If it is cable driven then remove the end at the trans and pull the cable out. Chk the drive on the trans tail shaft too.Anthing in the dash shop be taken to a shop. Good luck, ...

i turn the steering wheel but the tires dont move i can still drive forward and backwords broken rack and pinion or steering shaft

stalling and hard starting i could be driving down the road and the car would just die without warning like it just turned itself off.at times i can go to the store be in there 15 min. and come out ...

...same but dont drive with unpluged will burn up transmission also could be fuel pump . or crank shaft postion sensor . try the tcc first then vheck fuel presure , and then check for codes with ...

...drive shaft no, there is no "drive shaft" on a 94 oldsmobile. It is front wheel drive. you have a CV shaft from trans to left front wheel and a separate CV shaft from trans to right front wheel. The ...

...shop/tech test drive it with you and have him/her listen to it. Could be wheel bearing, drive shaft/u-joint or many other possibilities. that humming sound can be cause by a semi clog calyter ...

...shaft. If you do not have access to an air impact wrench, I highly recommend getting a 1/2"drive socket and using a large (at least 16") 1/2" breaker bar to remove this nut, as it is VERY tight. ...

...more serious problem. Since I commute to work, I would like to be sure the car isn't unsafe to drive. I'm assuming that the entire suspension and the shafts have been checked. If that's ...