...1400 s express fault F01 and F02 whats the problem here? F01 Door not closed properly. F02 Tap not turne on, Inlet hose kinked or pinched, Filter blocked in water inlet hose, Water pressure to
...FAULT F01 ON MY WASHING MACHINE WF860 STARTS TO FILL UP THEN STOPS AND BEEPS THEN SHOWS F01 F01 indicates a short circuit motor triac, this is part of the motor speed control, either in the motor, or ...
Question about Ultima WF860 Front Load Washer
I have a Hotpoint ultima wt960 with f01 error can I fit the part Hi f01 means motor fault. remove motor and check the brushes. if ok then fault could either be motor or pcb which is faulty. regards
...Fault F01 What does the fault mean ? instuction sheet not clear. This is a printout of the fault codes System Fault indicator is on and all other front panel indicators are flashing. Internal UPS ...
Question about BR1500LCD UPS System
...machine will not start Fault Code F01 machine will not start Fault code F01 indicates a problem with the motor triac. Check all connections to and from the motor, the control module, and the motor ...
wf860 washer dryer - dryer has no heat and displays f01 Hi, Fault code F01 indicates a problem with the motor triac.Check all connections to and from the motor, the control module, and the motor plug
...F01 means defective triac or defective motor. On a Fagor washing machine it means: Not filled in time allowed (8 Minutes) - washing machine does not fill Check mains water pressure Check inlet hoses ...
error f01 flashing on machine F01 on a Washer Dryer means you have a motor fault. I suggest check the motor and associated wiring. You may just have a broken wire. Hope this helps.
...fault code f01 on drying The initial fault was a blown heating element, which was replaced, but that brought to light a welded relay on the control board. I have replaced that too, which allows the ...
...F01 is an Electronic circuit board fault I recommend you disconnect (unplug) the appliance from the mains supply for a minimum of 2 minutes. Reconnect supply and wait 30 seconds and try starting the ...
Usually answered in minutes!
9,025 Questions
3,801 Questions
3,127 Questions
2,929 Questions
2,616 Questions