Questions & Answers for: eec problems


Question about 1996 Cavalier

2 Answers

...twice] Your problem sounds like an intermittent short in the power feed to the coil pack from the EEC module what exactly did you do? did you replace the power feed from the eec and if you did, did ...


Question about 1996 Explorer

1 Answer tried the following: Ignition Control Module (ICM) REMOVAL & INSTALLATION NOTE: Only the EEC-IV ignition systems use an external ICM. EEC-V systems have incorperated the ICM into the Power ...


Question about 1994 Bronco

1 Answer

dies when shifted in to drive 94 bronco pcm problem. the EEC has some control on the transmission. PCM- power train control module. EEC IV Electric engine control. they both play together. Check ...

Question about 2008 Sebring Convertible

3 Answers

2011 freightliner Cascadia with DD15. Fault code EEC 61 comes on. What does this mewnijju BEFORE CONTECT ME DONT WORRY ABOUT IT 03452663007 What's the problem for freightliner cascadia EEC 61 Check ... taurus. Am I right to think it is the crankshaft position sensor/ camshaft position sensor, EEC, or the wiring between them based on the details below? If yes, where ar Ran out of gas, tried ...

...filled gas- plenty, batt. now dead, charged and jumped- wouldn't start (did I blow the EEC/PCM if I charged with key in the ON position- for the hazads?), towed home. Checked fuel ...

...signal to injector and no have spark the car crank and have good fuel presion Its possible that the EEC Relay is bad, the EEC diode or the signals are not processing in the EEC unit itself. Sometimes ...

...of box to each component and clean all grounds those trucks had alot of problems with grounds around battery area and to is gen times these can be very mind challenging.good

...engine module still won't stay running when starts what could be the problem? engine module ????? EEC - engine control module ? Or the ignition control module ? Learning how to test electronic ...

Question about 1987 Ranger

1 Answer

...on a 1989 f-250 The fuel pump is powered by a relay, and its secondary circuit is monitored by the EEC. The primary circuit also powers the EEC itself, so if that's out, the EEC would not come on,

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts


Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides